Constraints on the number of maximal independent sets in graphs

A maximal independent set of a graph G is an independent set that is not contained properly in any other independent set of G. Let i(G) denote the number of maximal independent sets of G. Here, we prove two conjectures, suggested by P. Erdös, that the maximum number of maximal independent sets among all graphs of order n in a family Φ is o(3^n/3) if Φ is either a family of connected graphs such that the largest value of maximum degrees among all graphs of order n in Φ is o(n) or a family of graphs such that the approaches infinity as n → ∞.     

Measurements of climatic parameters and ground-level ozone at Terra Nova Bay in Antarctica

Summary The results of local meteorology, solar radiation and ground-level ozone measurements taken in Antarctica during the second Italian expedition (December 86–February 87) at Terra Nova Bay are presented. During the summer months the site of the Italian base camp is characterized by a thin strip of deglaciated ground, along which the temperature measurements close to the ground and up to 6 m high show a strongly superdiabatic profile. This irregular trend of the temperature in the surface layer is mainly due to the notable incoming amounts of radiation and to the extreme transparency of the atmosphere. This is also shown by the low values of the ratio between total radiation and diffuse radiation. The ground is thus subjected to intense heating, especially in the warmer hours of the day, while the surface layer of the atmosphere will be characterized by strong upward heat fluxes and by turbulent convective movements. Vertical-temperature-profile measurements show an almost forced persistence in the superdiabatic trend, which tends towards isothermic values only as a resultof rapid variations in the direction and intensity of the wind, connected to the downward flux of cold air masses, shown also by the simultaneous increases in ground-level ozone concentrations which would support the presence of dry-deposition processes in the lower layer. However, the complex local orography and the horizontal discontinuity (sea, deglaciated coast, snow-covered surfaces) do not permit a correct application of profile flux relations, normally used in studies on groundlevel dry-deposition. Paper presented at the IV Congresso del Gruppo Nazionale per la Fisica dell'Atmosfera e dell'Oceano, June 22–24, 1987, Rome.     

氙灯泵浦的NYAB晶体调Q激光运转特性及实验研究

首次报道了氙灯泵浦的自激活自倍频NYAB复合功能晶体的BDN染料片调Q运转,获得了自倍频绿光单脉冲.测量了不同L和T_o情况下的绿光脉冲的能量、脉宽和峰值功率.文中还从理论上推导了自激活自倍频晶体调Q激光器的方程组.数值求解方程组,所得的理论数据与实验结果很好地相符.最后,讨论了进一步提高绿光脉冲峰值功率的途径.     

一种新的$1/f$过程小波模型

给出了一种新的二进小波1/f过程模型,从理论上证明了一类谱指数为H的近似1/f过程可通过一簇平稳随机过程产生.由于所提方法利用了1/f过程小波系数的相关性,因而有效地减少了合成1/f过程的谱误差.数值实验结果表明,新模型很好地改进了已有模型.     

A trace class operator inequality

In this note, we generalize the inequality about the trace of positive semidefinite matrix trk(AB)?k(trA)k(trB) to Hilbert space, and obtain a relevant inequality about positive trace class operator.     

Synthesis,characterization, and micellization of an epoxy‐based amphiphilic diblock copolymer of ϵ‐caprolactone and glycidyl methacrylate by enzymatic ring‐opening polymerization and atom transfer radical polymerization

Amphiphilic diblock copolymer polycaprolactone‐block‐poly(glycidyl methacrylate) (PCL‐b‐PGMA) was synthesized via enzymatic ring‐opening polymerization (eROP) and atom transfer radical polymerization (ATRP). Methanol first initiated eROP of ?‐caprolactone (?‐CL) in the presence of biocatalyst Novozyme‐435 under anhydrous conditions. The resulting monohydroxyl‐terminated polycaprolactone (PCL–OH) was subsequently converted to a bromine‐ended macroinitiator (PCL–Br) for ATRP by esterification with α‐bromopropionyl bromide. PCL‐b‐PGMA diblock copolymers were synthesized in a subsequent ATRP of glycidyl methacrylate (GMA). A kinetic analysis of ATRP indicated a living/controlled radical process. The macromolecular structures were characterized for PCL–OH, PCL–Br, and the block copolymers by means of nuclear magnetic resonance, gel permeation chromatography, and infrared spectroscopy. Differential scanning calorimetry and wide‐angle X‐ray diffraction analyses indicated that the copolymer composition (?‐CL/GMA) had a great influence on the thermal properties. The well‐defined, amphiphilic diblock copolymer PCL‐b‐PGMA self‐assembled into nanoscale micelles in aqueous solutions, as investigated by dynamic light scattering and transmission electron microscopy. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 5037–5049, 2007     

一类Lagrangian对偶问题的零对偶间隙性质及其最优路径的收敛性

针对一般的非线性规划问题,利用某些Lagrange型函数给出了一类Lagrangian对偶问题的一般模型,并证明它与原问题之间存在零对偶间隙．针对具体的一类增广La- grangian对偶问题以及几类由非线性卷积函数构成的Lagrangian对偶问题,详细讨论了零对偶间隙的存在性．进一步,讨论了在最优路径存在的前提下,最优路径的收敛性质．     

Synthesis and optoelectronic properties of silole‐containing polyfluorenes with binary structures

2,5‐Bis(2‐bromofluorene‐7‐yl)silole was prepared by a modified one‐pot synthesis with a reverse addition procedure, from which novel silole‐containing polyfluorenes with binary random and alternating structures (silole contents between 4.5 and 25% and high M_w up to 509 kDa were successfully synthesized. The well‐defined repeating unit of the alternating copolymer comprises a terfluorene and a silole ring. Optoelectronic properties including UV absorption, electrochemistry, photoluminescence (PL), and electroluminescence (EL) of the copolymers were examined. The different excitation energy transfers from fluorene to silole of the copolymers in solution and in the solid state were compared. The films of the copolymers showed silole‐dominant green emissions with high absolute PL quantum yields up to 83%. EL devices of the copolymers with a configuration of ITO/PEDOT/copolymer/Ba/Al displayed exclusive silole emissions peaked at around 543 nm and the highest EL efficiency was achieved with the alternating copolymer. Using the alternating copolymer and poly(9,9‐dioctylfluorene) as the blend‐type emissive layer, a maximum external quantum efficiency of 1.99% (four times to that of the neat film) was realized, which was a high efficiency so far reported for silole‐containing polymers. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 756–767, 2007     

Characteristics of nanosized ruthenium metal by chemical reduction method

Nano-sized Ru metals have been prepared by the chemical reduction of ruthenium chloride and ruthenium hydroxide. Sodium borohydride was used as a reducing agent. The samples have been characterized by elemental analysis, X-ray diffraction, differential scanning calorimetry, and transmission electron microscopy. The preparation method greatly affects the composition and surface area of the material. All the samples show nanosized particles. However, samples prepared by reduction of ruthenium hydroxide had a lower surface area and larger particle size than those prepared by reduction of ruthenium chloride. Residual amount of boron was present in the samples. The samples demonstrate amorphous structure.