Electron impact and chemical ionization mass spectra of some unsaturated anomeric C-glycosides

Electron impact mass spectra at 70 eV electron energy and chemical ionization mass spectra with ammonia as the reagent gas are reported for certain unsaturated C-glycosides. Comparisons are made between the mass spectra of anomeric pairs of these glycosides.     

Structural evolution of hexa-peri-hexabenzocoronene adlayers in heteroepitaxy on n-pentacontane template monolayers

The growth and structure of self-assembled adlayers of hexakis(n-dodecyl)-peri-hexabenzocoronene (HBC-C12) adsorbed on highly ordered pyrolitic graphite (HOPG) decorated by an n-pentacontane (n-C50H102) monolayer have been investigated by scanning tunneling microscopy (STM). Whereas on HOPG the HBC-C12 molecules readily self-assemble into a unique stable 2D structure, on the [n-C50H102 monolayer/graphite] system we observe morphological phase transitions with formation of time dependent alpha, beta, and gamma phases (alpha-->beta-->gamma). The initial alpha-phase is similar to that obtained on bare graphite, while intermediate beta- and final gamma-structures present molecular dimers and rows, respectively. The observed two-dimensional polymorphism is due to weak interaction between HBC-C12 molecules and n-C50H102-modified graphite substrate. Our results constitute an important step toward the control of the growth and structure of highly ordered monolayers of functional conjugated molecules by modifying the graphite surface with an n-alkane monolayer of appropriate chain length.     

Application of gas chromatography-tandem mass spectrometry to the analysis of pesticides in fruits and vegetables

A new analytical method was devised using gas chromatography with tandem mass spectrometry (GC-MS-MS) for the routine analysis of 31 multi-class pesticide residues and approximately 8000 fresh fruit and vegetable samples (green bean, cucumber, pepper, tomato, eggplant, watermelon, melon, and marrow). Extraction of the pesticides with dichloromethane was carried out. The optimal ionization mode, either electron impact or chemical ionization, was selected for each pesticide in the same run. Carbofrit was used in the liner and combined with the selectivity of the detector this avoided additional clean-up. Thus, not only was money and time saved, the uncertainty of the method was decreased in its application to routine analysis. The average recoveries in cucumber obtained for each pesticide ranged between 71 and 119% at two different fortification levels (n=10 each) that ranged between 7 and 300 ng g(-1) (depending on the pesticide). The relative standard deviation was lower than 19% for all compounds tested. The calculated limits of detection and quantification were typically <1 ng g(-1) which were much lower than the maximum residue levels established by European legislations.     

Experimental and theoretical studies of the quenching of Li(3p,4p) by N2

Quenching mechanisms of the Li3p and Li4p states in collision with the nitrogen molecule are studied by laser-induced fluorescence spectroscopy and by a quantum chemical calculation. The Li3p state is observed to be efficiently quenched to the Li3s state detected as intense 3s-->2p emission. The Li4p state is efficiently quenched to the Li4s and Li3d states detected as 4s-2p and 3d-2p emissions, respectively. The potential-energy surfaces for the Li(2s-4p)N2 states show a large number of conical intersections and avoided crossings resulting from the couplings between the ionic [Li+(N2)-] and covalent configurations. There are a large number of stable excited states, and we give here the spectroscopic constants for the lowest two stable isomers correlating to Li2p+N2.     

Molecular orbital calculations of iron(II) complexes of diimine ligands

Summary Molecular orbital calculations using-, the INDO method have been carried out fm the [FeL(CN)₄]² and [FeLH(CN)₄] complexes, as well as for the tree ligands, with L 2 × pyridine, 1,10-phenanthroline.2,2-bipyridyl. 2,2-rimidine, 2, 3,3-bipyridazine and 4.4-bipyrimidine. Calculations of residual charge at carbon atoms in the ligand rings. correlating with relative nucleophilicity of the compounds, corresponds with observed differences of rate of reaction of the complex [FeI;]² With nucleophiles.     

The application of "click chemistry" for the decoration of 2(1H)-pyrazinone scaffold: generation of templates

The "click chemistry" approach has been explored on the 2-(1H)-pyrazinone scaffold for the generation of pharmacologically interesting heterocyclic moieties. Huisgen 1,3-dipolar cycloaddition has been evaluated as the key step for the construction of the 1,2,3-triazole ring at the C-3 position of 2-(1H)-pyrazinones. Two different pathways have been successfully evaluated: (1) via C-C or C-O linkage of the acetylenic part to the C-3 position of the 2-(1H)-pyrazinone scaffold or (2) via azide introduction in the C-3 position. The subsequent application of "click chemistry" resulted in the formation of hitherto unknown skeletons. Microwave irradiation has successfully been applied in different steps of the sequence.     

Countercurrent chromatographic isolation of lolitrem B from endophyte-infected ryegrass (Lolium perenne L.) seed

This paper describes a new method of purification of the Lolitrem B, a tremorgenic mycotoxin produced in planta by the endophytic fungus Neotyphodium lolii. The method is based on the large-scale isolation of the toxin by countercurrent chromatography (CCC). The lolitrem B content in endophyted ryegrass seed, 11 microg/g or 11 ppm, is extracted by stirring finely ground seeds with ethanol for 3 h at room temperature. The concentrated crude extract contains about 0.6 mg/g or 600 ppm of lolitrem B. It is then submitted to CCC purification with a biphasic four-solvent liquid system. A 160-fold enrichment was obtained in one step producing a raffinate containing 10% or 100 mg/g of the toxin. Further purifications were then performed by thin layer and low pressure liquid chromatography. Twenty-eight micrograms of lolitrem B with a 96% purity grade were obtained from 8 kg of seeds (yield 32%).     

Experimental analysis of floc size distributions in a 1-L jar under different hydrodynamics and physicochemical conditions

This study focuses on the relation among hydrodynamics, physicochemical conditions, and floc size. During ortho-kinetic flocculation, the floc size is controlled by a balance between hydrodynamic stress and aggregate strength. Special attention was paid to the influence of a hydrodynamic sequencing on both the aggregate strength and the flocculation processes. Experimental research was conducted in a 1-L jar for two different pH values. The hydrodynamic sequencing was made up of successive slow and rapid mixing periods, and different slow mixing intensities were studied. First, the large floc size was shown to decrease with increasing velocity gradient (G), with an expected trend (d proportional variant epsilon(-1/4)). Then, the aggregate strength was shown to depend on two main factors: the flocculation history and the physicochemical conditions, which control the cohesion forces between primary particles. Finally, flocculation processes are discussed in terms of aggregation and breakup phenomena, with relation to local hydrodynamics and physicochemical conditions.     

Flow injection analysis: Rayleigh light scattering technique for total protein determination

A novel flow injection analysis (FIA) method with Rayleigh light scattering (RLS) detection was developed for the determination of total protein concentrations. This method is based on the weak intensity of RLS of bromothymol blue (BB) (3',3"-dibromothymolsulfonephthalein) which can be enhanced by the addition of protein in weakly acidic solution. A common spectrofluorimeter was used as a detector. It was proved that the application of this method to quantify the total proteins in real samples by using bovine serum albumin was possible. The RLS signal was detected at lambda(ex)= lambda(em)=572 nm. The linear range was 7.0-70.0 microg mL(-1), the detection limit was 3.75 microg mL(-1), the reproducibility was 5.5% (n=7), and the sample throughput was 26 h(-1).     

Neutral and ionic aluminum,gallium, and indium compounds carrying two or three terminal ethynyl groups

The syntheses of the ionic compounds [Li(+).2 dioxane (2,6-iPr(2)C(6)H(3)N(SiMe(3))Al(C triplebond CSiMe(3))(3))(-)].0.75 dioxane (1), [(Li(+))(2).(dioxane)(7)](0.5) [2,6-iPr(2)C(6)H(3)N(SiMe(3))Ga(C triplebond CSiMe(3))(3)(-)].1.5 dioxane (2), and [(Li(+))(2).(dioxane)(7)](0.5) [2,6-iPr(2)C(6)H(3)N(SiMe(3))In(C triplebond CSiMe(3))(3)(-)].1.5 dioxane (3) by the reaction of the corresponding organo metal chloride with LiC triplebond CSiMe(3) are reported. The neutral ethynyl compounds Br-Al(C triplebond CtBu)(2).2 THF (4), Cl-Ga(C triplebond CtBu)(2).THF (5), Cl-In(C triplebond CtBu)(2).2 THF (6), Al(C triplebond CtBu)(3).C[N(Me)CMe](2) (7), Ga(C triplebond CtBu)(3).dioxane (8), and In(C triplebond CtBu)(3).NEt(3) (9) have been obtained in good yields from the reaction of AlBr(3), GaCl(3), and InCl(3) with LiC triplebond CtBu in the presence of a Lewis base. Compound 7 is the first heterocyclic carbene substituted ethynyl derivative. Aluminum and gallium compounds with three terminal ethynyl groups Al(C triplebond CPh)(3).NMe(3) (10) and Ga(C triplebond CPh)(3).NMe(3) (11) have been prepared by the reaction of AlH(3).NMe(3) or GaH(3).NMe(3) with three equivalents of phenylethyne. All the above-mentioned compounds have been structurally studied. In compound 1 the lithium ion is coordinated to the three terminal ethynyl groups, whereas in compounds 2 and 3 the lithium is coordinated to the solvent (dioxane). Compound 8 crystallizes as a coordination polymer with dioxane molecules bridging the individual gallium units.