基于联合变换相关器的Dempster-Shafer理论计算

提出了用联合变换相关器(JTC)来实现证据理论概率分配函数正交和的光学计算,在理论上对于如何用联合变像相关器实现证据理论分配函数正交和作了详细的讨论,并作了相应的仿真测试,结果显示该方法是可行的。与John Caulfield提出的用声光器件矢量外积实现的正交和计算相比,在该结构中由于采用二进制编码的数值计算,因此其计算精度得到了提高,同时对联合变换相关器输入端二进制编码的数值空间位置的适当调整可以直接得到所需要的证据理论正交和矢量,在处理步骤上得到了简化。     

敏化光波长对(Fe,Ni):LiNbO3晶体全息记录性能的影响

分别采用514 nm绿光、488 nm蓝光和390 nm紫外光作为敏化光,633 nm红光作为记录光,详细研究了敏化光波长对氧化(Fe,Ni):LiNbO3晶体全息记录性能的影响.结果表明:随着敏化光波长的逐渐减小,氧化(Fe,Ni):LiNbO3晶体的非挥发全息记录性能逐渐优化,390 nm紫外光是这三种敏化光中最优的敏化光.考虑敏化光的吸收,为了在双中心全息记录中获得最优的性能,应当选择合适波长的敏化光:一方面短波长敏化光能有效地敏化深中心;另一方面短波长敏化光的吸收太强(如对光折变效应无用的基质吸收),不能沿厚度方向有效地敏化晶体,所以实际上需折衷考虑,并从理论上给予了解释.     

Direct Potentiometric Study of Cationic and Nonionic Surfactants in Disinfectants and Personal Care Products by New Surfactant Sensor Based on 1,3-Dihexadecyl−1H-benzo[d]imidazol−3-ium

A novel, simple, low-cost, and user-friendly potentiometric surfactant sensor based on the new 1,3-dihexadecyl−1H-benzo[d]imidazol−3-ium-tetraphenylborate (DHBI–TPB) ion-pair for the detection of cationic surfactants in personal care products and disinfectants is presented here. The new cationic surfactant DHBI-Br was successfully synthesized and characterized by nuclear magnetic resonance (NMR), Fourier transform infrared (FTIR) spectrometry, liquid chromatography–mass spectrometry (LC–MS) and elemental analysis and was further employed for DHBI–TPB ion-pair preparation. The sensor gave excellent response characteristics for CTAB, CPC and Hyamine with a Nernstian slope (57.1 to 59.1 mV/decade) whereas the lowest limit of detection (LOD) value was measured for CTAB (0.3 × 10⁻⁶ M). The sensor exhibited a fast dynamic response to dodecyl sulfate (DDS) and TPB. High sensor performances stayed intact regardless of the employment of inorganic and organic cations and in a broad pH range (2−11). Titration of cationic and etoxylated (EO)-nonionic surfactant (NSs) (in Ba²⁺) mixtures with TPB revealed the first inflexion point for a cationic surfactant and the second for an EO-nonionic surfactant. The increased concentration of EO-nonionic surfactants and the number of EO groups had a negative influence on titration curves and signal change. The sensor was successfully applied for the quantification of technical-grade cationic surfactants and in 12 personal care products and disinfectants. The results showed good agreement with the measurements obtained by a commercial surfactant sensor and by a two-phase titration. A good recovery for the standard addition method (98–102%) was observed.     

Anomalous curving of Arrhenius plots for data obtained from electro-thermal vaporization at atmospheric pressure

Arrhenius plots are often used in electrothermal atomization atomic absorption spectroscopy (ETA-AAS) to obtain activation energies (E_a) of vaporization processes. However, these plots are often nonlinear, and the exact cause of the curvature is not clear. This phenomenon has been attributed to multiple generation functions, diffusion of atoms through the graphite walls, changes in the size of the generating particles, changes in the surface coverage and interferences of the removal function with the supply function. This paper examines several other possibilities using computer simulations on a micro-computer. These possibilities include the effects of diffusion, errors in the assumed order of the reaction and small systematic errors. These can create curving very similar to that observed in typical ETA-AAS and should be considered before assigning the curvature to other chemical or physical properties of the system.     

双中心全息记录的矢量分析与记录方向优化

对描述双掺杂晶体非挥发性全息记录动力学过程的Kukhtarev方程进行了矢量分析,分析中考虑了体光生伏特效应和外加电场的作用。在小信号近似的基础上给出了双中心全息记录中记录与固定阶段空间电荷场的矢量解析解。在综合考虑空间电荷场的各向异性以及晶体有效电光系数的各向异性后,给出了双中心全息记录的优化记录方向。结果表明,对(Fe,Mn)∶LiNbO3晶体633nm寻常光记录,优化记录方向主要由有效电光系数决定,光栅波矢与光轴夹角为22°,方位角为30°;对(Fe,Mn)∶LiNbO3晶体633nm非寻常光记录,优化记录方向主要由固定空间电荷场决定,光栅波矢与光轴夹角为44°,方位角为90°。     

Two Equivalent Reduction of Copper(I) Complexes; Evidence of an Anionic Copper Species

Reactive copper solutions have been prepared by a cold temperature, two equivalent lithium naphthalenide reduction of copper(I) complexes. One equivalent of organic halides react with one equivalent of the anionic copper to yield organocopper reagents.     

Comparison of phantom materials for use in quality assurance of microbeam radiation therapy

Microbeam radiation therapy (MRT) is a promising radiotherapy modality that uses arrays of spatially fractionated micrometre‐sized beams of synchrotron radiation to irradiate tumours. Routine dosimetry quality assurance (QA) prior to treatment is necessary to identify any changes in beam condition from the treatment plan, and is undertaken using solid homogeneous phantoms. Solid phantoms are designed for, and routinely used in, megavoltage X‐ray beam radiation therapy. These solid phantoms are not necessarily designed to be water‐equivalent at low X‐ray energies, and therefore may not be suitable for MRT QA. This work quantitatively determines the most appropriate solid phantom to use in dosimetric MRT QA. Simulated dose profiles of various phantom materials were compared with those calculated in water under the same conditions. The phantoms under consideration were RMI457 Solid Water (Gammex‐RMI, Middleton, WI, USA), Plastic Water (CIRS, Norfolk, VA, USA), Plastic Water DT (CIRS, Norfolk, VA, USA), PAGAT (CIRS, Norfolk, VA, USA), RW3 Solid Phantom (PTW Freiburg, Freiburg, Germany), PMMA, Virtual Water (Med‐Cal, Verona, WI, USA) and Perspex. RMI457 Solid Water and Virtual Water were found to be the best approximations for water in MRT dosimetry (within ±3% deviation in peak and 6% in valley). RW3 and Plastic Water DT approximate the relative dose distribution in water (within ±3% deviation in the peak and 5% in the valley). PAGAT, PMMA, Perspex and Plastic Water are not recommended to be used as phantoms for MRT QA, due to dosimetric discrepancies greater than 5%.     

Dependence of electrical performance on structural organization in polymer field effect transistors

Organic semiconductors (OSCs) are strong contenders for use in printed, flexible electronics. Although organic electronic materials have been studied for many years, the physics of charge transport is still under investigation. This is in part due to variability resulting from the large variety of molecules that can be synthesized and inconsistency in electrical characterization due to device and processing conditions. Molecular ordering in OSCs is known to alter the charge transport characteristics and attention to long range and short range ordering provides clues as to the nature of transport pathways. Here, we study ordered regioregular poly(3‐hexylthiophene‐2,5‐diyl) films carefully prepared to obtain a set of three samples with incrementally increasing order on identical transistor architectures. Ordering was characterized using a variety of short and long range techniques to probe the coherence and number of crystallites formed during processing, and the correlation between these different measures of order are quantified. We observe three changes in transistor behavior that show a shift from non‐ideal to more textbook‐like characteristics with increasing order: reduction of the contact resistance, shift to field‐independent mobility, and a shift from a diode‐like (S‐shaped) to linear response at low lateral fields. © 2017 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2017 , 55, 1063–1074