Modification of poly-HEMA with nonreactive POSS derivatives by in situ photopolymerization

Photo-induced polymerization of 2-hydroxyethyl methacrylate (HEMA) in the presence of various amounts of nonreactive polyhedral oligomeric silsesquioxanes (POSS) functionalized with glycidyl, fluoroalkyl or hydroxyl groups was investigated. HEMA/POSS systems were characterized before, during and after the photocuring, with the special emphasis on the photopolymerization kinetics (measured by isothermal differential scanning calorimetry). It was found that the introduction of tested POSS derivatives into HEMA strongly affects the photopolymerization kinetics (enhancement of the gel effect, increase in the polymerization rate and conversion), mainly due to the increase in the viscosity of the initial formulation which leads to a reduction in the termination rate coefficient. However, interactions HEMA–POSS cause also a slight increase in the propagation rate coefficient. The behavior of the polymerization rate coefficients during the reaction suggests that POSS cages may mitigate the inhibitory effect of viscosity on the diffusion of macroradicals by exerting a slip effect. The materials produced are microcomposites due to the partial phase separation occurring during the curing process. Small amounts of added POSS modifiers cause plasticization of the material; at higher loads, POSS domains behave like nanofiller aggregates that increase the glass temperature. The nonreactive POSS have very little effect on thermal decomposition of the poly-HEMA matrix, which can result in a degree from the phase separation; the latter is also the main cause of the deterioration of the mechanical properties of composites compared to a pure polymer matrix.

     

Analysis of Assumptions in BIG Bell Test Experiments

Recently, a group of experiments tested local realism with random choices prepared by humans. These various tests were subject to additional assumptions, which lead to loopholes in the interpretations of almost all of the experiments. Among these assumptions are fair sampling, no signaling, and faithful reproduction of a Bell-type quantum model. The data from 9 of 13 experiments were examined and occurring anomalies were analyzed in view of the above assumptions. It is concluded that further tests of local realism need better setup calibration to avoid apparent signaling or necessity of the complicated underlying quantum model.     

Bacillus cereus Toxin Repertoire: Diversity of (Iso)cereulide(s)

The emetic Bacillus cereus toxin cereulide (1) poses a significant safety risk in the food industry, causing emesis and nausea after consumption of contaminated foods. Analogously to cereulide, the structures of various isocereulides, namely, isocereulides A–G, have been recently reported and could also be identified in B. cereus-contaminated food samples. The HPLC fractionation of B. cereus extracts allows us to isolate additional isocereulides. By applying MSⁿ sequencing, post-hydrolytic dipeptide, amino acid and α-hydroxy acid analyses using UPLC-ESI-TOF-MS to purify the analytes, seven new isocereulides H–N (2–8) could be elucidated in their chemical structures. The structure elucidation was supported by one-dimensional and two-dimensional NMR spectra of the isocereulides H (2), K (5), L and N (6 + 8) and M (7). The toxicity of 2–8 was investigated in a HEp-2 cell assay to determine their respective 50% effective concentration (EC₅₀). Thus, 2–8 exhibited EC₅₀ values ranging from a 0.4- to 1.4-fold value compared to cereulide (1). Missing structure-activity correlations indicate the necessity to determine the toxic potential of all naturally present isocereulides as single compounds to be able to perform a thorough toxicity evaluation of B. cereus-contaminated foods in the future.     

A Review of Modifications of Quinoline Antimalarials: Mefloquine and (hydroxy)Chloroquine

Late-stage modification of drug molecules is a fast method to introduce diversity into the already biologically active scaffold. A notable number of analogs of mefloquine, chloroquine, and hydroxychloroquine have been synthesized, starting from the readily available active pharmaceutical ingredient (API). In the current review, all the modifications sites and reactivity types are summarized and provide insight into the chemistry of these molecules. The approaches include the introduction of simple groups and functionalities. Coupling to other drugs, polymers, or carriers afforded hybrid compounds or conjugates with either easily hydrolyzable or more chemically inert bonds. The utility of some of the compounds was tested in antiprotozoal, antibacterial, and antiproliferative assays, as well as in enantiodifferentiation experiments.     

Bioactive mesoglobules of poly(di(ethylene glycol) monomethyl ether methacrylate)–peptide conjugate

This study describes the synthesis and aggregation behavior of thermosensitive poly(di(ethylene glycol) monomethyl ether methacrylate) (P(DEGMA‐ME)) conjugated with the fluorescently labeled pentapeptide glycine‐arginine‐lysine‐phenylalanine‐glycine‐dansyl (GRKFG‐Dns). The GRKFG‐Dns was obtained using Fmoc solid‐phase peptide synthesis and was modified with 2‐bromopropionic acid to initiate an atom transfer radical polymerization of di(ethylene glycol) monomethyl ether methacrylate (DEGMA‐ME). The polymerization led to a well‐defined P(DEGMA‐ME)–GRKFG‐Dns conjugate with a number average molar mass of 108,000 g/mol. The pentapeptide acted as a hydrophilic moiety that increased the phase transition temperature compared to the P(DEGMA‐ME) homopolymer of similar molar mass. The bioconjugate macromolecules aggregated in dilute aqueous solution into spherical particles (mesoglobules). The sizes of aggregates were easily controlled by changing the concentration and heating rate of the P(DEGMA‐ME)‐GRKFG‐Dns solution. The weight average molar masses and sizes of mesoglobules were determined based on light scattering measurements. Enzymatic hydrolysis of the bioconjugate in dilute solution was performed at temperatures below and above the cloud point temperature of the bioconjugate. The peptides were fully accessible to enzymatic digestion even when the macromolecules were aggregated to mesoglobules, indicating that the peptide segments in mesoglobules formed the external shell of the nanoparticles and could be easily released by enzymes. © 2012 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2012     

Influence of the Medium Composition and the Culture Conditions on Surfactin Biosynthesis by a Native Bacillus subtilis natto BS19 Strain

An effective microbial synthesis of surfactin depends on the composition of the culture medium, the culture conditions and the genetic potential of the producer strain. The aim of this study was to evaluate the suitability of various medium components for the surfactin producing strain and to determine the impact of the culture conditions on the biosynthesis of surfactin isoforms by the newly isolated native strain Bacillus subtilis natto BS19. The efficiency of surfactin biosynthesis was determined by measuring the surface tension of the medium before and after submerged culture (SmF) and by qualitative and quantitative analysis of the obtained compound by high performance liquid chromatography. The highest efficiency of surfactin biosynthesis was achieved using starch as the carbon source and yeast extract as the nitrogen source at pH 7.0 and 37 °C. Potato peelings were selected as an effective waste substrate. It was shown that the increase in the percentage of peel extract in the culture medium enhanced the biosynthesis of surfactin (mg/L) (2–30.9%; 4–46.0% and 6–58.2%), while reducing surface tension of the medium by about 50%. The obtained results constitute a promising basis for further research on biosynthesis of surfactin using potato peelings as a cheap alternative to synthetic medium components.     

Chitin and chitin-cellulose composite hydrogels prepared by ionic liquid-based process as the novel electrolytes for electrochemical capacitors

This paper reports on the preparation and electrochemical performance of chitin- and chitin-cellulose-based hydrogel electrolytes. The materials were prepared by a casting solution technique using ionic liquid-based solvents. The method of chitin dissolution in ionic liquid with the assistance of dimethyl sulfoxide co-solvent was investigated. The obtained membranes were soaked with 1-M lithium sulfate aqueous solution. The prepared materials were preliminarily characterized in terms of structural and physicochemical properties. Further, the most promising biopolymer membranes were assembled with activated carbon cloth electrodes in symmetric electrochemical capacitor cells. The electrochemical performances of these devices were studied in a 2-electrode system by commonly known electrochemical techniques, such as cyclic voltammetry, galvanostatic charge/discharge, and electrochemical impedance spectroscopy. The devices operated at a maximum voltage of 0.8 V. All the investigated materials have shown high efficiency in terms of specific capacitance, power density, and cyclability. The studied capacitors exhibited specific capacitance values in the range of 92–98 F g⁻¹, with excellent capacitance retention (ca. 97–98%) after 20,000 galvanostatic charge and discharge cycles. Taking into account the above information and the eco-friendly nature of the biopolymer, it appears that the prepared chitin- and chitin-cellulose-based hydrogel electrolytes can be promising components for green electrochemical capacitors.

     

Effective Stimulation of the Biotechnological Potential of the Medicinal White Rot Fungus: Phellinus pini by Menadione-Mediated Oxidative Stress

The effect of menadione (MQ; 2-methyl-1,4-naphtoquinone), a superoxide-generating agent, on the natural biodegradation system in the medicinal white rot fungus Phellinus pini was determined. While measuring the activities of extracellular manganese-dependent peroxidase (MnP) and intracellular chitinase, it was found that the application of MQ (0.75 mM) distinctly stimulated the activities of these enzymes in comparison to the control values (without MQ). Using the capillary electrophoresis (CE) method, an increase in the extracellular oxalic acid (OXA) concentration was detected during the first days after the addition of MQ. It was observed that the rate of intracellular proteolysis at pH 3.5 evidently decreased under oxidative stress conditions. Contrary to these results, the activities of serine proteases at pH 9.5 measured against fluorogenic peptide substrates distinctly increased in stressed cultures. The MQ treatment also caused an evident increase in the catalase (CAT) activity, as well as the levels of superoxide anion radicals (SORs), formaldehyde (FA), and phenolic compounds (PHC) in the experimental cultures. The results obtained confirm that prooxidants may find application as an effective way to stimulate biotechnological production of MnP and chitinase by white rot fungi.     

Hematite/Polystyrene Raspberry-Like Microcomposites as Stable Support for Silver Nanoparticle Immobilization

Among the methods utilized for the preparation of raspberry-like microcomposites, due to its simplicity and universality, the electrostatically-driven deposition of nanoparticles at the surface of microparticles is especially attractive. This process, leading to the formation of a single nanoparticle monolayer, is widely reported. On the other hand, no data concerning the electrostatically-driven formation of nanoparticle bilayers at the surface of microparticles are reported. To fill this gap, the detailed investigation of the formation of silver/hematite nanoparticle bilayers at the surface of polystyrene microparticles is reported. First, the hematite/polystyrene raspberry-like microcomposites are obtained by immobilization of hematite nanoparticles under an electrostatically-driven process. The stability of hematite/polystyrene microcomposites at elevated temperatures up to 323 K is monitored using microelectrophoresis. No significant changes in the hematite nanoparticle layer coverage are observed after prolonged time of incubation. This proves the irreversible character of nanoparticle immobilization. Next, the hematite/polystyrene microcomposites are utilized as the interfaces for immobilization of negatively charged silver nanoparticles. This process is quantitatively described using electrokinetic measurements. The changes in the hydrodynamic diameter of microcomposites are also determined. Finally, the validity of the electrokinetic model used in this work for predicting the zeta potential of the silver/hematite/polystyrene microcomposites is confirmed.     

Impact of Lignocellulose Pretreatment By-Products on S. cerevisiae Strain Ethanol Red Metabolism during Aerobic and An-aerobic Growth

Understanding the specific response of yeast cells to environmental stress factors is the starting point for selecting the conditions of adaptive culture in order to obtain a yeast line with increased resistance to a given stress factor. The aim of the study was to evaluate the specific cellular response of Saccharomyces cerevisiae strain Ethanol Red to stress caused by toxic by-products generated during the pretreatment of lignocellulose, such as levulinic acid, 5-hydroxymethylfurfural, furfural, ferulic acid, syringaldehyde and vanillin. The presence of 5-hydroxymethylfurfural at the highest analyzed concentration (5704.8 ± 249.3 mg/L) under aerobic conditions induced the overproduction of ergosterol and trehalose. On the other hand, under anaerobic conditions (during the alcoholic fermentation), a decrease in the biosynthesis of these environmental stress indicators was observed. The tested yeast strain was able to completely metabolize 5-hydroxymethylfurfural, furfural, syringaldehyde and vanillin, both under aerobic and anaerobic conditions. Yeast cells reacted to the presence of furan aldehydes by overproducing Hsp60 involved in the control of intracellular protein folding. The results may be helpful in optimizing the process parameters of second-generation ethanol production, in order to reduce the formation and toxic effects of fermentation inhibitors.