单一基质白光荧光粉Na3Sc2(PO4)3∶Tm3+,Dy3+的合成及发光性质

采用高温固相法成功制备了Na₃Sc_2-x-y(PO₄)₃∶xTm³⁺,yDy³⁺荧光粉,利用X射线衍射仪、扫描电子显微镜和荧光光谱仪对荧光粉进行了物相、形貌和发光性能进行了表征。 在Na₃Sc₂(PO₄)₃∶0.06Tm³⁺,yDy³⁺荧光粉中,物质的量分数6%的Tm³⁺和6%的Dy³⁺在360 nm激发下呈现出白光发射,其发射光谱在460~685 nm范围内存在Tm³⁺位于457 nm的特征发射峰,对应于Tm³⁺的³H₆→¹D₂跃迁,以及Dy³⁺位于483、577和672 nm处的3个特征发射峰,分别对应于Dy³⁺的⁴F_9/2→⁶H_15/2、⁴F_9/2→⁶H_13/2和⁴F_9/2→⁶H_11/2的跃迁。 观测到Na₃Sc₂(PO₄)₃∶Tm³⁺荧光粉的发射光谱与Na₃Sc₂(PO₄)₃∶Dy³⁺的激发光谱有较好的重叠,且Tm³⁺的荧光寿命随Dy³⁺浓度的增加逐渐降低,因此在Na₃Sc₂(PO₄)₃∶Tm³⁺,Dy³⁺荧光粉中存在Tm³⁺向Dy³⁺的能量传递。 利用Dexter和Reisfeld近似分析了能量转移机制,发现从Tm³⁺到Dy³⁺的能量传递临界距离为1.6 nm,能量传递过程是通过偶极-偶极相互作用进行的。 Na₃Sc₂(PO₄)₃∶0.06Tm³⁺,0.06Dy³⁺荧光粉具有较好的耐受热猝灭性能,在423、473和523 K时的发射强度分别为298 K时发射强度的97.6%、89.2%和78.6%。 随着Dy³⁺浓度的增加,Na₃Sc₂(PO₄)₃∶0.06Tm³⁺,yDy³⁺荧光粉的发光颜色由蓝色转变为白色,再由白色变黄色。 Na₃Sc₂(PO₄)₃∶Tm³⁺,Dy³⁺荧光粉作为一种可调色或单相白光荧光粉在发光二极管上具有潜在的应用前景。     

Effect of poly(methylhydrogen)siloxane modification on adjusting mechanical properties of bamboo flour‐reinforced HDPE composites

Cellulose - Poly(methylhydrogen)siloxane (PMHS) was applied for hydrophobic modification of bamboo flour (BF) at room temperature based on the dehydrogenation between hydroxyl groups of BF and...     

Controlled migration of antifog additives from LLDPE compatibilized with LLDPE grafted maleic anhydride

This paper summarizes a study of controlled migration of an antifog (AF) additive; sorbitan monooleate (SMO), from linear low density polyethylene (LLDPE) films containing a compatibilizer, LLDPE grafted maleic anhydride (LLDPE‐g‐MA). LLDPE/LLDPE‐g‐MA/SMO blends were prepared by melt compounding. Bulk and surface properties of compression molded LLDPE films containing SMO and LLDPE‐g‐MA were characterized using Fourier transform infrared spectroscopy and contact angle measurements. Thermal properties were investigated using a thermal gravimetric analyzer. Diffusion coefficient (D) was calculated, and AF properties were characterized using a “hot fog” test. Compression molded films were characterized for their morphology using high‐resolution scanning electron microscopy, and rheological properties were measured using a parallel‐plate rotational rheometer. It was found that the LLDPE/LLDPE‐g‐MA/SMO systems are characterized by a slower SMO migration rate, a lower diffusion coefficient, and lower contact angle values compared with LLDPE/SMO blends. These results are well correlated with results of a hot fog test. Morphological studies revealed a very fine dispersion of SMO in the LLDPE films, when 3 phr LLDPE‐g‐MA was combined with 1 phr SMO. Thermal analysis results show that the incorporation of 3 phr LLDPE‐g‐MA and 1 phr SMO significantly increases the decomposition temperature of the blend at T > 400°C. At high shear rates, the LLDPE blends show that the AF and the compatibilizer have a lubrication effect on LLDPE. Copyright © 2014 John Wiley & Sons, Ltd.     

Synthesis of Chiral Exocyclic Amines by Asymmetric Hydrogenation of Aromatic Quinolin‐3‐amines

Asymmetric hydrogenation of aromatic quinolin‐3‐amines was successfully developed with up to 94 % enantiomeric excess (ee). Introduction of the phthaloyl moiety to the amino group is crucial to eliminate the inhibition effect caused by the substrate and product, to activate the aromatic ring, and to improve the diastereoselectivity. This new methodology provides direct and facile access to chiral exocyclic amines. Notably, this report is the first on the highly enantioselective hydrogenation of aromatic amines.     

Facile Mechanochemical Synthesis of Nano SnO2/Graphene Composite from Coarse Metallic Sn and Graphite Oxide: An Outstanding Anode Material for Lithium‐Ion Batteries

A facile method for the large‐scale synthesis of SnO₂ nanocrystal/graphene composites by using coarse metallic Sn particles and cheap graphite oxide (GO) as raw materials is demonstrated. This method uses simple ball milling to realize a mechanochemical reaction between Sn particles and GO. After the reaction, the initial coarse Sn particles with sizes of 3–30 μm are converted to SnO₂ nanocrystals (approximately 4 nm) while GO is reduced to graphene. Composite with different grinding times (1 h 20 min, 2 h 20 min or 8 h 20 min, abbreviated to 1, 2 or 8 h below) and raw material ratios (Sn:GO, 1:2, 1:1, 2:1, w/w) are investigated by X‐ray diffraction, X‐ray photoelectron spectroscopy, field‐emission scanning electron microscopy and transmission electron microscopy. The as‐prepared SnO₂/graphene composite with a grinding time of 8 h and raw material ratio of 1:1 forms micrometer‐sized architected chips composed of composite sheets, and demonstrates a high tap density of 1.53 g cm^?3. By using such composites as anode material for LIBs, a high specific capacity of 891 mA h g^?1 is achieved even after 50 cycles at 100 mA g^?1.     

Synthesis of Rhenabenzenes from the Reactions of Rhenacyclobutadienes with Ethoxyethyne

Treatment of Na[Re(CO)₅] with RC?CCO₂Et (R=phenyl, naphthalen‐1‐yl, phenanthren‐9‐yl and pyren‐1‐yl) followed by reaction with acetyl chloride and ethanol afforded the rhenacyclobutadienes Re{‐C(R)?C(CO₂Et)C(OEt)?}(CO)₄. Reactions of these rhenacyclobutadienes with HC?COEt produced rhenabenzenes Re{‐C(R)?C(CO₂Et)C(OEt)?CHC(OEt)?}(CO)₄. Except for R=Ph, new rhenacyclobutadienes with pendant alkenyl substituents Re{‐C(R)?C(C(OEt)?CH(CO₂Et))C(OEt)?}(CO)₄ were also isolated from these reactions. The NMR spectroscopic and X‐ray structural data, as well as the aromatic stabilization energy (ASE) values suggest that the rhenabenzenes are aromatic, with extensive delocalized π character.     

Enhanced Anticancer Efficacy by ATP‐Mediated Liposomal Drug Delivery

A liposome‐based co‐delivery system composed of a fusogenic liposome encapsulating ATP‐responsive elements with chemotherapeutics and a liposome containing ATP was developed for ATP‐mediated drug release triggered by liposomal fusion. The fusogenic liposome had a protein–DNA complex core containing an ATP‐responsive DNA scaffold with doxorubicin (DOX) and could release DOX through a conformational change from the duplex to the aptamer/ATP complex in the presence of ATP. A cell‐penetrating peptide‐modified fusogenic liposomal membrane was coated on the core, which had an acid‐triggered fusogenic potential with the ATP‐loaded liposomes or endosomes/lysosomes. Directly delivering extrinsic liposomal ATP promoted the drug release from the fusogenic liposome in the acidic intracellular compartments upon a pH‐sensitive membrane fusion and anticancer efficacy was enhanced both in vitro and in vivo.     

Gold‐Catalyzed 1,2‐Acyloxy Migration/Intramolecular [3+2] 1,3‐Dipolar Cycloaddtion Cascade Reaction: An Efficient Strategy for Syntheses of Medium‐Sized‐Ring Ethers and Amines

A highly efficient strategy for the formation of medium‐sized‐ring ethers and amines based on a gold‐catalyzed cascade reaction, involving enynyl ester isomerization and intramolecular [3+2] cyclization, has been developed. Various multisubstituted medium‐sized‐ring unsaturated ethers and amines were obtained through this transformation. This method represents one of the relatively few transition metal catalyzed intramolecular cycloaddition reactions for medium‐sized ring synthesis.     

Synthesis of Polyketide Stereoarrays Enabled by a Traceless Oxonia‐Cope Rearrangement

Polyketide antibiotics bearing skipped polyols represent a synthetic challenge. A SiCl₄‐promoted oxonia‐Cope rearrangement of syn,syn‐2‐vinyl‐1,3‐diols was developed to forge an array of 1,5‐pentenediols, thus providing versatile motifs for the preparation of 1,2,3,5‐stereoarrays in a highly stereoselective manner. Further exploration with Sn(OTf)₂ realized the rearrangement of a cross‐aldehyde which tactically warrants the utility of the current approach to access complex polyketides. The origin of high stereoselectivity is attributed to a chairlike anti‐conformation of the oxonium ion intermediate.