Rapid, low pressure, and simultaneous ion chromatography of common inorganic anions and cations on short permanently coated monolithic columns

Short permanently coated reversed-phase silica based monolithic columns have been investigated for the rapid separation of inorganic anions and cations. One 2.5 x 0.46 cm column was permanently coated with didodecyldimethylammonium (DDAB), for anion analysis; and a second 5.0 x 0.46 cm column was coated with dioctylsulphosuccinnate (DOSS), for cation analysis. The use of a single combined eluent of 2.5 mM phthalate/1.5 mM ethylenediamine, at flow rates of between 4.0 and 8.0 mL/min, resulted in the rapid separation of 8 anions (in under 100 s) and 5 cations (in under 100 s) on the above columns when used individually, with detection limits for common anions ranging from approximately 0.25 to 5 mg/L, and between 2.5 and 50 mg/L for alkaline earth metals, by direct and indirect conductivity detection, respectively. However, with both columns subsequently connected in parallel, with the eluent delivered using a flow splitter from a single isocratic pump, the simultaneous analysis of anions and cations was also possible, based on a single conductivity detector. The potential of this system for the rapid, complete screening of water samples for multiple common anions and cations is shown.     

Fundamental role of the fostriecin unsaturated lactone and implications for selective protein phosphatase inhibition

Key derivatives and analogues of fostriecin were prepared and examined that revealed a fundamental role for the unsaturated lactone and confirmed the essential nature of the phosphate monoester. Thus, an identical 200-fold reduction in protein phosphatase 2A (PP2A) inhibition is observed with either the saturated lactone (7) or with an analogue that lacks the entire lactone (15). This 200-fold increase in PP2A inhibition attributable to the unsaturated lactone potentially may be due to reversible C269 alkylation within the PP beta12-beta13 active site loop accounting for PP2A/4 potency and selectivity.     

Tuning Thiophene with Phosphorus: Synthesis and Electronic Properties of Benzobisthiaphospholes

1,4‐Dimercapto‐2,5‐diphosphinobenzene and 3,6‐bis(hexyloxy)‐1,4‐dimercapto‐2,5‐diphosphinobenzene were synthesized and combined with various acid chlorides to obtain a series of benzobisthiaphospholes. Electrochemical and photophysical properties of the substituted benzobisthiaphospholes have been evaluated, and the observed reductions are more facile than the related benzothiaphospholes and 2,6‐diphenylbenzobisthiazole. A benzobisthiaphosphole with C₆H₄‐p‐CN substituents was reduced at E_1/2=?1.08 V (vs. saturated calomel electrode (SCE)). X‐ray diffraction data for several of these phosphorus heterocycles has been obtained, and DFT calculations at the B3LYP level have been performed.     

Silyl trifluoromethanesulfonate-activated para-methoxybenzyl methyl ether as an alkylating agent for thiols and aryl ketones

para-Methoxybenzyl methyl ether acts as an alkylating agent for thiols in the presence of trimethylsilyl trifluoromethanesulfonate and trialkylamine base in good yields (58–96%). Aryl ketones are alkylated under similar conditions, probably through an enol silane intermediate, also in high yields (67–95%). The active alkylating species is likely a p-methoxybenzyl cation.     

High Sensitive Microsensor Based on Organic‐Inorganic Composite for Two‐Dimensional Mapping of H2O2 by SECM

The present work describes the development of a selective, sensitive and stable sensing microsensor for scanning electrochemical microscopy (SECM) to measure H₂O₂ during electrochemical reduction of oxygen. The microsensor is based on graphene and Poly(3,4‐ethylenedioxythiophene) composite as support to iron (III) hexacyanoferrate (II) (PEDOT/graphene/Fe^III₄[Fe^II(CN)₆]₃ microsensor). The electrochemical properties of the PEDOT/graphene/Fe^III₄[Fe^II(CN)₆]₃ microsensor were investigated by cyclic voltammetry (CV) and scanning electrochemical microscopy (SECM). The PEDOT/graphene/Fe^III₄[Fe^II(CN)₆]₃ microsensor showed an excellent electrocatalytic activity toward hydrogen peroxide (H₂O₂) reduction with a diminution of the overpotential of about 500 mV in comparison to the process at a bare gold microelectrode. The microsensor presented excellent performance for two dimensional mapping of H₂O₂ by SECM in 0.1 mol L^?1 phosphate buffer solution (pH 7.0). Under optimized conditions, a linear response range from 1 up to 1000 µmol L^?1 was obtained with a sensitivity of 0.08 nA L µmol^?1 and limit of detection of 0.5 µmol L^?1.     

Structure determination of sec-butylbenzene rotamers by UV spectroscopy and ab initio calculations

Sec-butylbenzene has been investigated using resonant two-photon ionization (R2PI) and UV–UV hole-burning spectroscopy aided by ab initio calculations. All three conformers predicted from theory are observed in the spectrum, and are assigned by rotational band contour analysis. The most strongly populated conformer (G1) has a gauche arrangement of the side chain dihedral angle τ₂(C₁C_αC_βC_γ). The populations of the anti (A) and the remaining gauche conformer (G2) are about 7% and 2%, respectively. The alpha methyl group is found to significantly affect the conformational preferences in sec-butylbenzene (sec-BB), compared to n-propylbenzene in which the anti conformer is favored.     

Distortion and charge density wave in the Ga square net coupled to the site occupancy wave in YCo0.88Ga3Ge

YCo 0.88Ga 3Ge has an incommensurately modulated structure that was solved with (3 + 1)D superspace techniques. YCo 0.88Ga 3Ge crystallizes in the orthorhombic superspace group Immm(alpha00)00 s with unit cell constants of a = 4.1639(4), b = 4.1639(4), c = 23.541(2) A and a modulation vector of q = 0.3200(4) a* at 293 K. The incommensurate modulation, which creates a very large supercell ( approximately 25 fold), arises from a charge density wave (CDW) in the square net of Ga atoms that is coupled with a site occupancy wave (SOW) of Co atoms. The distorted Ga net features polygallide ribbons, chains, as well as single atoms. Temperature dependent crystallographic studies of the structure from 100-500 K indicate that the CDW is "locked in". Electrical conductivity and thermopower measurements in the temperature range of 300-500 K show that YCo 0.88Ga 3Ge is a poor metal.     

High throughput screening arrays of rhodium and iridium complexes as catalysts for intramolecular hydroamination using parallel factor analysis

Parallel factor analysis (PARAFAC) was used to analyze data from the high throughput screening of an array of organometallic rhodium and iridium complexes as catalysts for the intramolecular hydroamination of 2-(2-phenylethynyl)aniline to give 2-phenylindole. The progress of the hydroamination reactions was monitored using UV-visible spectroscopy. The overlapped UV-visible spectra of the mixture of starting material, product and solvent in the samples taken at different times were deconvoluted using PARAFAC. Unique PARAFAC models led to close approximations of the actual UV-visible spectra of the compounds in the mixture. The performance of the catalysts was then compared by estimating the final concentration of the starting material and product using PARAFAC loadings. A library of 63 complexes generated in situ was examined in a single experiment using this methodology. The complexes were generated from combinations of seven ligands (bis(N-methyl2-imidazolyl)methane, bis(1-pyrazolyl)methane, 1,10-phenanthroline, N,N'-bis(p-tolyl)diazabutadiene, N,N'-bis(p-tolyl)1,2-dimethyldiazabutadiene, N,N'-bis(mesityl)1,2-dimethyldiazabutadiene and bis(2,4,6-trimethylphenylimino)acenapthene) and nine metal precursors ([Ir(COD)Cl](2) (COD = 1,5-cyclooctadiene), [Ir(CO)(2)Cl](n), [Ir(COE)(2)Cl](2), [IrCp*Cl(2)](2) (Cp* = 1,2,3,4,5-pentamethylcyclopentadiene), [Rh(COD)Cl](2), [Rh(CO)(2)Cl](2), [Rh(COE)(2)Cl](2), [RhCp*Cl(2)](2) and [RhCpCl(2)](2)) (Cp = cyclopentadiene)). The proposed method can be used for the fast screening of arrays of metal complexes for identifying effective catalysts, providing information that can augment traditional methods used for the analysis of catalyzed reactions.     

Effects of surface passivation on the exciton dynamics of CdSe nanocrystals as observed by ultrafast fluorescence upconversion spectroscopy

The exciton dynamics of CdSe nanocrystals are intimately linked to the surface morphology. Photo-oxidation of the selenium surfaces of the nanocrystal leads to an increase in radiative decay efficiency from both the band edge and deep trap emission states. The addition of the primary amine hexadecylamine curtails nonradiative excitonic decay attributed to the dangling surface selenium orbitals by passivation of those trap sites by the methylene protons on the amine, leading to enhanced band edge emission and the absence of deep trap emission. Furthermore, CdSeZnSe core/shell nanocrystals are not immune from contributions from surface states because of the alignment of the band structures of the core and shell materials.