Thermodynamic perturbation theory for fused sphere hard chain fluids using nonadditive interactions

A model is developed for the equation of state of fused chains based on Wertheim thermodynamic perturbation theory and nonadditive size interactions. The model also assumes that the structure (represented by the radial distribution function) of the fused chain fluid is the same as that of the touching hard sphere chain fluid. The model is completely based on spherical additive and nonadditive size interactions. The model has the advantage of offering good agreement with simulation data while at the same time being independent of fitted parameters. The model is most accurate for short chains, small values of Delta (slightly fused spheres) and at intermediate (liquidlike) densities.     

Mechanochemical Adsorption of Phenol by Tot Swelling Clay Minerals

The mechanochemical adsorption of phenol by laponite, saponite, montmorillonite, beidellite and vermiculite was studied by IR and X-ray spectroscopy. Mixtures containing phenol and clay in the ratio of 6:10 were manually ground by a mortar and pestle for 1,3,5 and 10 min and the ground mixtures were investigated. Depending on the basicity of the clay mineral and the time of grinding, two different associations between interlay er cations, water and phenol were identified. In these associations phenol can act either as a proton acceptor or donor (Configurations I and II, respectively). The phenol is more acidic than water and in most cases phenol acts as a proton donor. With montmorillonite and beidellite phenol acts as a proton acceptor. In this association the aromatic ring forms π bonds with atoms of the oxygen planes of the tetrahedral sheets which donate electrons to the anti-bonding π orbitals of the phenol.     

Optimization of an electrolytic conductivity detector for determination of toxic nitrogen-containing food contaminants separated by open tubular column gas chromatography

The combination of open tubular column gas chromatography with electrolytic conductivity detection has been evaluated for the determination of nitrogen-containing pesticide residues in food extracts. Optimization of the column position at the column-detector interface was crucial to the successful operation of the detector. The signal-to-noise ratio and response stability of the detector are greatly influenced by the composition of the electrolyte solvent. Large volume splitless injections using retention gaps and optimized detector operating conditions enabled pesticide residues in food extracts to be determined at sub parts-per-million levels. Although the electrolytic conductivity detector is less sensitive than the thermionic ionization detector, its greater nitrogen selectivity can he crucial to the determination of nitrogen-containing contaminants in food extracts, particularly in complex mixtures where phosphorus-containing contaminants or matrix compounds are also present.     

Solid-phase synthesis of arginine-containing peptides and fluorogenic substrates using a side-chain anchoring approach

Attachment of an amino acid to a solid support by its side chain is sometimes necessary to take advantage of an alpha-carboxylic group available for diverse modifications, including the incorporation of a fluorophore for the preparation of fluorogenic substrates. In contrast to most other amino acids, anchoring the guanidinium group of an arginine to a resin requires the use of a supplementary linker. To avoid the usually multistep synthesis of such a linker as well as its difficult attachment to the guanidine group, we developed a simple method where the guanidine group is built on a Rink amide resin. Our strategy followed the steps of guanidine formation: (i) addition of an isothiocyanate derivative of ornithine to the amino group of a solid support, yielding Nomega-linked thiocitrulline; (ii) S-methylation of thiourea; (iii) guanidinylation using ammonium acetate. Cleavage of the resin generated the arginine-containing compound, the amine group of the resin becoming part of the guanidine. We have demonstrated the usefulness of this method by the synthesis of a series of fluorogenic substrates for trypsin-like serine proteases, which were obtained in high yield and purity. Then, our strategy also allowed generation from the same precursor differentially substituted arginine derivatives, including Nomega-methyl- and Nomega-ethylarginines. The ability to prepare such analogues together with the intermediates thiocitrulline and S-methylisothiocitrulline from a unique precursor while the alpha-amine and carboxylic groups remain available for modification also makes this method a powerful tool for combinatorial solid-phase synthesis of NO synthase inhibitors.     

Molecular structure of an alkyl-side-chain polymer-water interface: origins of contact angle hysteresis

A new and direct approach to verify surface heterogeneity as the microscopic origin of contact-angle hysteresis is demonstrated. IR-visible sum-frequency-generation spectroscopy (SFG) was used to selectively probe the molecules at the interface of an alkyl-side-chain polymer [poly(vinyl n-octadecyl carbamate-co-vinyl acetate)] with water. The spectra indicate that in contact with water, the polymer surface is heterogeneous (having areas of differing surface energies). This evidence of surface heterogeneity supports the hysteresis observed in the advancing and receding contact angles of the polymer surface with water. The same measurements made for the chemically and structurally similar surface of an octadecyltrichlorosilane self-assembled monolayer indicates a homogeneous surface at the water interface. In this case, contact-angle hysteresis measurements implicate surface roughness as the cause of hysteresis. Atomic force microscopy measurements of roughness for these surfaces further support our conclusions. The polymer-water interface was probed using SFG at above-ambient temperatures, and an order-to-disorder transition (ODT) of alkyl side chains at the interface was observed, which closely follows the melting of crystalline side chains in the bulk. This transition explains the increased wettability of the polymer, by water, when the temperature is raised above the bulk melting temperature. Furthermore, the irreversibility of this ODT suggests that the disordered polymer-water interface is the thermodynamic equilibrium state, whereas the before-heating structure of this interface is a kinetically hindered metastable state.     

Eilatin complexes of ruthenium and osmium. synthesis, electrochemical behavior, and near-IR luminescence

The synthesis and characterization of new Ru(II) and Os(II) complexes of the ligand eilatin (1) are described. The new complexes [Ru(bpy)(eil)(2)](2+) (2), [Ru(eil)(3)](2+) (3), and [Os(eil)(3)](2+) (4) (bpy = 2,2'-bipyridine; eil = eilatin) were synthesized and characterized by NMR, fast atom bombardment mass spectrometry, and elemental analysis. In the series of complexes [Ru(bpy)(x)(eil)(y)()](2+) (x + y = 3), the effect of sequential substitution of eil for bpy on the electrochemical and photophysical properties was examined. The absorption spectra of the complexes exhibit several bpy- and eil-associated pi-pi and metal-to-ligand charge-transfer (MLCT) transitions in the visible region (400-600 nm), whose energy and relative intensity depend on the number of ligands bound to the metal center (x and y). On going from [Ru(bpy)(2)(eil)](2+) (5) to 2 to 3, the d(pi)(Ru) --> pi(eil) MLCT transition undergoes a red shift from 583 to 591 to 599 nm, respectively. Electrochemical measurements performed in dimethyl sulfoxide reveal several ligand-based reduction processes, where each eil ligand can accept up to two electrons at potentials that are significantly anodically shifted (by ca. 1 V) with respect to the bpy ligands. The complexes exhibit near-IR emission (900-1100 nm) of typical (3)MLCT character, both at room temperature and at 77 K. Along the series 5, 2, and 3, upon substitution of eil for bpy, the emission maxima undergo a blue shift and the quantum yields and lifetimes increase. The radiative and nonradiative processes that contribute to deactivation of the excited level are discussed in detail.     

Syntheses and crystal structures of dinuclear complexes containing d-block and f-block luminophores. Sensitization of NIR luminescence from Yb(III), Nd(III), and Er(III) centers by energy transfer from Re(I)- and Pt(II)-bipyrimidine metal centers

Mononuclear complexes [Re(bpym)(CO)(3)Cl] and [Pt(bpym)(CC-C(6)H(4)CF(3))(2)] (bpym = 2,2'-bipyrimidine), in which one of the bipyrimidine sites is vacant, have been used as "complex ligands" to prepare heterodinuclear d-f complexes in which a lanthanide tris(1,3-diketonate) unit is attached to the secondary bipyrimidine site to evaluate the ability of d-block chromophores to act as antennae for causing sensitized near-infrared (NIR) luminescence from adjacent lanthanide(III) centers. The two sets of complexes so prepared are [Re(CO)(3)Cl(mu-bpym)Ln(fod)(3)] (abbreviated as Re-Ln; where Ln = Yb, Nd, Er) and [(F(3)C-C(6)H(4)-CC)(2)Pt(mu-bpym)Ln(hfac)(3)] (abbreviated as Pt-Ln; where Ln = Nd, Gd). Members of both series have been structurally characterized; the metal-metal separation across the bipyrimidine bridge is approximately 6.3 A in each case. In these complexes, the (3)MLCT (MLCT = metal to ligand charge-transfer) luminescences of the mononuclear [Re(bpym)(CO)(3)Cl] and [Pt(bpym)(CC-C(6)H(4)CF(3))(2)] complexes are quenched by energy transfer to those lanthanides (Ln = Yb, Nd, Er) that have low-lying f-f states capable of NIR luminescence; as a result, sensitized NIR luminescence is seen from the lanthanide center following excitation of the d-block unit. In the solid state, quenching of the luminescence from the d-block chromophore is complete, indicating efficient d --> f energy transfer, as a result of the short metal-metal separation across the bipyrimidine bridge. In a CH(2)Cl(2) solution, partial dissociation of the dinuclear complexes into the mononuclear units occurs, with the result that some (3)MLCT luminescence is observed from mononuclear [Re(bpym)(CO)(3)Cl] or [Pt(bpym)(CC-C(6)H(4)CF(3))(2)] present in the equilibrium mixture. Solution UV-vis and luminescence titrations, carried out by the addition of portions of Ln(fod)(3)(H(2)O)(2) or Ln(hfac)(3)(H(2)O)(2) to the d-block complex ligands, indicate that binding of the lanthanide tris(1,3-diketonate) unit at the secondary bipyrimidine site to give the d-f dinuclear complexes occurs with an association constant of ca. 10(5) M(-)(1).     

Cyclic voltammograms of iron and C-steels in oxalic acid solutions and investigation of the effect of phenyl phthalimide as corrosion inhibitors

Summary The electrochemical behaviour of Fe and C-steel samples in oxalic acid solutions was studied by the use of cyclic voltammetry. Two peaks were observed; the first one was the anodic peak and the second one an unexpected reductive dissolution peak which could be observed in the cathodic branch of cyclic voltammograms of all electrodes studied. The carbon content was found to increase the active dissolution of steels and to decrease their tendency towards passivation. The inhibitive efficiency of phenyl phthalimide derivatives on the active dissolution of Fe and steel samples in 0.1M oxalic acid were investigated.

---

Cyclische Voltammogramme von Eisen und C-Stählen in Oxalsäurelösungen und der Einfluß von Phenylphthalimiden als Korrosionsinhibitoren

Zusammenfassung Das elektrochemische Verhalten von Eisen und C-Stählen in Oxalsäurelösungen wurde mit Hilfe cyclischer Voltammetrie studiert. Dabei treten zwei Signale auf: das anodische Signal sowie ein unerwartetes reduktives Lösungssignal. Letzteres wurde im kathodischen Zweig der cyclischen Voltammogramme aller untersuchten Elektroden gefunden. Der Kohlenstoffgehalt erhöht die aktive Auflösung von Stählen und erniedrigt ihre Tendenz zur Passivierung. Die Inhibitionseffizienz von Phenylphthalimiden für die aktive Auflösung von Eisen und Stahlproben in 0.1M Oxalsäure wurde untersucht.

     

Anti-HIV Active Naphthyl Analogues of HEPT and DABO

Summary.  5-Isopropyl-6-naphthyl uracil and 5-isopropyl-6-naphthyl-2-thiouracil were alkylated to give N-1-(ethoxymethyl and methylthiomethyl) uracil and S²-cyclohexyl-thiouracil, respectively. 5-Ethyl-6-naphthyl uracil and 5-ethyl-6-naphthyl-2-thiouracil afforded N-1-(ethoxymethyl, methoxy-methyl, methylthiomethyl, acetoxyethoxy methyl and hydroxyethoxy methyl) uracil and S²-((2,2- diethoxyethyl), methoxycarbonylmethyl, ethoxycarbonylpropyl, methylthiomethyl, ethoxymethyl, methyl and cyclohexyl)-thiouracil upon alkylation. Received September 25, 2001. Accepted (revised) December 3, 2001     

Deposition of ZnS thin film by ultrasonic spray pyrolysis: effect of thickness on the crystallographic and electrical properties

Zinc sulfide (ZnS) thin films have been deposited on Si (1 0 0) substrate using ultrasonic spray pyrolysis. X-ray diffraction (XRD) analysis revealed that the films are (0 0 2) preferentially oriented with c-axis-oriented wurtzite structure. The crystallinity has been found to improve with film thickness in the 180–6000 nm range. Film structure has been analyzed by XRD, scanning electron microscope, FTIR, and Raman spectroscopies, while the stoichiometry has been verified by energy-dispersive spectroscopy and particle-induced X-ray emission techniques. Electrical properties of the grown films were characterized by current–voltage and capacitance–voltage measurements where, the films show better conducting behavior at higher thickness.