Cyclopolycondensations. VII. Preparation of aromatic poly(ureido acids) by the low-temperature solution polymerization and cyclodehydration to fully aromatic polyquinazolinediones

Fully aromatic polyquinazolinediones (IV) of high molecular weight were obtained by thermal cyclodehydration of aromatic poly(uredio acids) (III) prepared by the polyaddition reaction of 4,4′-diaminobiphenyl-3,3′-dicarboxylic acid (I) with aromatic diisocyanates (II). From the kinetic study of reactions of model systems (anthranilic acid with phenyl isocyanate) in the presence of a variety of basic catalysts, it was established that tertiary amines had the highest catalytic activity for the formation of ureido linkage. The optimum polymerization conditions were determined by the study of reaction variables such as monomer concentration, polymerization temperature, monomer ratio, and catalyst concentration. The effect of polarity and purity of organic solvents and reactants was also studied.     

Planar chiral cyclic ether: asymmetric resolution and chirality transformation

Remarkably stable planar chirality was found in a nine-membered diallylic cyclic ether. Enantiomerically enriched ether was prepared by a kinetic resolution of a racemic one, which is valuable as a novel type of chiral building block.     

Preparation and characterization of silicalite-1 membranes prepared by secondary growth of seeds with different crystal sizes

MFI-type zeolite particles of 0.1–1 μm in diameter were prepared by adjusting tetra-n-propylammonium hydroxide (TPAOH) and water contents in synthesis mixtures. Using those particles as seeds, MFI-type zeolite membranes were prepared on the surface of a porous mullite tube by secondary growth. The membranes were formed as polycrystalline zeolite layers on and inside the porous support, and the membranes were composed of the [h 0 h]-oriented crystallites. The membrane consisting of a-oriented crystallites could be also prepared. However, the a-oriented zeolite layers were not active on the permeation properties of butanes. Rather the size and loaded amount of the seed particles influenced on the permeation properties through the membranes. As a result, the n-C₄H₁₀/i-C₄H₁₀ permselectivity could be increased to 220 by adjusting the size and the loaded amount of particles. These results suggest that the number of loaded particles affects on the permeation properties through the membranes.     

Distribution and behavior of long-lived radioiodine in soil

The concentration of¹²⁹I in soil in Japan was determined by neutron activation analysis. For the activation analysis, pre-irradiation chemical separation of the iodine was carried out by acid decomposition and distillation and post-irradiation treatment was performed by ion exchange and solvent extraction. The concentration of stable iodine and¹³⁷Cs were also determined and compared with the behavior of¹²⁹I in soil.Soil samples from Ibaraki, Fukui, Fukushima, and Nagasaki Prefectures were analyzed and¹²⁹I was detected in amounts ranging from 10^–7 to 10^–5 Bq/g soil in uncultivated surface soil. There are apparently small variations in the¹²⁹I concentrations in each of the regions analyzed.From depth profile studies in sandy soil, the iodide form of¹²⁹I was found to migrate downward at a relatively rapid rate while other species remain longer in the surface soil.     

Charge-transfer interactions,exciplex formations and ionic dissociations in singlet oxygen reactions

Intermolecular perturbation and configuration interaction calculations have been carried out to elucidate the attacking modes of singlet molecular oxygen (¹O₂) to allyl olefins and electron-rich olefins, which are classified into four groups from their molecular structures. It is found: (1) that the attacking modes are dependent on the molecular structure of substrates ; (2) that the charge-transfer (CT) interactions between ¹O₂ and substrates are particularly important for the formation of exciplexes through which the ene and (2+2) reactions of ¹O₂ proceed ; and (3) that the CT energy levels are important in governing the fraction of ionic dissociation to produce Superoxide anion and the relative ratio between the (4+2) and (2+2) reactions of ¹O₂ with dienes, heterocycles and related species.     

Size distribution and characteristics of chemical components in ambient particulate matter.

Ambient particulate matter and gas in Kyoto were investigated by gravimetric analysis, X-ray fluorescence spectrometry, and ion chromatography in order to clarify their behavior and origin. The size distribution and characteristics of the chemical components in ambient particulates collected on PTFE membrane filters using an Andersen air sampler were examined from August 2001 to April 2004. A four-stage filter pack method was used to sample the atmosphere for the determination of gas (SO2, HNO3, HCl, NH3) and particulate matter (SO42, NO3, Cl-, Na+, K+, Ca2+, Mg2+, NH4+) concentrations from October 2002 to April 2004. The concentration of SPM mass was in the range of 6.7 - 80.2 microg/m3. The size distributions of SPM mass were bimodal, peaking at around 0.65 - 1.1 and 3.3 - 4.7 microm, and 40 - 85% of SPM mass was fine particles (< 2.1 microm). Na, Mg, Al, Si, Ca, Cl, and Fe were mainly present in coarse particles (2.1 to 11.0 microm), while S was present in fine particles. The concentrations of Al, Si, Ca, Mg, and Fe in fine particles increased from March to April in 2002, and those in coarse particulates increased in November 2002 and from March to April in 2004. This may be the effect of the continental yellow sand "Kosa." The differences in the size distributions of Al, Si, Ca, Mg, and Fe in particles may depend on differences in their place of occurrence and course of transport from China to Japan. The concentration of HCl gas was higher than that of particulate chloride ion in summer. Nitric acid gas existed at higher concentrations in summer, but fine particulate nitrate ion was observed in winter. The gaseous-to-fine aerosol nitrate fraction became higher at warmer temperatures. Coarse sulfate was below 10%, and SO2 gas and fine particulate sulfate were above 90%.     

Absorption and fluorescence of a nonionic detergent in aqueous solution

The absorption and fluorescence spectra of a detergent, polyoxyethylene octylphenyl ether, were measured in water at different concentrations. The absorption spectra had a peak at 275 mμ and a shoulder at 281 mμ. The spectra were independent of concentration below the critical micelle concentration, but the molar extinction coefficients of the peak and the shoulder increased with concentration above the critical micelle concentration. The critical micelle concentration value derived from the absorption data was in good agreement with those obtained by other methods. The fluorescence spectra of the detergent in water were independent of concentration in dilute solutions, if the intensities of the spectra were normalized at the peak at 302 mμ. At higher concentrations, a weak excimer band appeared at 345 mμ, whose intensity increased with concentration. The excimer band manifested itself at a concentration slightly lower than the critical micelle concentration. The main band decreased and the excimer band increased, as the temperature was raised. An excimer band was observed in the same region of the spectra for the pure detergent, either in the solid or liquid state. The equilibrium solid spectra exhibited a very strong excimer emission. It was concluded that the excimers were formed within micelles in the case of aqueous solutions.     

Analysis of scintigrams using fuzzy theory

Textural features for phantom images were extracted. Texture parameters which represent RI distribution--skew, energy, entropy and angular second moment were used. But, it was difficult to analyse the images using discriminant analysis for textural features, because textural features had statistical noise. Therefore fuzzy reasoning was adapted to analyse the images. Textural features for six kinds of images were showed using membership function. The possibility to the image was evaluated using the value of membership function on each images. Fuzzy reasoning could be done easily using max-min composition formula. The reasoning was found more suitable to analyse the images than discriminant analysis and will be considered useful for analysis of clinical scintigrams.     

Electrochemical synthesis of a polypyrrole thin film with supercritical carbon dioxide as a solvent

A conductive polypyrrole (PPy) film was successfully synthesized in a homogeneous supercritical carbon dioxide (scCO2)/acetonitrile (AN) system. The occurrence of a homogeneous supercritical state was confirmed by observations of the phase behavior of the system through a high-pressure cell with a viewing window. The concentration of a supporting electrolyte, tetrabutylammonium hexafluorophosphate (TBAPF6), significantly changed the phase behavior of the scCO2/AN system. The polymerization rate of the film in that system decreased with further addition of CO2. This result suggested that the low viscosity of scCO2 did not play an important role in improving the growth rate of the PPy film. The low polymerization rate might have been due to the electron-transfer resistance arising from the low dielectric constant of scCO2/AN mixture. The roughness of the film prepared in the homogeneous scCO2/AN system was 1/10 that synthesized in AN itself as a solvent. The slow growth of film and the high diffusion rate of the monomer seemed to account for the smooth flat film formation.     

Multiple and irreversible binding of cis-diamminedichloroplatinum(II) to human serum albumin and its effect on warfarin binding.

Irreversible bindings of cis-diamminedichloroplatinum(II) (cis-DDP) to human serum albumin (HSA) were investigated in a pH 7.4 buffer containing 0.1 M NaCl at various molar ratios (cis-DDP/HSA) up to 60 over a 14 d period (37 degrees C). The metal binding seemed to reach a plateau when incubated at less than 10 times excess of cis-DDP. As the molar ratio increased, the reaction rate was relatively fast within the first day, followed by a moderate increase in the metal binding. When incubated at 60 times excess of cis-DDP, the metal bound as much as 20 mol per mol of HSA in 14 d. Fluorescence quenching of the metal-bound protein suggested that the tryptophan residue was gradually exposed to a hydrophilic environment as the metal binding increased. Furthermore, cis-DDP cleaved disulfide bonds at the ratio of 1 mol of disulfide bond per 5.3 mol of the metal binding. It was therefore suggested that the metal binding also occurred at several sites other than the disulfide bond. Warfarin binding to the metal-bound protein, examined by fluorescence changes, also decreased with increasing metal binding or cleavage of the disulfide bonds. Thus, cis-DDP bound to multiple sites in addition to the lone sulfhydryl group (Cys-34), suggesting that massive conformational changes of the protein took place.