Optimized Selection of Water Resource Allocation Schemes Based on Improved Connection Entropy in Beijing’s Southern Plain

Increased urbanization has caused problems such as increasing water consumption and the continuous deterioration of the groundwater environment. It is necessary to consider the groundwater quality in the water resource optimization system and increase the rate of reclaimed water development to reduce the amount of groundwater exploitation and achieve sustainable development of water resources. This study used the Daxing District, a region of Beijing’s southern plain, as an example to evaluate water quality by analyzing water quality data of surface and groundwater from 2012 to 2016 and actual water-use schemes from 2006 to 2016. Three groundwater extraction modes were set up based on NO₃–N concentrations, water resources were optimized under three extraction modes, and water resource optimization schemes were determined based on the improved connection entropy. The results show that (1) the surface water quality was poor, and the proportion of V₄ type water in the indexes of NH₃–N and chemical oxygen demand (COD) was the largest. The surface water can only be used for agricultural irrigation. The pollution sources contributing most to NH₃–N and COD were domestic and agricultural pollution sources. (2) The groundwater quality was good. The NO₃–N index was primarily type I–III water, accounting for 95.20% of the total samples. Severe NH₃–N pollution areas were mainly in the northern region, and most regional groundwater can be used for various purposes. (3) Taking 2016 as an example, three groundwater exploitation modes were set to optimize water resource allocation, and the results showed that the rate of groundwater development and NO₃–N pollution decreased significantly after optimization. (4) Connection entropy is an evaluation method that combines connection numbers and entropy, including identify, difference, and opposition entropy. As connection entropy being a kind of complete entropy, which can reflect the difference of the system in different states, based on the improved connection entropy, the connection entropies of optimal water resource allocation and actual water-use schemes were calculated. The connection entropy of groundwater exploitation mode 3 was less than that of groundwater exploitation modes 1 and 2 and actual water-use schemes from 2006 to 2016. Therefore, exploitation mode 3’s water resource optimization scheme was recommended. In the paper, satisfactory results have been obtained. As a kind of complete entropy, connection entropy has great research value in dealing with complex hydrological problems. This study’s research methods and outcomes can provide methodological and theoretical lessons for water management in freshwater-deficient areas.     

聚合物气体辅助注射成型制品的形态结构

作为一种由常规注射成型发展起来的聚合物加工技术,气体辅助注射成型具有节约原材料、缩短成型周期以及提高制品性能等优点,已得到广泛的应用.由于气辅成型过程是一个在刚、柔双重约束界面条件下进行的多相复杂体系的多次流动过程,因而其形态结构的形成、发展和演化要远比常规注塑成型复杂.然而在气辅成型的形态结构方面,国内外的研究一直以来开展得较少.近年来,作者在聚合物及其共混物、复合材料气辅成型制品的形态结构方面已开展了广泛的研究工作,本文对这些工作和一些重要结果作了总结,并简要分析了成型过程中剪切场对形态演化的影响,最后对该研究方向的发展趋势作了展望.     

低浓度部分水解聚丙烯酰胺/柠檬酸铝交联体系剪切稳定性研究

采用粘度法、核孔膜过滤和动态光散射(DLS)法,研究了高分子量低浓度的部分水解聚丙烯酰胺(HPAM)与柠檬酸铝(AlCit)反应所形成的交联体系的剪切稳定性和HPAM剪切降解后与AlCit反应所形成的体系的封堵性能及降解机理.研究结果表明,低浓度的HPAM与AlCit反应所形成的交联聚合物体系随剪切速率增加,其对1.2μm的核孔膜的封堵能力降低.HPAM稀溶液剪切降解后再与AlCit反应,低剪切速率对其封堵性能影响较小,而高剪切速率会使得其封堵性能大大降低.HPAM/AlCit交联体系和HPAM剪切降解后形成的交联体系的封堵性能下降的原因是HPAM/AlCit交联体系中交联聚合物线团(LPC)尺寸和HPAM中高分子线团的尺寸变小.     

流变学方法测定共混物相图及其分辨尺度探讨

应用小振幅振荡剪切(SAOS)和小角激光散射(SALS)测定了苯乙烯-马来酸酐共聚物/聚甲基丙烯酸甲酯(SMA/PMMA)共混体系相分离温度,并分析了动态储能模量对频率响应的敏感程度以及不同测试方法在相分离判据方面的差别.认为前者是造成由不同的测试频率得到的相边界之间存在差异的原因,而SAOS与SALS得到的相边界不同则缘于后者;通过评估不同温度下分散相的尺度,发现选择合适的测试频率进行SAOS测试可以得到比SALS法更小的分辨尺度.     

聚合物二元体系动态力学性能的估算

动态热机械分析是多相聚合物体系的一个重要研究手段.分析动态力学性能可以研究共混高聚物的相容性、复合材料的界面特性以及高分子运动机理等.本文综述了聚合物二元体系,即填充、纤维增强、共混体系动态力学性能的估算方法.在填充体系中,分别概述有无界面作用两种情况,当存在界面作用时,界面作用越强,模量越大,阻尼越小.对纤维增强体系,讨论了玻璃纤维有无取向的情况下模量和阻尼的估算.特别对于聚合物二元共混体系,分"海-岛"结构和双连续相两种情况,分别讨论了模量与阻尼的估算.     

多肽自组装技术及其在生物医学上的应用

多肽分子自组装广泛存在于自然界中。多肽具有良好的生物相容性和可调控的降解性能,并且利用多肽自组装技术,可以在分子水平上设计并调控聚集态的形状和结构,这在生物医学材料方面具有巨大的应用潜力。近年来关于多肽自组装的研究成为材料学、医学等领域中研究热点之一,并且在药物缓释载体、组织工程支架研究方面取得进展。本文介绍多肽分子自组装技术的概念,综述了多肽自组装技术在药物缓释载体材料、组织工程支架材料方面的应用。     

新版《高分子化学》解读

旨在剖析祖仁教授主编的《高分子化学》第四版的教学思想和撰写特点,涉及章节、内容的选择和安排、逻辑思维和教学方法,以及一些技术术语等。同时也指出了新版教材的一些印刷错误等。     

反相微乳液法制备纳米Ag2S增感剂的化学增感研究

本文用反相微乳液法制备了纳米Ag₂S,并用作卤化银乳剂的硫增感剂,研究了其增感效果、增感规律及可能的增感机理.反相微乳液由异辛烷、表面活性剂AOT钠盐和水形成;制得的Ag₂S粒径3—5 nm;用制得颗粒增感卤化银乳剂,获得的感光性能优越于用Na₂S₂O₃水溶液增感;增感规律的研究表明,随着乳剂中纳米Ag₂S浓度的增加,模型乳剂感光度迅速提高、灰雾变化不大,并在100—200μmol/molAg左右获得最佳感光性能,进一步增加浓度则感光度呈下降趋势、灰雾升高;获得最佳感光性能所需的化学增感时间很短,约40分钟,之后感光度不再增加、灰雾上升;用漫反射光谱(DRS)作探针,跟踪记录增感时卤化银微晶表面上纳米Ag₂S增感剂颗粒的演变,为新型纳米增感剂的优异增感特性提供了机理性解释.     

模拟太阳光下稀土Gd掺杂了TiO2纳米晶的光催化性能研究

以甲基橙的光催化降解为探针反应,采用氙灯模拟自然条件下的太阳光,评价了通过酸催化的溶胶-凝胶法制备的稀土Gd掺杂改性TiO2纳米晶的光催化活性及对甲基橙水溶液TOC的去除效果.运用XRD和UV-Vis DRS表征技术考察了Gd掺杂对纳米TiO2的微晶尺寸、晶体结构与光学性能的影响.结果表明,Gd掺杂可以抑制TiO2由锐钛矿相向金红石相的转变,阻碍TiO2晶粒增长,使TiO2的光吸收带边发生蓝移且有利于对可见光的吸收,从而使Gd掺杂TiO2在模拟太阳光下光催化降解甲基橙的能力得到明显提高,但样品对甲基橙水溶液TOC的去除效果要滞后于其对色度的去除.     

可见光响应纳米TiO2光催化薄膜的研究进展

综述了近几年国内外可见光响应纳米TiO₂薄膜制备的研究现状,阐述了TiO₂薄膜光催化降解有机物的催化机理,系统地介绍了提高纳米TiO₂吸收波长的方法、常用载体、可见光响应纳米TiO₂薄膜制备方法和在降解有机物方面的应用,并概述了其以后的发展趋势.