磁控溅射技术制备ZnO透光薄膜

采用RF磁控溅射方法,在玻璃衬底上制备了择优取向的ZnO薄膜;通过台阶仪、X射线衍射技术、原子力显微镜和分光光度计分别测量了不同溅射功率条件下淀积的ZnO薄膜厚度(淀积速率)、结晶质量、表面形貌与粗糙度、透光光谱,报道了该薄膜结晶质量、薄膜粗糙度与其在可见光区透光率的关系.     

Interfacial structure and electrical properties of LaAlO3 gate dielectric films on Si by metalorganic chemical vapor deposition

LaAlO₃ (LAO) gate dielectric films were deposited on Si substrates by low-pressure metalorganic chemical vapor deposition. The interfacial structure and composition distribution were investigated by high-resolution transmission electron microscopy (HRTEM), X-ray photoelectron spectroscopy (XPS), secondary-ion mass spectroscopy (SIMS), and Auger-electron spectroscopy (AES). HRTEM confirms that there exists an interfacial layer between LAO and Si in most samples. AES, SIMS, and XPS analyses indicate that the interfacial layer is compositionally graded La–Al silicate and the Al element is severely deficient close to the Si surface. Electrical properties of LAO films were evaluated. No evident difference in electrical properties between samples with and without native SiO₂ layers was observed. The electrical properties are discussed in terms of LAO growth mechanisms, in relation to the interfacial structure. PACS 73.40.Qv; 81.15.Gh; 77.55.+f; 68.35.-p     

中物院远红外自由电子激光实验研究

中国工程物理研究院基于射频直线加速器技术的远红外自由电子激光(FIR-FEL)实验取得阶段性进展,于2005年3月24晚8时30分首次出光, 并多次重复. 中心波长115μm, 谱宽1%.介绍了实验系统的主要组成部分和主要实验结果.     

求解通信网节点间全部路由的逻辑代数化算法

经典的D IJKSTRA和BELLM AN-F LOYD通信网络路由算法,只能根据特定网络参数得到最佳路由,却无法获得网络存在的全部可用路由,而通信网理论研究及网络管理等方面,往往需要获得节点之间的全部可用路由.研究出一种路由新算法,遵循逻辑代数运算规则、采用关联矩阵中行与行之间整合与删除方式计算,N个节点的网络只需N-1次整合及删除运算,就能得到源节点到任意节点两点之间全部路由结果.详细论证了算法的正确性与合理性,简介了算法的并行运算可行性及与经典路由算法的兼容性等问题.通过算例详细说明算法的计算过程,并验证其正确性.     

新型噻吩基取代卟啉的合成及其荧光光谱研究

合成了两种新型噻吩基卟啉－5，15－二（2－噻吩基）－2，8，12，18－四乙基－3，7，13，17－四甲基卟啉7a（45．1％）和5，15－二（2－联噻吩基）－2，8，12，18－四乙基－3，7，13，17－四甲基卟啉7b(61.2%),并研究了它们的光谱性质，其中荧光光谱的最大发射峰蜂都在631nm处，量子产率分别为4．1％（7a)和1．4％（7b)。     

Isothermal crystallization kinetics of poly(3‐hydroxybutyrate)/layered double hydroxide nanocomposites

Poly(3‐hydroxybutyrate) (PHB)/layered double hydroxides (LDHs) nanocomposites were prepared by mixing PHB and poly(ethylene glycol) phosphonates (PEOPAs)‐modified LDH (PMLDH) in chloroform solution. Both X‐ray diffraction data and TEM micrographs of PHB/PMLDH nanocomposites indicate that the PMLDHs are randomly dispersed and exfoliated into the PHB matrix. In this study, the effect of PMLDH on the isothermal crystallization behavior of PHB was investigated using a differential scanning calorimeter (DSC) and polarized optical microscopy. Isothermal crystallization results of PHB/PMLDH nanocomposites show that the addition of 2 wt % PMLDH into PHB induced more heterogeneous nucleation in the crystallization significantly increasing the crystallization rate and reducing their activation energy. By adding more PMLDH into the PHB probably causes more steric hindrance of the diffusion of PHB, reducing the transportation ability of polymer chains during crystallization, thus increasing the activation energy. The correlation among crystallization kinetics, melting behavior and crystalline structure of PHB/PMLDH nanocomposites can also be discussed. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 3337–3347, 2006     

Influence of Yb-Doped Nanoporous TiO2 Films on Photovoltaic Performance of Dye-Sensitized Solar Cells

Yb-doped TiO2 pastes with different Yb/TiO2 weight ratios are prepared in the sol-gel process to obtain dyesensitized solar cells （DSCs）. The nanocrystalline size of Yb-TiO2 becomes smaller and the lattice parameters change. Lattice distortion is observed and dark current is detected. It is found that a part of Yb existing as insulating oxide Yb2O3 state acts as barrier layers at the electrode-electrolyte interface to suppress charge recombination. A Yb-doped TiO2 electrode applied in DSCs leads to a higher open-circuit voltage and a higher fill factor. How the Yb-doped TiO2 films affect the photovoltaic response of DSCs is discussed.     

阴极还原处理对多孔硅发光性能的影响

对经过阴极还原处理后的多孔硅样片进行了光致发光测试和稳定性测试.实验结果表明这种处理能明显改善多孔硅的发光稳定性,使其表面结构更加稳定.利用原子力显微镜对不同还原时间的多孔硅微结构及形貌进行了比较,在一定范围内随着还原时间的增长多孔硅表面粗糙度增大,PL谱增强.