Reductions in overshoot following intense sound exposures

Overshoot refers to the poorer detectability of brief signals presented soon after the onset of a masking noise compared to those presented after longer delays. In the present experiment, brief tonal signals were presented 2 or 190 ms following the onset of a broadband masker that was 200 ms in duration. These two conditions of signal delay were tested before and after a series of exposures to a tone intense enough to induce temporary threshold shift (TTS). The magnitude of the overshoot was reduced after the exposure when a TTS of at least 10 dB was induced, but not when smaller amounts of TTS were induced. The reduction in overshoot was due to a decrease in the masked thresholds with the 2-ms delay; masked thresholds with the 190-ms delay were not different pre- and post-exposure. The implication is that the mechanisms responsible for the normal overshoot effect are temporarily inactivated by the same stimulus manipulations that produce a mild exposure-induced hearing loss. Thus the result is the paradox that exposure to intense sounds can produce a loss of signal detectability in certain stimulus conditions and a simultaneous improvement in detectability in other stimulus conditions.     

Thermal and dielectric behaviors of poly(vinylidene fluoride-trifluoroethylene) copolymers at the curie transition

The thermal and dielectric behaviors of poly(vinylidene fluoride-trifluoroethylene) copolymers near the ferroelectric-to-paraelectric phase transition are investigated for samples with 20, 25, 30, and 40 mol% trifluoroethylene (TrFE). The data suggest that the transition becomes continuous for a particular composition near 50 mol% TrFE. Experimental data are sensitive to thermal history (kinetics of crystallization, and kinetics and cycling over the structural transition). It is found that several anomalies are present at the structural change, and in particular the 30 mol% TrFE sample shows the most marked anomalies. These phenomena can be attributed to defects, but another possibility would be the existence of an intemediate supplementary phase. Both hypotheses are discussed.     

Chemical analysis and distribution investigation of trace elements in indium matrix by spark source mass spectrometry

Summary High-purity indium was analysed by spark source mass spectrometry, using electrical and photoplate detection. For the calibration of the differences in elemental sensitivity, a standard sample was prepared in which 10 impurities were determined by graphite furnace atomic absorption spectrometry. In this way accuracies of less than 40% were obtained for relatively homogeneous elements at ppm and sub-ppm level. About 40 elements could be determined with detection limits of 10 to 30 ppb. Two pattern recognition methods, principal component analysis and clustering analysis, were applied to obtain information on trace element distribution, which indicated that a number of elements were strongly spatially correlated in the analysed sample.

---

Chemische Analyse und Verteilungsbestimmung von Spurenelementen in Indium-Matrix durch Funkenquellen-Massenspektrometrie

---

On leave from: Department of Chemistry, Nanjing Normal University, Nanjing, People's Republic of China     

Coagulation in lipid- and protein-containing systems

The behavior of real disperse systems with organic impurities was examined under conditions of destabilization by inorganic coagulants. A number of physicochemical methods of analysis and a simulation method were used to identify the character and type of the complexes formed and to calculate their stability constants.     

Electro-optic pulse response of ferroelectric liquid crystals

The electro-optic response of ferroelectric smectic C* liquid crystals has been studied. Anomalous switching behaviour of such materials which possess a negative dielectric anisotropy has been reported. These materials show a minimum in response time at a sufficiently high field. We present results showing the dependency of this minimum upon spontaneous polarisation and the effect of AC bias. Calculations based upon the equation of motion of the director around the cone are presented which describe this effect and its dependence on the relative magnitudes of the spontaneous polarization and dielectric anisotropy of the material. Good agreement with the experimental results is found.     

High Concentration Arsenic Diffusion in Crystalline Silicon: An Asymptotic Analysis

For fairly high concentrations, the effective arsenic diffusioncoefficient is known to grow linearly with the concentration.In this paper, we consider the strongly enhanced diffusion ofarsenic by asymptotic methods, and extend the results of a previouspaper (King & Please, 1987) in three ways: we characterizean additional (low-concentration) region; we consider the influenceof the initial data; and we consider the case of constant surfaceconcentration.     

Studies on calcium‐containing poly(urethane ether)s

The calcium salt of mono(hydroxyethoxyethyl)phthalate [Ca(HEEP)₂] was synthesized by the reaction of diethylene glycol, phthalic anhydride, and calcium acetate. Calcium‐containing poly(urethane ether)s (PUEs) were synthesized by the reaction of hexamethylene diisocyanate (HMDI) or tolylene 2,4‐diisocyanate (TDI) with a mixture of Ca(HEEP)₂ and poly(ethylene glycol) (PEG₃₀₀ or PEG₄₀₀) with di‐n‐butyltin dilaurate as a catalyst. A series of calcium‐containing PUEs of different compositions were synthesized with Ca(HEEP)₂/PEG₃₀₀ (or PEG₄₀₀)/diisocyanate (HMDI or TDI) molar ratios of 2:2:4, 3:1:4, and 1:3:4 so that the coating properties of the PUEs could be studied. Blank PUEs without calcium‐containing ionic diols were also prepared by the reaction of PEG₃₀₀ or PEG₄₀₀ with HMDI or TDI. The PUEs were well characterized by Fourier transform infrared, ¹H and ¹³C NMR, solid‐state cross‐polarity/magic‐angle‐spinning ¹³C NMR, viscosity, solubility, and X‐ray diffraction studies. The thermal properties of the polymers were also studied with thermogravimetric analysis and differential scanning calorimetry. The PUEs were applied as top coats on acrylic‐coated leather, and their physicomechanical properties were also studied. The coating properties of PUEs, such as the tensile strength, elongation at break, tear strength, water vapor permeability, flexing endurance, cold crack resistance, abrasion resistance, color fastness, and adhesive strength, were better than the standard values. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 2865–2878, 2003     

On existence and stability in the theory of swelling porous elastic soils

The aim of this paper is to introduce a new functional in thestudy of swelling porous elastic soils saturated by a fluid.This new functional is a useful tool; it allows us to provethe existence of solutions in the case of a compressible fluid.We also prove the stability of solutions and the exponentialdecay in the case of an incompressible fluid. We study as wellthe continuous dependence with respect to the initial time.