新的基于条纹投影轮廓测量的系统标定方法

提出一种新的光栅条纹投影轮廓测量术系统标定模型,新模型不要求投影装置和成像系统的光心连线与参考面平行、成像系统的光轴垂直于参考面及投影装置和成像系统的光轴相交。基于该模型得出了新的相位高度映射关系,其待定系数与成像点的坐标无关。实际测量中只需2个高度不同的标准块便可以求得待定系数。对4个标准块进行高度测量,得到的最大相对误差为0.6%。实验证明:该标定方法简单有效,提高了系统标定的可操作性和测量精度。     

基于彩色光栅投影的快速三维测量方法

 针对条纹投影术提取物体高度信息的问题,提出了一种新的基于彩色光栅投影的三维测量方法。对选取G分量为255,R,B分量各取0或255而组成的青、白、黄、绿四色遵循格雷码原理进行编码,然后将G分量作正弦调制形成投影光栅投向被测物体。提取采集到的光栅变形图中G分量,利用傅里叶变换方法得到其初始相位;同时对采集到图像中的R,B分量作阈值迭代分割而G分量自动赋值为255,综合三分量信息得到条纹颜色信息进而获取条纹的周期信息,从而展开相位。全过程仅需投影一幅彩色光栅图就能完成三维测量,实验结果表明该算法易于实现,在测量实时性和精确性上表现良好。     

大离轴量凹面取样镜的设计

根据系统的使用要求以及椭球面特有的成像性质,提出使用离轴椭球面来完成光束取样和完善成像的设计方式.利用设计输入,计算出镜面的初始结构参数,得到离轴椭球面的二次曲线方程,将计算结果带入光学设计软件ZEMAX中验证成像质量.结果表明:离轴椭球面不但将物点和像点分开,减小了系统的长度,而且在像点处成完善像,将离轴成像转换为轴上成像,使后续光斑成像系统的高质量成像易于实现.     

稀土钕-丙烯酸-草酸配合物的合成、表征及荧光性能

合成了钕-草酸-丙烯酸三元固体配合物。利用元素分析、红外光谱(FT-IR)、紫外-可见光谱(UV-Vis)、热重分析(TGA)和荧光光谱等手段研究了配合物的结构和性质。结果表明配合物的组成为[Nd(OOC—COO)(CH2CH—COO)].3H2O,热分析结果表明该配合物具有较好的热稳定性。荧光光谱表明配合物都具有较好的荧光特性,且发射谱线很窄,主发射峰为钕离子的4G5/2 2G7/2-4I9/2跃迁,表明合成的新型稀土配合物可用作光致发光材料。     

海洋-声学耦合过程初始温度误差传递与发展

针对海洋初始温度场误差到水声传播误差的传递以及随时间演变发展的问题,优化海洋-声学耦合模式,通过对比遥感数据,验证了模型的可靠性。在此基础上,采用在控制试验温度初始场上加扰动的方法进行传播损失全局误差发展和区域误差发展试验。结果表明,初始温度场全局扰动在经过5天繁殖后使传播损失误差达到饱和,且扰动分布结构和海洋运动规律基本保持一致;对于在黑潮流域设定的目标海区,其上游区域的初始扰动发展最快。该结论可为开展海洋声学适应性观测提供依据。     

分光光度法测定鱼翅中锗

本文用分光光度法测定鱼翅中的总锗量。结果表明 ,鱼翅中的总锗含量为 18.2 5— 2 2 .75 μg·g-1;回收率为 85 .8%— 93.2 %。     

VO2热致变色薄膜的结构和光电特性研究

用磁控溅射方法制备了VO₂热致变色薄膜.用X射线衍射、X射线光电子谱和原子力显微镜对薄膜的宏观及微观结构进行了分析，表明VO₂薄膜纯度高、相结构单一、结晶度好.薄膜的光透过率在2000nm处相变前后改变了42%，高/低温电阻率变化达到三个数量级以上.薄膜的光透过谱和相变过程中电学性质变化的研究与结构分析结果相一致. 关键词：     

Explosive cathode gyrotron experiments

Experiments have investigated the behavior of explosive emission cathode gyrotrons using cylindrically symmetric coaxial diodes with centrally located knife-edged cathode and conical anode. Voltage probes and current shunts were exploited to monitor the diode electrical behavior when driven by a 3 μs 1/e time Marx power supply (up to 150 kV). Temporal reference signals permitted comparison of the diode's electrical evolution with the simultaneously measured microwave output signal from the gyrotron. The microwave output pulse duration was found to depend on the diode gap spacing (in the range 16-27 mm), the cavity magnetic field (range 1.3-3.3 T) and the cathode material, the termination being caused by the decay of the accelerating potential across the diode and the disruption of the diode geometry. The ratios of the cathode flare expansion velocities for graphite, copper and stainless steel cathodes were estimated as (1:(1.3±0.2):(2.2±0.5)) with a corresponding change in the duration of the microwave output signal [((590±17):(414±25):(325±10)) ns at 2.6 T]. Preliminary results are reported of recent experiments which have compared the optical emissions from the diode region during pulsed gyrotron operation with the simultaneously recorded diode electrical behavior and the gyrotron microwave output     

Effect of spatial patterns on population size

We investigate the role of the spatial pattern and temporal dynamics on the population properties of a diffusive Gause–Lotka–Volterra system. The average total population size is insensitive to the temporal dynamics, whereas a significant decrease of the population size can be found as the spatial diffusion effect is increased, implying that the spatial pattern plays an important role. At large diffusion coefficients, a saturation of the spatial pattern variation is observed, which can be understood by a spatial scaling analysis of the system. The existence of multiple attractors can also indicate that spatial patterns play a more important role than temporal dynamics in dominating the population size.