Determination of aristolochic acid by capillary zone electrophoresis

A simple and rapid capillary zone electrophoresis (CZE) method for the determination of aristolochic acid (AA) in dietary supplements and selected herbs is described. A clear separation of AA from other sample constituents was achieved within 5 minutes without any sample clean up. A mixture of 20 mM-morpholinethanesulphonic acid+10 mM-BisTrisPropane+0.2% hydroxyethylcelullose in 10% methanol serves as a background electrolyte. The linearity, accuracy, intra-assay and detection limit of the developed method are 200–6000 ng/mL, 95–103%, 3.5%, and 50 ng/ml, respectively. Ease of use, sufficient sensitivity and low running cost are the most important attributes of the CZE method. The proposed CZE method was compared with HPLC.     

An experimental and theoretical study of the Cp2VO2CO: use of 13CO3(2-) for structure investigation of d1-metallocene complexes

EPR study has shown that the anticancer agent vanadocene dichloride (Cp2VCl2) interacts with carbonate contained in physiological solutions. Chelate complex Cp2VO2CO (|A(iso)(51V)| = 175.1 MHz, g(iso) = 1.9861) is the only paramagnetic species formed in the range about the physiological pH (5.5-11.0). The super-hyperfine coupling (|a(iso)(13C)| = 24.1 MHz) was evidenced at measurements using 13C labelled carbonate. The structure of carbonate complex was validated by comparison of observed and theoretical calculated HFC tensors (at the density functional level of theory).     

Determination of pesticides in waters by capillary gas chromatography with atomic emission detection

Capillary gas chromatography with atomic emission detection (GC-AED) was successfully used to separate and quantify 14 pesticides (organochlorines, organophosphorus compounds and pyrethrins) in water samples after liquid-liquid extraction with ethyl acetate. Monitoring the emission lines for elements such as chlorine, bromine and sulfur ensures nearly specific chromatograms for these elements, and markedly increases selectivity. Calibration curves were obtained by plotting peak area versus concentration and the correlation coefficients relating to linearity were at least 0.999. Each chromatographic separation takes 21 min and, since two injections are necessary, it requires approximately 1 h to analyze one sample. The method shows a precision of 4.3-8.2% (RSD), depending on the compound. The application of liquid-liquid extraction with ethyl acetate led to recoveries from spiked samples ranging from 76 to 113%. The sensitivity and linearity for the elements chlorine, sulfur, nitrogen and phosphorus were checked under the optimized conditions at their customary emission wavelength. The sensitivity and linearity for these compounds decreased in the order (atom and emission wavelength) Cl (479 nm)>S (181 nm)>P (178 nm)>N (174 nm). A study of the GC-AED system's response to chlorine concentration in eight pesticide molecules was performed and a linear relationship was found with a correlation coefficient of 0.987.     

Direct solid sample analysis of geological samples with SS-GF-AAS and use of 3D calibration

These results from direct solid-sample trace-element analysis, with 3D calibration, follow those of earlier publications. Cd, Cr, Cu, Ni, Pb, and Zn have been determined in complex inorganic powder samples, e.g. sediments, soils, rocks, and minerals. The measurements were performed with two SS-GF-AAS spectrometers which differ in the type of graphite furnace (transverse and longitudinal tube) and the background-correction technique (with and without the Zeeman system). The performance of the 3D calibration method was optimized by systematic investigation and the 2D- and 3D calibration techniques were compared. Another feature is the determination of confidence limits of the 3D calibration. This calibration error was calculated by the statistical bootstrap method. The results of calibration experiments and the precision and accuracy of the determination of trace elements in CRMs show that 3D calibration becomes increasingly essential as the refractory character of the analyte increases. Although there are large differences between the state of development and technical performance of the instruments used, 3D-calibration works with both SS-GF-AAS spectrometers.     

Immunoaffinity isolation of CEACAM1 on hydrazide-derivatized cellulose with immobilized monoclonal anti-CEA antibody

Carcinoembryonic cell adhesion molecule 1 (CEACAM1) is a human membrane glycoprotein belonging to the carcinoembryonic antigen (CEA) family and to the immunoglobulin superfamily. It is expressed in apical membranes of many epithelial cells in gastrointestinal and urogenital tract and also in granulocytes and lymphocytes, and its biological effect in human tissues has recently been discussed in literature. The purpose of this study was to isolate CEACAM1 glycoprotein from bile and characterize its purity and recovery which has not been described before. Affinity chromatography of CEACAM1 on hydrazide-activated cellulose with immobilized monoclonal anti-CEA F34-187 antibody is described. The immunoglobulin carbohydrate moiety was oxidized by periodate and then bound to hydrazide-activated matrix. Crude protein fraction from bile was applied on the affinity column and after extensive washing of non-bound proteins CEACAM1 was eluted with 6 M guanidine-HCl. A single immunopositive 85 kDa band was detected on Western blots with anti-CEA antibody after SDS-PAGE. We found out that CEACAM1 was not stainable with any common method of protein staining and the only non-specific method which could detect the 85 kDa band was a lectin staining.     

Parallelization of three-center electron repulsion integrals

The parallelization of the three-center electron repulsion integrals arising from the variational fitting of the Coulomb potential is presented. A scheme for dynamical load balancing of the corresponding loop structure is discussed. The implementation in the density functional theory program deMon using the message passing interface is described. The efficiency of the parallelization is analyzed by selected benchmark calculations     

Stability of Suspensions of Bioactive Particles Using Hybrid Organic–Inorganic Solutions as Dispersing Media

Functional coatings incorporating different types of particles developed by the sol–gel method have been proposed in the last few years for diverse applications. This work focuses on the preparation of homogeneous coatings prepared from stable suspensions with 10 wt% of glass and glass ceramic particles in a hybrid organic–inorganic solution as dispersing media. For this purpose, the pH was shifted up to 6–7 by adding tetrapropylammonium hydroxide (TPAH) which behaves as a cationic surfactant being probably adsorbed on the particles surface, while the sol maintains stable. Rheological measurements were performed to study the stability of the suspensions prepared at different conditions such as the kind and concentration of dispersant and the pH conditions. After sintering at 450^∘C/30 min, coatings around 2 μ m in thickness were obtained.     

Characterization of three agave species by gas chromatography and solid-phase microextraction-gas chromatography-mass spectrometry

Steam distillation (SD) extraction-solid-phase microextraction coupled to GC-MS was developed for the determination of terpenes and Bligh-Dyer extraction-derivatization coupled with GC for the determination of fatty acids such as ethyl esters were used. It was found that the three different Agave species have the same profile of fatty acids; the quantity of these compounds is different in each Agave variety. On the other hand, different terpenes were identified in the three Agave plants studied: nine in A. salmiana, eight in A. angustifolia and 32 in A. tequilana Weber var. azul.     

Heterogeneous oxidation of pyrimidine and alkyl thioethers in ionic liquids over mesoporous Ti or Ti/Ge catalysts

Heterogeneous catalytic oxidation of a series of thioethers (2-thiomethylpyrimidine, 2-thiomethyl-4,6-dimethyl-pyrimidine, 2-thiobenzylpyrimidine, 2-thiobenzyl-4,6-dimethylpyrimidine, thioanisole, and n-heptyl methyl sulfide) was performed in ionic liquids by using MCM-41 and UVM-type mesoporous catalysts containing Ti, or Ti and Ge. A range of triflate, tetrafluoroborate, trifluoroacetate, lactate and bis(trifluoromethanesulfonyl)imide-based ionic liquids were used. The oxidations were carried out by using anhydrous hydrogen peroxide or the urea-hydrogen peroxide adduct and showed that ionic liquids are very effective solvents, achieving greater reactivity and selectivity than reactions performed in dioxane. The effects of halide and acid impurities on the reactions were also investigated. Recycling experiments on catalysts were carried out in order to evaluate Ti leaching and its effect on activity and selectivity.     

Ca(2.5)Sr(0.5)GaMn2O8: diamagnetic Ga in control of the structural and electronic properties of a bilayered manganate

The temperature dependence of the crystal structure and electronic properties of brownmillerite-like Ca(2.5)Sr(0.5)GaMn(2)O(8) has been studied by neutron powder diffraction and muSR spectroscopy. The results show that short-range 2D magnetic order begins to develop within the perovskite-like bilayers of MnO(6) octahedra approximately 50 K above the 3D Néel temperature of approximately 150 K. The bilayers show a structural response to the onset of magnetism throughout this temperature range whereas the GaO(4) layers that separate the bilayers only respond below the 3D ordering temperature. XANES spectroscopy shows that the sample contains Mn(3+) and Mn(4+) cations in a 1:1 ratio, and the behavior in the region of the Néel transition is interpreted as a local charge ordering. Electron diffraction and high-resolution electron microscopy have been used to show that the local microstructure is more complex than the average structure revealed by neutron diffraction, and that microdomains exist in which the GaO(4) tetrahedra show different orientations. It is argued that the bonding requirements of diamagnetic gallium control the electronic behavior within the perovskite-like bilayers.