Mechanism and Kinetics of Thermal Dissociation of Inclusion Complex of Benzaldehyde with β-Cyclodextrin

The inclusion complex of benzaldehyde (BA) with β-cyclodextrin (β-CD) was prepared and was studied by thermal analysis and X-ray diffractometry. The composition of the complex was identified by TG and elemental analysis as β-CD·BA·9H₂O. TG and DSC studies showed that the thermal dissociation of β-CD·BA·9H₂O took place in three stages: dehydration in the range 70-120°C; dissociation of β-CD·BA in the range 235-270°C; and decomposition of β-CD above 280°C. The kinetics of dissociation of β-CD·BA in flowing dry nitrogen was studied by means of TG both at constant temperature and at linearly increasing temperature. The results showed that the dissociation of β-CD·BA was dominated by a one-dimensional random nucleation and subsequent growth process (A₂). The activation energy E was 124. 8 kJ mol^-1, and the pre-exponential factor A 5.04·10¹¹ min^-1. This revised version was published online in July 2006 with corrections to the Cover Date.     

芥子气模拟剂2-氯乙基乙基硫醚的光催化降解

利用连续流动微反、原位红外和GC/MS等手段考察了芥子气模拟剂2-氯乙基乙基硫醚（2-CEES）在P25 TiO2上的光催化降解反应,证实CO2和H2O是这个反应的最终产物.详细的跟踪分析表明,除了CO2和H2O外,在反应的气相混合物中可检测到C2H4、CH3CHO、CH4、CO、HCl和H2S；少量小分子的羧酸、醚和砜；微量C2H5SC2H5、C2H5S2C2H5、C2H5SC2H4Cl和CH2ClCH2Cl等中间产物;在反应后的催化剂表面可检测到C2H5S2C2H5、C2H5SC2H4OH、C4H9S2C2H5和C2H5S2C2H4OH、等物.根据这些结果提出了2-CEES光催化降解的反应机理,推断2-CEES的光催化降解涉及脱氯、C－S键断裂、有机硫化物光聚合和裂解等复杂过程最终转化为CO2和H2O.认为各种硫物种在表面的积聚引起了催化剂的缓慢失活.     

环氧丙烯酸酯的紫外光固化

制备了适于配制紫外光固化涂料的环氧丙烯酸酯，研究了反应温度、阻聚剂、催化剂等因素对环氧树脂与丙烯酸反应的影响；讨论了反应机理和动力学；并利用红外光谱观察了产物的紫外光固化行为。季铵盐能有效地催化环氧树脂和丙烯酸的反应，当其用量为０．６％～１．２％时，在９０～１１０℃反应４．５～８小时后，环氧基转化率大于９７％。由此配制的光固化涂料经紫外光辐照能快速固化。     

Hydrogen bonded layer-by-layer assembly of poly(2-vinylpyridine) and poly(acrylic acid): Influence of molecular weight on the formation of microporous film by post-base treatment

This article describes the buildup of hydrogen bonded multilayer film of poly(2-vinylpyridine) (P2VP) and poly(acrylic acid) (PAA), and the influence of polymer molecular weight on the formation of microporous film by post-base treatment. The formation of a microporous film involved a two-step mechanism: the release of PAA from P2VP/PAA multilayer, and the reorganization of the remaining P2VP on the substrate. Fourier transform infrared spectroscopy (FT-IR) indicated that the release of PAA from hydrogen bonded multilayer was a rapid process, which was almost independent of the molecular weight of PAA. Furthermore, the molecular weight of P2VP had a great effect on micropore formation by immersing the P2VP/PAA multilayer in basic solution. The rate of micropore formation increased with increasing molecular weight. We anticipate that a comparative study on P2VP/PAA films containing high or low molecular weight polymer provides a way to control the surface morphology, and will be helpful and constructive for the forthcoming discussion about the formation of the microporous film.     

Two Novel Alkaloids from Zanthoxylum nitidum

Two novel alkaloids, 4,5‐dihydroxy‐1‐methyl‐3‐oxo‐2‐(trichloromethyl)‐3H‐indolium chloride ( 1 ) and 4‐(2‐methoxyethyl)‐N,N‐dimethylbenzenamine ( 2 ), were isolated from the EtOH extract of the roots of Zanthoxylum nitidum. Their structures were identified on the basis of spectroscopic and mass‐spectrometric analyses.     

三核钨钼簇合物对苯乙烯氧化反应的催化

关于烯烃的催化氧化,报道较多。Takao等研究了苯乙烯在Ir和Rh络合物存在下的氧化反应;Collman曾报道环己烯在Vaska络合物[IrX(CO)(PPh_3)_2]催化下氧化成环己酮和环已烯氧化物。本文采用Cotton合成的簇合物[W_3O_2(CH_3CO_2)_6(H_2O)_3]Br_2·     

Heat transfer from a rarefied plasma flow to a metallic or nonmetallic particle

Heat transfer from a plasma flow to a metallic or nonmetallic spherical particle is studied in this paper for the extreme case of free-molecule flow regime. Analytical expressions are derived for the heat flux due to, respectively, atoms, ions, and electrons and for the floating potential on the sphere exposed to a two-temperature plasma flow. It has been shown that the local or average heat flux density over the whole sphere is independent of the sphere radius and approximately in direct proportion to the gas pressure. The presence of a macroscopic relative velocity between the plasma and the sphere causes substantially nonuniform distributions of the local heat flux and enhances the total heat flux to the sphere. The heat flux is also enhanced by the gas ionization. Appreciable difference between metallic and nonmetallic spheres is found in the distributions along the oncoming flow direction of the floating potential and of the local heat flux densities due to ions and electrons. The total heat flux to the whole sphere is, however, almost the same for these different spheres. For a fixed value of the electron temperature, the heat flux decreases with increasing temperature ratio T_e/T_h.     

Interactions of hemoglobin with lecithin liposomes

In this paper, the interaction of hemoglobin (Hb) with lecithin liposomes is studied by UV-vis spectroscopy, fluorescent spectroscopy, and transmission electron microscopy. The adsorption of Hb on liposomes is likely to be related to the hydrophobic interaction between Hb and liposomes, which brings about the increase of the microenvironmental polarity (I ₁/I ₃) and the decrease of the fluorescence polarization (P) of lecithin liposomes. These results are considered to be that the adsorption of Hb on liposomes makes the spaces between the lecithin molecules increase, and a temporary gap is consequently formed in the liposomal bilayer membranes. The leakage of aqueous-space marker from the liposomes is increased with the addition of Hb.     

红外光谱法研究LB膜中的分子取向

The structure information of orientation and packing of molecular chains can be obtained from infrared transmission and reflection-absorbance (RA) spectra. In the present paper, on the basis of Umemura et al., their FORTRAN program of minicomputer was developed and can be run on 486 personal computer. By comparison of infrared transmission and RA intensities, surface enhancement factors and molecular orientation angle were calculated using the above program, and the influence of complex refractive index, angle of incidence, and thickness of LB film were discussed. These results are consistent with that of Umemura et al.