Analysis and optimization of a new photonic crystal filters in near ultraviolet band

Transmission characteristics of one-dimensional (1D) photonic crystals (PCs) heterostructures containing defective are studied using the transfer matrix method. The key is to search the best combination style for different 1D PCs to form heterostructures. It is shown that the non-transmission range over near ultraviolet and visible range can be substantially enlarged and the phenomenon of narrow band PC filter in near ultraviolet can be realized by adjusting the repeat cycle counts of various photonic crystals. The theoretical results on multiple heterostructures containing TiO₂/SiO₂ multilayer films are presented. With a perfect omni-directional and high peak transmission filters for TE modes, this structure opens a promising way to fabricate ultra-narrow band PC filters with wide non-transmission range in near ultraviolet and visible range.     

Surface modification of Mg2B2O5 whisker and its effect on the mechanical properties and thermostability of polycarbonate/Mg2B2O5w composites

The Mg₂B₂O₅ whiskers (Mg₂B₂O₅w) were modified by boric acid ester (BE) coupling agent and used to prepare polycarbonate (PC) composites. Surface wettability test and evaluation of dispersibility of BE-modified Mg₂B₂O₅w (BE-Mg₂B₂O₅w) in n-heptane were carried out by water contact angle measurement and polarizing microscopy, respectively. The surface chemical characteristics of BE-Mg₂B₂O₅w and estimation of the amount of tightly bonded organic modifier were examined by Fourier transform infrared spectrometry (FT-IR) and thermogravimetric analysis (TGA), respectively. The influence of BE-Mg₂B₂O₅w on the mechanical property, morphology and thermostability of PC composites was investigated by using universal testing machine, scanning electron microscopy (SEM), dynamic mechanical analysis (DMA) and TGA, respectively. It was found that BE was successfully grafted to the surface of Mg₂B₂O₅w, and the hydrophobic BE-Mg₂B₂O₅w leads to high ratio of adhesion work to interfacial tension between PC and BE-Mg₂B₂O₅w, and its better dispersibility in n-heptane. Furthermore, the incorporation of BE-Mg₂B₂O₅w into PC matrix resulted in higher tensile properties of PC/BE-Mg₂B₂O₅w than that of PC/Mg₂B₂O₅w composites and lower maximum weight loss rate than that of PC. The storage modulus of the PC/Mg₂B₂O₅w composites increased obviously as a function of whisker content, especially for the composites with BE-Mg₂B₂O₅w, but the T_g value changed little.     

Adsorption and manipulation of carbon onions on highly oriented pyrolytic graphite studied with atomic force microscopy

Carbon onions produced by DC arc discharge method were deposited on highly oriented pyrolytic graphite (HOPG) surface and their adsorption and manipulation was studied using an atomic force microscopy (AFM). Well-dispersed adsorption of carbon onions on HOPG surface was obtained and aggregations of onions were not observed. The van der Waals interaction between the onion and HOPG surface and that between two onions, were calculated and discussed using Hamaker's theory. The manipulation of adsorbed onions on HOPG surface was realized using the AFM in both the raster mode and the vector mode. The controllability and precision of two manipulation modes were compared and the vector mode manipulation was found superior, and is a useful technique for the construction of nano-scale devices based on carbon onions.     

The stability of Bose--Einstein condensates in a two-dimensional shallow trap

The stability of Bose--Einstein condensates (BECs) loaded into a two-dimensional shallow harmonic potential well is studied. By using the variational method, the ground state properties for interacting BECs in the shallow trap are discussed. It is shown that the possible stable bound state can exist. The depth of the shallow well plays an important role in stabilizing the BECs. The stability of BECs in the shallow trap with the periodic modulating of atom interaction by using the Feshbach resonance is also discussed. The results show that the collapse and diffusion of BECs in a shallow trap can be controlled by the temporal modulation of the scattering length.     

CoPt(FePt)-C纳米复合膜的结构与磁性

用磁过滤脉冲真空电弧沉积方法制备了CoPt(FePt) C纳米复合薄膜，并在不同温度下进行了退火处理，研究了薄膜中碳的含量以及退火温度对薄膜结构与磁性能的影响.制备态薄膜经过足够高的温度退火后，x射线衍射和磁力显微镜分析发现，在碳基质中生成了面心四方相的CoPt(FePt)纳米颗粒.对于特定组分为Co24Pt31C45和Fe43Pt35C22的薄膜，矫顽力以及颗粒尺寸都随退火温度的升高而增大，当退火温度为700℃时，Co24Pt31C45薄膜的矫顽力为21×105A/m，晶粒尺寸为17nm;当退火温度为650℃时，Fe43Pt35C22相应值分别为28×105A/m和105nm. 关键词： 磁记录材料 磁性薄膜 CoPt FePt纳米复合薄膜     

X-ray observations of tungsten wire array Z-pinch implosions on QiangGuang-1 facility

Z-pinch experiments with two arrays consisting, respectively, of 32 4-μm- and 6-μm-diameter tungsten wires have been carried out on QiangGuang-1 facility with a current rising up to 1.5MA in 80ns. At early time of implosion, x-ray framing images show that the initial emission comes from the central part of arrays, and double clear emission rings, drifting to the anode and the cathode at 5×10⁶cm/s and 2.4×10⁷cm/s respectively, are often produced near the electrodes. Later, in a 4-μm-diameter tungsten wire array, filamentation caused by ohmic heating is prominent, and more than ten filaments have been observed. A radial inward shift of arrays starts at about 30\,ns earlier than the occurrence of the x-ray peak power for both kinds of arrays, and the shrinkage rate of emission region is as high as 1.7×10⁷cm/s in a 4-μm-diameter tungsten wire array, which is two times higher than that in a 6-μm one. Emission from precursor plasmas is observed in implosion of 6-μm-diameter tungsten wire arrays, but not in implosion of a 4-μm-diameter tungsten wire array. Whereas, in a 4-μm-diameter tungsten wire array, the soft x-ray emission shows the growth of m=1 instability in the plasma column, which is caused by current. The reasons for the discrepancy between implosions of 4-μm- and 6-μm-diameter tungsten wire arrays are explained.     

基于ROI编码的干涉超光谱图像近无损压缩

针对干涉超光谱成像仪所成图像的特点,提出了一种基于ROI（Region of Interest,感兴趣区域）编码的干涉超光谱图像序列压缩方法.利用帧内差值变换,结合矩形ROI编码,在提高遥感图像压缩比的同时,使压缩后的重建图像质量达到近无损的技术要求.实验结果表明,这种压缩方法在干涉超光谱图像压缩中当相对光谱二次误差为2.04％时,干涉图像的压缩比达到9.66∶1.     

Temperature Dependence of the Mössbauer Effect on Prussian Blue Nanowires

Highly ordered Prussian blue nanowires with diameter of about 50 nm and length up to 4 m have been fabricated by an electrodepositing technology with two-step anodizing anodic aluminum oxide films. The Mössbauer spectra taken between 15 and 300 K indicate that the hyperfine parameters decrease as the temperature increases. The temperature dependence of the quadrupole splitting, the isomer shift and the spectra area are discussed. A decrease of Debye temperature for Prussian blue nanowires was found with respect to that of Prussian blue bulk.     

第Ⅰ种非对称两态叠加多模叠加态光场的偶数阶等阶N次方Y压缩

本文利用多模压缩态理论,研究了第Ⅰ种非对称两态叠加多模叠加态光场|Ψ_Ⅰ^(ab)Ⅰ>_q的偶数阶等阶N次方Y压缩特性.结果发现:在压缩阶数N取偶数情况下,只要构成态|Ψ_Ⅰ^(ab)Ⅰ>_q的两个量子光场态的强度(即平均光子数)不相等,则当各模的初始相位φ_j^(a)、φ_j^(b)(j＝1,2,3,…,q)、态间的初始相位差(θ_pq^(bI)-θ_nq^(aR))以及与上述的两个量子光场态相对应的各单模相干态光场的光子干涉项之和 ＝[R_j^(a)R_j^(b)cos(φ_j^(a)-φ_j^(b))]等满足一定条件时,态|Ψ_Ⅰ^(ab)Ⅰ>_q可呈现出周期性变化的、任意偶数阶的等阶N次方Y压缩效应.这一结果与现有文献报道的结果截然不同.     

基于CdSe/ZnS量子点光转化层的高稳定性白光LED器件

采用一步法合成了510,550和630 nm三种峰值的高稳定性、高量子效率核壳结构CdSe/ZnS量子点材料,其量子产率分别达到82%,98%,97%。将该量子点材料取代传统的荧光粉材料,与硅胶均匀混合后作为光转换层涂覆到蓝色InGaN LED芯片上,制备了白光LED器件。通过依次添加不同颜色量子点制备的量子点光转换层,考察了510,550和630 nm三色CdSe/ZnS量子点在硅胶中的不同配比对白光LED器件性能的影响,研究了不同颜色量子点之间的能量转换机制,利用量子点对白光光谱及其色坐标的影响机制,得到优化的白光器件结果及其三色量子点的配比,结果表明,当绿色、黄绿色、红色三种量子点之间的配比为24∶7∶10时,得到高稳定性、高效率的正白光器件特性,在电流20～200 mA范围内,色温变化为4 607～5 920 K,色坐标变化为（0.355 1,0.348 3）～（0.323 4,0.336 1）,显色指数变化为77.6～84.2,器件最高功率效率达到31.69 lm W-1@20 mA。另外,为了进一步考察器件性能稳定的原因,研究了时间、温度以及UV处理对CdSe/ZnS QDs/硅胶混合光转换材料稳定性的影响,结果表明,器件的高稳定性可归因于所采用的一步法合成的核壳结构量子点材料本身的稳定性,研究的优化器件结果是一种低能耗的优质白光光源,可使人们真实地感知物体的原貌,在正白光光源领域具有很好的应用前景。