Influence of the weakly interacting light U boson on the properties of massive protoneutron stars

Considering the octet baryons in relativistic mean field theory and selecting entropy per baryon S=l,we calculate and discuss the influence of U bosons on the equation of state,mass-radius,moment of inertia and gravitational redshift of massive protoneutron stars(PNSs).The effective coupling constant gu of U bosons and nucleons is selected from 0 to 70 GeV~(-2).The results indicate that U bosons will stiffen the equation of state(EOS).The influence of U bosons on the pressure is more obvious at low density than high density,while the influence of U bosons on the energy density is more obvious at high density than low density.The U bosons play a significant role in increasing the maximum mass and radius of PNS.When the value of gu changes from 0 to 70 GeV~(-2),the maximum mass of a massive PNS increases from 2.11M_⊙ to 2.58M_⊙,and the radius of a PNS corresponding to PSR J0348+0432 increases from 13.71 km to 24.35 km.The U bosons will increase the moment of inertia and decrease the gravitational redshift of a PNS.For the PNS of the massive PSR J0348+0432,the radius and moment of inertia vary directly with gu,and the gravitational redshift varies approximately inversely with gu.     

高功率LED热特性测试方法研究与应用

叙述了利用动态电学测试方法测量高功率LED热阻和结温的原理、试验装置、测量步骤和影响测试结果的因素.研究结果表明,该方法具有测试结构简单、稳定性高等特点,可作为高功率LED热阻和结温的一种测试方法.     

Continuous‐scan capability at SSRL and applications to X‐ray diffraction

Typical X‐ray diffraction measurements are made by moving a detector to discrete positions in space and then measuring the signal at each stationary position. This step‐scanning method can be time‐consuming, and may induce vibrations in the measurement system when the motors are accelerated and decelerated at each position. Furthermore, diffraction information between the data points may be missed unless a fine step‐scanning is used, which further increases the total measurement time. To utilize beam time efficiently, the motor acceleration and deceleration time should be minimized, and the signal‐to‐noise ratio should be maximized. To accomplish this, an integrated continuous‐scan system was developed at the Stanford Synchrotron Radiation Lightsource (SSRL). The continuous‐scan system uses an in‐house integrated motor controller system and counter/timer electronics. SPEC software is used to control both the hardware and data acquisition systems. The time efficiency and repeatability of the continuous‐scan system were tested using X‐ray diffraction from a ZnO powder and compared with the step‐scan technique. Advantages and limitations of the continuous‐scan system and a demonstration of variable‐velocity continuous scan are discussed.     

大功率高温超导滤波器的设计与功率测试

本文在双面YBCO高温超导薄膜上设计并制备了两节大功率超导滤波器,根据滤波器功率承载能力与最大电流密度之间的关系,减小电流密度和分散电流密度的分布是提高功率承载能力的关键.本文采用增加超导谐振器尺寸、优化几何结构及改进馈线耦合方式的方法,设计了两节2 GHz频段梭型谐振器结构的滤波器.设计及测量结果显示了馈线结构及谐振器几何尺寸优化程度对超导滤波器功率承载能力有不同程度的影响,说明了在大功率超导滤波器设计中应选用无结点间隙耦合式馈线以抑制电流密度的聚集.采用优化后的谐振器结构制备的梭型两节超导滤波器经测试功率承载能力为2 W.超导滤波器的尺寸为25×12 mm LaAlO3基片,中心频率2.022 GHz,相对带宽为2.4%.同时给出了超导滤波器功率测试的结构和方法.     

Creation of helical vortices during magnetization of aligned carbon nanotubes filled with Fe: theory and experiment

We report a novel magnetic phenomenon consisting of the formation of helical spin configurations during the magnetization of densely packed ferromagnetic nanowires encapsulated inside carbon nanotubes. We studied the hysteresis loops when the magnetic fields are applied parallel and perpendicular to the nanotubes axes. We also performed theoretical calculations on aligned nanowire arrays that clearly indicate the creation of helical spin vortices in the hysteresis loops. The latter are caused by the presence of strong dipolar interactions among neighboring wires.     

高温超导滤波器的光刻工艺

根据高温超导薄膜的特点,详细讨论了制备高温超导滤波器的光刻技术及在制备的各环节中需注意的问题,实验结果表明:此种方法提高了制备的成功率。     

电流模式SEPIC变换器倍周期分岔现象研究

以SEPIC变换器中前置电感电流为控制对象,建立了SEPIC变换器断续电流模式下的离散时间模型, 并分析了不动点的稳定性.通过相轨图、功率谱图以及分岔图, 发现电路中存在一种特殊的倍周期分岔现象——电路的运行状态经历了1倍周期、 2倍周期、4倍周期再到2倍周期、4倍周期,最终进入混沌状态.实验结果与仿真结果相一致, 证实了SEPIC变换器在断续电流模式下存在这种倍周期分岔现象.     

高温超导滤波器两种刻蚀方法的研究

在高温超导滤波器的制备过程中,针对所使用的高温超导薄膜的特点,采用了两种刻蚀方法——湿化学刻蚀法和离子束刻蚀法,设计对比了两种刻蚀的制作流程及其优缺点,并用两种方法分别制备了高温超导滤波器,对微波特性做了对比分析。得出离子束刻蚀对超导薄膜的性能影响要小一些,用此方法制备的高温超导滤波器具有更好的微波特性。