碳酸二苯酯中微量杂质的高效液相色谱分析

碳酸二苯酯和双酚A产生酯交换和缩聚反应,制得聚碳酸酯.聚碳酸酯耐压、透明性好,在机械制造、电子电器、军事及照明工业.安全与医疗器械等许多方面有着广泛的用途,是一种性能优良的工程塑料.聚碳酸酯的色泽与许多因素有关.由于原料碳酸二苯酯在制造过程中,一些沸点与之相近的杂质极易残留在产品里.要想得到高质量的聚碳酸酯,必须使其每一种杂质含量控制在100μg/g以下.至今未见报道同时检测碳酸二苯酯中3种微量杂质的分析方法.因此,本文结合单位工艺研究建立了一种用液相色谱进行分析的方法.     

不同干燥过程对超细TiO2粉体性质的影响

考察了采用不同干燥工艺制备的TiO2粉体在粒子形貌、颗粒大小与分布、晶相组成以及比表面积和孔结构等织构和结构性质方面的差异。结果表明，利用常规的干燥方法，由水凝胶脱水所得的颗粒，颗粒间严重团聚，颗粒粒径大且分布不均匀，比表面积和孔体积最小；由醇凝胶直接脱水，则可以显著提高粉体的织构性能．而采用超临界流体干燥法则可以进一步提高粉体的性能，比表面积由水凝胶的4．88m2·g－1增大到113．8m2·g－1，提高了近30倍；孔体积由0．027cm3·g－1增大到0．41cm3·g-1．大约提高了15倍；而且其能够有效地防止粒子间的团聚，较好地保持了湿凝胶的网络结构，使颗粒尺寸降低且分布均匀，可重复性好．     

负载型非晶态Cu/SiO2催化剂的非晶性质

以超细ＳｉＯ２为载体，用ＫＢＨ４还原Ｃｕ＾２＋盐溶液制备了非负载型Ｃｕ和负载型Ｃｕ／ＳｉＯ２催化剂，ＸＲＤ，ＴＥＭ和电子衍射分析结果表明，负载型Ｃｕ／ＳｉＯ２为完全非晶态，而非负载型Ｃｕ中存在着少量晶态Ｃｕ，ＤＳＣ结果表明，非晶态Ｃｕ／ＳｉＯ２的热稳定性明显高于非负载型Ｃｕ，说明超细ＳｉＯ２具有稳定非晶结构的作用，ＸＰＳ结果表明，还原产物中的铜原子呈Ｃｕ状态，ＩＣＰ分析结果表明，样品中的Ｂ含量均低     

稀土催化丁二烯顺式聚合过程中的环化改性

采用ＮｄＣｌ３·３ｉ－ＰｒＯＨ－ＡｌＥｔ３稀土催化剂进行丁二烯的顺式聚合，在聚合过程中引入烯丙基氯，进行分子内环化反应以及单体的环聚反应．考察了稀土催化剂用量、ｎ（烯丙基氯）／ｎ（ＡｌＥｔ３）、环化时间、反应温度、单体浓度等对环化反应的影响，并对产物进行了红外光谱、核磁共振光谱的表征     

空气中电晕放电高能电子密度沿反应器分布的光谱研究(英)

利用目前在等离子体特性诊断方面较为先进实用的发射光谱法,在常温常压下测量了正脉冲电晕放电空气中的Ｎ２（Ｃ３ Πｕ →Ｂ３ Πｇ） 发射光谱相对强度沿线－ 筒式反应器的径向分布,由此得到了正脉冲电晕放电等离子体中高能电子（ ≥１１ ．０３ｅＶ） 的电子密度沿线－ 筒式反应器的径向分布．随径向距离增大高能电子密度呈非线性递减,对于不同放电电压这种递减规律相同．     

微乳液介质-对乙酰基偶氮氯膦光度法测定微量的锆

研究了在微乳液介质中锆与对乙酰基偶氮氯膦显色反应的条件。络合物的最大吸收波长在685nm处,锆含量在0～30μg/25mL的范围内符合比尔定律,表观摩尔吸光系数为3.0×10~4L/(mol·cm),络合物的络合比为1:1。对乙酰基偶氮氯膦与锆的显色反应体系稳定性及重现性较好。直接用于实际样品的测定,结果较好。     

纳米级TiO2粉体的制备研究——Ⅱ.絮凝剂及其浓度的影响

采用溶胶-凝胶-超临界流体干燥(SCFD)法制备纳米级TiO₂超细粉，详细考察了不同絮凝剂及其浓度对TiO₂织构和结构性质的影响。结果表明，利用强碱溶液作为絮凝剂，浓度为5 mol·L^-1是制备大孔高比表面TiO₂超细粉较为适宜的条件。     

Sorption and desorption of radioselenium on red earth and its solid components

The effect of organic matter and iron oxides as solid components of the red earth on the retention of SeO₃ has been investigated by a batch technique and selective extraction method. The sorption and desorption isotherms of SeO₃ on the untreated red earth and the three treated soils were determined at 20°C, pH 6.8 or 7.2 and in the presence of 0.01M CaCl₂. It was found that the sorption-desorption hysteresis for untreated an treated soils is obvious and the clays play an important role in the sorption-desorption hysteresis, and that the retention of SeO₃ on red earth is attributed to the iron oxides to a great extent.     

Solvent effect on the aggregate of fluorinated gemini surfactant at silica surface

The aggregate states of partially fluorinated gemini surfactant [(CF3)2CF(CF2)2(CH2)10N(CH3)2]2(CH2)6Br2 (C(F)(5)C10-C6-C10C(F)(5)) on silica surface were investigated with atomic force microscopy (AFM) and water contact angle (CA) measurement by analyzing the effects of bulk concentration and adsorption time on stack state. On surfactant-adsorbed silica surfaces, there was a flat surface layer interspersed with some scattering surfactant aggregates. In the case of short adsorption times, the aggregates would be hemisphere. In the case of long adsorption times, the aggregates would be present in the form of bilayers. With the increase of bulk concentration, the adsorbed amount was enlarged and the surface layer became more compact. The formation of patchy bilayer aggregates indicated the saturation of the surface layer. Furthermore, organic solvent effects on the aggregate state of the surfactant on a silica surface were studied with four organic solvents, including n-hexane, dehydrated ethanol, 1,1,2-trichloro-1,2,2-trifluoroethane, and toluene. With the treatment of different organic solvents, the hemisphere aggregates on the surface layer can rearrange into spherical bilayer, rodlike monolayer, and branched rodlike monolayer aggregates, respectively. The polarity of solvents and affinity of organic solvents for surfactant molecules may have a great impact on the stack state of the fluorinated gemini surfactant molecules.     

A New 18(13 → 12β)‐abeo‐Lanostadiene Triterpenoid from Ganoderma fornicatum

A new triterpenoid, fornicatin C (= (3β)‐3‐hydroxy‐18(13 → 12β)‐abeo‐lanosta‐13(17),24‐dien‐18‐oic acid; 1 ), was isolated from the fruiting bodies of Ganoderma fornicatum, together with the known compounds fornicatin A ( 2 ) and fornicatin B ( 3 ), among other constituents. The structure of 1 was elucidated by means of spectroscopic techniques, and those of 2 and 3 were identified by comparing their spectroscopic data with those reported in the literature.