板条增益介质波前畸变诊断方法

对波前重构算法中的区域法进行了改进,使其能够应用于板条增益介质的波前畸变诊断。利用该方法对47块Nd: YAG板条增益介质沿厚度方向波前畸变进行测量,指出镀膜和加工等环节对增益介质的波前畸变可能造成的影响。按照波前畸变峰谷（PV）值对测量结果进行了统计,结果表明:增益介质造成的静态波前畸变参差不齐,测量样本中静态畸变PV值最多可达5 m以上,且仅有4.1%的增益介质静态畸变PV值小于1 m。通过选取某些增益介质使之级联,测量其组合波前畸变,发现在系统中使用两块波面互补的增益介质有助于减小系统的静态波前畸变。     

Boson peak in Sm-Al-Co ternary metallic glasses and its possible structural origin

The low temperature specific heat of Sm-Al-Co ternary metallic glasses is investigated and a clear anomaly associated with the Boson peak is identified. While this anomaly depends slightly on the chemical composition, it has no dependence on external magnetic field. To figure out the mechanism of the Boson peak, we interpret the data within various model frameworks. Unlike earlier work, our study shows that this Boson peak is mainly ascribed to an additional T² term of the specific heat, which may originate from the quasi-two-dimensional and short-range ordered structure units possibly existing in the metallic glasses.     

A scanning superconducting quantum interference device microscope for room temperature samples

We have constructed a scanning low-T_c superconducting quantum interference device (SQUID) microscope, in which the SQUID is mounted on the lower end of a copper rod and cooled to liquid helium temperature. There is a 65μm thick sapphire window under the SQUID. The sample at room temperature underneath the window can be scanned to produce magnetic images. The microscope has a spatial resolution of 100－150μm and a magnetic field sensitivity of 3－60pT/$\sqrt{Hz}$ in a magnetically unshielded environment. We have used this scanning SQUID microscope to measure various room temperature samples.     

Observation of D+(s)K- and evidence for D+(s)pi- final states in neutral B decays

We report the first observation of a B meson decay that is not accessible by a direct spectator process. The channel B(0)-->D(+)(s)K- is found in a sample of 85 x 10(6) BB; events, collected with the Belle detector at KEKB, with a branching fraction B(B(0)-->D(+)(s)K-)=(4.6(+1.2)(-1.1)+/-1.3) x 10(-5). We also obtain evidence for the B0-->D(+)(s)pi(-) decay with branching fraction B(B0-->D(+)(s)pi(-))=(2.4(+1.0)(-0.8)+/-0.7) x 10(-5). This value may be used to extract a model-dependent value of |V(ub)|.     

超声波法提取迎春花总黄酮含量的工艺研究

研究了超声波法对迎春花中总黄酮的提取条件。其最优提取条件为:料液比1∶40,超声波温度20℃,作用时间20min。在此条件下,用NaNO2-Al(NO3)3-NaOH显色法测定的总黄酮为18.22%,RSD=1.48%(n=5)。     

Effects of annealing on luminescence efficiency of large-size YAG:Ce crystal grown by temperature gradient techniques

<正>YAG:Ce crystal with a diameter of 110 mm is successfully grown by the temperature gradient technique (TGT).The effects of annealing on the luminescence efficiency of YAG:Ce crystal are investigated,and the optimal annealing temperature and atmosphere are obtained.The mechanism of variation behavior of the luminescence efficiency of YAG:Ce under different annealing conditions is discussed and some details on the luminescence associated with color centers are analyzed.     

Study of absorption and re-emission processes in a ternary liquid scintillation system

Liquid scintillators are widely used as the neutrino target in neutrino experiments.The absorption and emission of different components of a ternary liquid scintillator （Linear Alkyl Benzene （LAB） as the solvent,2,5-diphenyloxazole （PPO） as the fluor and p-bis-（o-methylstyryl）-benzene （bis-MSB） as wavelength shifter） are studied.It is shown that the absorption of this liquid scintillator is dominant by LAB and PPO at wavelengths less than 349 nm,and the absorption by bis-MSB becomes prevalent at the wavelength larger than 349 nm.The fluorescence quantum yields,which are the key parameters to model the absorption and re-emission processes in large liquid scintillation detectors,are measured.     

Ultrafast nonlinear optical properties of dye-doped PMMA discs irradiated by 40 fs laser pulses

The two-photon absorption (TPA) characteristics of PMMA discs doped with three different dyes were studied using an fs-pulsed Ti-Sapphire laser as the pump source, and employing the open-aperture Z-scan technique. TPA cross-sections obtained for PMMA doped with the dyes PM597, DCM and rhodamine 6G–rhodamine B (co-doped) were found to be equal to 24.7, 33.3 and 32.3 GM, respectively (1 GM=10^?50 cm⁴ s phot^?1 mol^?1). Furthermore, two-photon fluorescence was measured for the samples containing DCM and rhodamine 6G–rhodamine B (co-doped). Compared to the one-photon fluorescence spectrum, the peaks in the two-photon fluorescence spectrum were red shifted and the extent of red shift increased with increasing doping concentration. We have also observed that the red shift in the two-photon fluorescence peak of the samples in the solid form is much larger than that in the solution state. This phenomenon could be explained by a twisted intra-molecular charge transfer model.     

Deterministic secure quantum communication using four-particle genuine entangled state and entanglement swapping

A deterministic secure quantum communication scheme using entanglement swapping is proposed. The sender prepares four-particle genuine entangled states and sends two particles in each state to the receiver and remains the rest particles. If the quantum channel is secure, they begin to communicate. After their four-particle projective measurements, the receiver can obtain the secret information according to his measurement outcomes and classical information from the sender. Using entanglement swapping, there are no particles carrying secret information to be transmitted.     

Up-conversion emissions of Er<Superscript>3+</Superscript>-Yb<Superscript>3+</Superscript> codoped Al<Subscript>2</Subscript>O<Subscript>3</Subscript> nanoparticles by the arc discharge synthesis method

The Er³⁺-Yb³⁺ codoped Al₂O₃ nanoparticles with an average particle size of about 50 nm have been synthesized by an arc discharge synthesis method. The green and red up-conversion emissions centered at about 526, 547 and 677 nm, corresponding respectively to the ²H_11/2→⁴I_15/2, ⁴S_3/2→⁴I_15/2 and ⁴F_9/2→⁴I_15/2 transitions of Er³⁺, were detected by a 978-nm semiconductor laser diode excitation. The Annealing has evident effect on the up-conversion emissions of the samples: The red up-conversion emission is noticeable before annealing; however, the green up-conversion emission becomes predominant after annealing. The mixture of (Er,Yb)₃Al₅O₁₂ and α-(Al,Er,Yb)₂O₃ phases is more favorable for green up-conversion emissions due to an enhancement of the ESA (I) of ⁴I_11/2+a photon→⁴F_7/2 and ET (III) of ²F_5/2(Yb³⁺)+⁴I_11/2(Er³⁺)→²F_7/2(Yb³⁺)+⁴F_7/2(Er³⁺) processes. The two-photon absorption up-conversion process is involved in the green and red up-conversion emissions. The results have proved that arc discharge synthesis is a new promising preparation technology for optical materials. Supported by National Natural Science Foundation of China (Grant No. 10804015), the Scientific Research Foundation for Doctor of Liaoning Province (Grant No. 20071095), and the Educational Committee Foundation of Liaoning Province (Grant No. 2008123)