Electrocatalytic reduction of CO2 to CO by polypyridyl ruthenium complexes

Electrocatalytic reduction of CO(2) by [Ru(tpy)(bpy)(solvent)](2+) (tpy = 2,2':6',2'-terpyridine, bpy = 2,2'-bipyridine) and its structural analogs is initiated by sequential 1e(-) reductions at the tpy and bpy ligands followed by rate limiting CO(2) addition to give a metallocarboxylate intermediate. It undergoes further reduction and loss of CO.     

Synthesis and Characterization of Poly(p-phenylene benzobisoxazole)/Poly(pyridobisimidazole) Block Copolymers

Poly(p-phenylene benzobisoxazole)/poly(pyridobisimidazole) block copolymers (PBO-b-PIPD) were prepared by introducing poly(pyridobisimidazole) (PIPD) moieties into the main chains of poly(p-phenylene benzobisoxazole) (PBO) in order to enhance its photostability. PBO and copolymer fibers were directly prepared from the polymerization solutions by dry-jet wet-spinning. Chemical structures and molecular chains arrangement of the block copolymers were characterized by Fourier transform infrared (FTIR) spectroscopy, solid-state ¹³C-NMR and wide angle X-ray diffraction (WAXD). Thermal stability of the copolymers was investigated by thermogravimetric analysis (TGA) in nitrogen. Thin films of PBO and copolymers were cast from methanesulfonic acid (MSA) solutions. Both the films and fibers were exposed to UV light to determine their photostability. Changes in the chemical structures and surface morphologies of the films were characterized by FTIR spectra and scanning electronic microscopy (SEM), respectively. After UV light exposure, the retention of strength for copolymer fibers is improved compared to PBO fibers. The results revealed that copolymers suffered less photodegradation in comparison with homopolymer. The mechanism for the improved photostability of the copolymers was discussed.     

Visible‐Light‐Induced Selective Photocatalytic Aerobic Oxidation of Amines into Imines on TiO2

Imines are important intermediates for the synthesis of fine chemicals, pharmaceuticals, and agricultural chemicals. Selective oxidation of amines into their corresponding imines with dioxygen is one of the most‐fundamental chemical transformations. Herein, we report the oxidation of a series of benzylic amines into their corresponding imines with atmospheric dioxygen as the oxidant on a surface of anatase TiO₂ under visible‐light irradiation (λ>420 nm). The visible‐light response of this system was caused by the formation of a surface complex through the adsorption of a benzylic amine onto the surface of TiO₂. From the analysis of products of specially designed benzylic amines, we demonstrated that a highly selective oxygenation reaction proceeds via an oxygen‐transfer mechanism to afford the corresponding carbonyl compound, whose further condensation with an amine would generate the final imine product. We found that when primary benzylic amines (13 examples), were chosen as the substrates, moderate to excellent selectivities for the imine products were achieved (ca. 38–94 %) in moderate to excellent conversion rates (ca. 44–95 %). When secondary benzylic amines (15 examples) were chosen as the substrates, both the corresponding imines and aldehydes were detected as the main products with moderate to high conversion rates (ca. 18–100 %) and lower selectivities for the imine products (ca. 14–69 %). When tribenzylamine was chosen as the substrate, imine (27 %), dibenzylamine (24 %), and benzaldehyde products (39 %) were obtained in a conversion of 50 %. This report can be viewed as a prototypical system for the activation of C? H bonds adjacent to heteroatoms such as N, O, and S atoms, and oxofuctionalization with air or dioxygen as the terminal oxidant under visible‐light irradiation using TiO₂ as the photocatalyst.     

Modulation of Electroosmotic Flow Using Polyelectrolyte Brushes: A Molecular Dynamics Study

Polyelectrolyte brushes grafted on a pair of parallel nanochannel walls can affect the electroosmotic flow (EOF) significantly. A molecular dynamics simulation method is used to investigate the relationship between charge distribution on polyelectrolyte brushes and EOF parameters such as flux, velocity, and density of particles. The EOF can be modulated by changing the step between two charged beads on the same chain, S_c, and the valence of a bead, N_c. Simulation results indicate that the flux increases as the total number of charges on the brushes increases. The decrease of S_c and N_c can lead to a maximum average velocity in the center region. The influence on density of particles is also analyzed.

     

35 kV油浸式配电变压器噪声与振动测试

配电变压器振动与噪声问题日益凸出,研究配电变压器振动与噪声特性对其振动与噪声控制具有重要意义。该文以一台35 k V/800 k VA油浸式配电变压器为研究对象,对不同激励电压作用下配电变压器铁心振动、油箱振动以及噪声进行测试。测试结果表明:配电变压器铁心、油箱振动与噪声具有相似频谱特征,均表现出以100 Hz、200 Hz为主要峰值的频谱特征;随着激励电压增加,变压器振动及噪声水平明显增大;变压器油箱振动值大于铁心,侧面振动水平较高,油箱正面和顶面振动水平略低。测试结果准确地反映配电变压器铁心与油箱的振动与噪声特性,对于其噪声振动控制具有参考价值。     

Content Determination and Release Characteristics of Six Components in the Different Phases of “Glycyrrhiza glabra-Nux vomica” Decoction by UPLC-MS/MS

The decoction turns into a complex multiphase system following exposure to high temperature and a complex chemical environment. However, the differences in the concentration of key active ingredients in different phase states and the release of drugs in sedimentary phase have yet to be elucidated. A simple ultra-performance liquid chromatography–tandem mass spectrometry (UPLC-MS/MS) method was developed and validated for the simultaneous quantitative determination of brucine, strychnine, liquiritin, isoliquiritin, isoliquiritigenin and glycyrrhizic acid concentrations and it was applied to compare the content of different phases and measure the release characteristics of the sedimentary phase in “Glycyrrhiza glabra-Nux vomica” decoction (NGD). The results show that the method’s selectivity, precision (intraday and interday ≤ 2%), matrix effect (101–108%), recovery and stability results were acceptable according to the guidelines. The method is sensitive and reliable. The content determination results show that the most toxic strychnine in the sedimentary phase accounted for 75.70% of the total components. The different components exhibited differential release in different media, and its components were released in the artificial intestinal fluid up to 81.02% in 12 h. Several components conformed to the primary kinetic model and the Ritger–Peppas model, and the most toxic compound exhibited slow release, thus conforming to the Ritger–Peppas model. This study provides a standard of reference for studies investigating reduction in toxicity of the combination of Glycyrrhiza glabra (Glycyrrhiza glabra L.) and Nux vomica (Strychnos nux-vomica L.).     

Facilitated Photocatalytic CO2 Reduction in Aerobic Environment on a Copper-Porphyrin Metal–Organic Framework

Herein, we fabricated a π–π stacking hybrid photocatalyst by combining two two-dimensional (2D) materials: g-C₃N₄ and a Cu-porphyrin metal–organic framework (MOF). After an aerobic photocatalytic pretreatment, this hybrid catalyst exhibited an unprecedented ability to photocatalytically reduce CO₂ to CO and CH₄ under the typical level (20 %) of O₂ in the air. Intriguingly, the presence of O₂ did not suppress CO₂ reduction; instead, a fivefold increase compared with that in the absence of O₂ was observed. Structural analysis indicated that during aerobic pretreatment, the Cu node in the 2D-MOF moiety was hydroxylated by the hydroxyl generated from the reduction of O₂. Then the formed hydroxylated Cu node maintained its structure during aerobic CO₂ reduction, whereas it underwent structural alteration and was reductively devitalized in the absence of O₂. Theoretical calculations further demonstrated that CO₂ reduction, instead of O₂ reduction, occurred preferentially on the hydroxylated Cu node.