Novel Phenomenon of Oxygen-to-oxygen Silyl Migration in Directed Aldol Reaction

The phenomenon of migration of the silyl groups from α-oxygen to β-oxygen in sodium aldol reaction was observed for the first time in this paper.     

A kinetic approach to homogeneous Ziegler type polymerization. Steady state

In this paper we present a kinetic approach to the analysis of steady-state homogeneous Ziegler-Natta polymerization activity data. The influence of the number of monomeric species that are coordinated to the active site on the apparent rate law is discussed and the equations are fitted to the experimental results.     

STUDIES OF MULTICOMPONENT COMPLEX OXIDE CATALYSTS FOR OXIDATIVE COUPLING OF METHANE VI.SURFACE BASICITY AND SURFACE ACTIVE OXYGEN SPECIES OF LiTi_xLa_(1-x)O_2 λ MULTICOMPONENT OXIDE CATALYSTS

The surface basicity of Ti-La-Li multicoinponent oxides has been investigated by means of CO2-TPD. The experiment results show that C2 (C2H6 C2H4) selectivity is related to surface basic strength. The surface active oxygen species have also been characterized by means of XPS, O2-TPD and so on. It has been indicated that C2 selectivity and CH4 conversion are correlated with lattice oxygen and the adsorbed oxygen on the surface of the catalyst respectively In the O2-TPD experiments, it has also been found that there are three kinds of oxygen species on the surface of the series catalvsts, which are a (100℃ 750℃) Among them α-oxvgen causes deep oxidation whileβand γ oxygen species are related to oxidalive coupling of methane (OCM).     

1,4-dioxane as a solvent in spectroscopy and photochemistry

Commercially available 1,4-dioxane, even of spectroscopic grade, contains various impurities that arise mostly from reaction of the solvent with oxygen. Aspects relevant to the spectroscopy and photochemistry of the dioxane/oxygen system are discussed. Methods of purification and storage of the solvent are presented.     

Concentration effects in gel permeation chromatography : IV. Contribution of viscosity phenomena and macromolecular expansion

The changes in elution volumes with the changes in the concentration of an injected polymer solution are caused by several contributing effects. Under model conditions, it is possible to assume only the effect of a viscosity gradient in a zone moving along the column and the effect of the concentration dependence of the hydrodynamic volume of a macromolecular coil. The non-Gaussian shape of the zone and the dependence of the width of the elution curve on concentration are factors that complicate the theoretical treatment of concentration effects. The described physico-chemical model allows to evaluate the ratio of mentioned two contributions in the concentration dependence of elution volumes. According to this model, the contribution of the concentration dependence of the hydrodynamic volume does not exceed about 20% of the total change in elution volume with the varying concentration under real experimental conditions. The efficiency of the columns used and the total injected volume of the polymer solution affect this ratio only negligibly. It is obvious from a comparison with earlier results that these conclusions are not fundamentally changed even by the revised model of the concentration dependence of the swelling factor.     

On-line filtration system for determining total chromium and chromium in the soluble fraction of industrial effluents by flow injection flame atomic absorption spectrometry

Two manifolds were assessed for the purpose of determining both the total chromium content and that present as a soluble form in industrial effluents by flow injection flame atomic absorption spectrometry (FI-FAAS). To determine the chromium content in the soluble fraction the samples were used without additional treatment, a 0.45 microm filter being included in the FI system. To determine the total chromium content, the samples were acidified with nitric acid 20% (v/v) and heated for 30 s in a microwave oven (temperatures of about 70 degrees C were reached). The problem posed by the very different concentration range in which total and soluble chromium are present was overcome by using programmed flow rate methodology and by only partially emptying the sample loop. A personal computer controlled both the rotation speed of a peristaltic pump and the volume of sample injected into the system, thus obtaining the dispersion degree required. Using the manifold proposed, the chromium content in the soluble fraction can be determined in the 0.5-20 microg mL(-1) range using a 10 microg mL(-1) single standard for calibration. To determine the total chromium content, a calibration line in the 20-200 microg mL(-1) range was obtained using a single 50 microg mL(-1) chromium standard solution. The reliability of the semi-automatic devices was verified by comparing the results obtained with those found by treating the samples and using both FAAS in a conventional way and a spectrophotometric method using diphenylcarbazide at the 95% confidence level (ANOVA test). The proposed procedures showed a RSD lower than +/-3%.     

Determination of iron at ng/ml level by solid phase spectrophotometry after preconcentration on cation exchange filters

A cationic exchanger paper is used to retain analytes in solution and, after drying, to analyze directly by measuring the UV-Vis absorbance of the paper. The method was applied to determination of iron using its known 1,10-phenanthroline complex. Using 100 ml of sample the applicable concentration range was between 1.0 and 10.0 ng/ml with a detection limit of 0.2 ng/ml and a RSD around 2%. The method was applied to determination of iron total in snow, human serum and wine.     

Nucleocyclitols. Synthesis of substituted purinyl-muco-inositol derivatives

Several carbocyclic nucleoside analogs possessing a 6-substituted purine linked to a mesylated muco-inositol were synthesized. The coupling of triethylamine-activated 6-chloropurine with 2,3-anhydro-l,5,6-tri-O-(methanesulfonyl)-epi-inositol gave a 6-chloro purinyl muco-inositol amenable to further synthetic transformations in the heterocyclic moiety by substitution of the chlorine atom by nitrogen nucleophiles such as methylamino, diethylamino, benzylamino, hydrazino, morpholino, hydroxylamino, piperidino, and glycyl groups.     

Some applications of gel-permeation chromatography in investigations of structure and the solution properties of radical-initiated poly(vinyl chloride)

The applicability of the published universal calibration parameters for gel-permeation chromatography on polystyrene standards and poly(vinyl chloride) samples with a defined structure has been compared. It was shown experimentally that of several theoretically possible molecular weight averages attributed to the elution volume at the position of the peak maximum, the root mean-square average molecular weight M _Rms = (M _wM _n)^0.5 shows the best accordance. The molecular weights obtained by gel-permeation chromatography were compared with those determined by viscometry, osmometry, and the light-scattering method. The reproducibility of gel-permeation chromatography measurements is 3%, and the average variance of the results as compared with results obtained by the above methods is about 8%. It was also found that the gel-permeation chromatography does not involve any anomalies interfering with results obtained by other methods.     

On-line preconcentration of inorganic mercury and methylmercury in sea-water by sorbent-extraction and total mercury determination by cold vapour atomic absorption spectrometry

A comparative study of three mercury chelate forming reagents [diethyldithiocarbamate, pyrrolidin-1-yldithioformate and diphenylthiocarbazone (dithizone)] has been carried out for the preconcentration of ultratrace amounts of inorganic mercury and methylmercury in silica C(18) minicolumns as the solid sorbent. Sample flow injection in-line sorbent extraction was coupled with continuous cold vapour atomic absorption spectrometry (CVAAS) for detection. Results showed the superiority of the carbamate type reagents over the dithizone for the on-line formation and preconcentration of the corresponding mercury chelates. Using diethyldithiocarbamate (DDC) as reagent, aqueous sample volumes of 100 ml can be preconcentrated with 100% efficiency for both inorganic mercury and methylmercury. Quantitative release of the retained DDC chelates was obtained for volumes of eluent (ethanol) of 50 microl. Following the proposed procedure, detection limits of 16 ng/l. of mercury were achieved for sample volumes of 25 ml. The relative standard deviation was +/- 3.4% at 0.5 microg/l. Hg(II) levels. The method has been successfully applied to the determination of low levels of mercury in sea-water.