Huge fluctuations in weight measurements at the bottom of a two-dimensional vertical sheet of grains

Weight measurements at the bottom of a quasi-2D vertical sheet of static cohesionless grains are carried out. The grains are held between two coaxial cylinders. This peculiar setup allows us to set either periodic or fixed lateral boundary conditions. Huge relative fluctuations in weight measurements appear in case of fixed lateral walls. This may be related to some indetermination in the mobilization state of friction forces on lateral walls. This argument would hold for any piling, but would lead to huge fluctuations in 2D systems only, because of averaging effects in 3D.     

Theoretical and experimental study of differential group delay and polarization dependent loss of Bragg gratings written in birefringent fiber

In this paper, we completely study the wavelength dependency of differential group delay (DGD) and polarization dependent loss (PDL) for Bragg gratings written in birefringent fibers. Based on the coupled mode theory, we present analytical expressions for the evolution with wavelength of the transmission coefficient, the DGD and the PDL. The wavelength dependencies of these evolutions on the birefringence are then discussed. Experimental results are finally presented for an apodized FBG written in a bow-tie fiber. A very good agreement between theory and experience is reported, confirming the validity of the theoretical analysis.     

Surface modification of polypropylene with an atmospheric pressure plasma jet sustained in argon and an argon/water vapour mixture

In this paper, an atmospheric pressure plasma jet sustained in pure argon and an argon/water vapour mixture has been used to modify the surface of polypropylene (PP) films. The gas temperature of the plasma jet was found to be 625 K in an active zone between the electrodes and was found to increase in the afterglow. Based on these results, the PP films are placed as close as possible to the edge of the capillary in order to avoid thermal damage to the polymer. XPS results on the untreated and modified PP samples revealed incorporation of a significant amount of oxygen on the polymer surface, however, this oxygen inclusion is more pronounced for the argon/water vapour jet due to the higher radicals density in the jet afterglow. One can therefore conclude that adding water vapour to an argon plasma jet can be a convenient way to increase the efficiency of plasma surface modification.     

Parameterized reduced order modeling of misaligned stacked disks rotor assemblies

Light and flexible rotating parts of modern turbine engines operating at supercritical speeds necessitate application of more accurate but rather computationally expensive 3D FE modeling techniques. Stacked disks misalignment due to manufacturing variability in the geometry of individual components constitutes a particularly important aspect to be included in the analysis because of its impact on system dynamics. A new parametric model order reduction algorithm is presented to achieve this goal at affordable computational costs. It is shown that the disks misalignment leads to significant changes in nominal system properties that manifest themselves as additional blocks coupling neighboring spatial harmonics in Fourier space. Consequently, the misalignment effects can no longer be accurately modeled as equivalent forces applied to a nominal unperturbed system. The fact that the mode shapes become heavily distorted by extra harmonic content renders the nominal modal projection-based methods inaccurate and thus numerically ineffective in the context of repeated analysis of multiple misalignment realizations. The significant numerical bottleneck is removed by employing an orthogonal projection onto the subspace spanned by first few Fourier harmonic basis vectors. The projected highly sparse systems are shown to accurately approximate the specific misalignment effects, to be inexpensive to solve using direct sparse methods and easy to parameterize with a small set of measurable eccentricity and tilt angle parameters. Selected numerical examples on an industrial scale model are presented to illustrate the accuracy and efficiency of the algorithm implementation.     

Just noticeable differences of open quotient and asymmetry coefficient in singing voice

This study aims to explore the perceptual relevance of the variations of glottal flow parameters and to what extent a small variation can be detected. Just Noticeable Differences (JNDs) have been measured for three values of open quotient (0.4, 0.6, and 0.8) and two values of asymmetry coefficient (2/3 and 0.8), and the effect of changes of vowel, pitch, vibrato, and amplitude parameters has been tested. Two main groups of subjects have been analyzed: a group of 20 untrained subjects and a group of 10 trained subjects. The results show that the JND for open quotient is highly dependent on the target value: an increase of the JND is noticed when the open quotient target value is increased. The relative JND is constant: ΔO_q/O_q = 14% for the untrained and 10% for the trained. In the same way, the JND for asymmetry coefficient is also slightly dependent on the target value–an increase of the asymmetry coefficient value leads to a decrease of the JND. The results show that there is no effect from the selected vowel or frequency (two values have been tested), but that the addition of a vibrato has a small effect on the JND of open quotient. The choice of an amplitude parameter also has a great effect on the JND of open quotient.     

Direct measurement of the spatial Wigner function with area-integrated detection

We demonstrate experimentally a novel technique for characterizing transverse spatial coherence by using the Wigner distribution function. The method is based on the measurement of interference between a pair of rotated and displaced replicas of the input beam with an area-integrating detector, and it provides an optimal signal-to-noise ratio in regimes when array detectors are not available. We analyze the quantum-optical picture of the presented measurement for single-photon signals and discuss possible applications in quantum information processing.     

Complete temporal characterization of short optical pulses by simplified chronocyclic tomography

A new self-referencing technique to characterize the temporal electric field of a short optical pulse is presented. The group delay of the pulse is directly obtained from two projections of the Wigner-Ville function after rotation of the pulse in chronocyclic space. Implementation of the technique requires only quadratic temporal phase modulation and two spectrum measurements, from which the electric field is directly and unambiguously reconstructed without any assumption. A device based on these principles is used to characterize the electric field of a 2-ps optical pulse.     

A novel femtosecond-laser formation of CdS nanocrystallites in zirconia matrices

A novel method for direct laser writing of two-dimensional cadmium sulfide (CdS) semiconductor nanoparticle microstructures is reported. A two photon or a higher-order multiphoton absorption process, originating from femtosecond laser pulses, was used to decompose CdS precursors dispersed in a zirconia thin film previously dip-coated on a glass substrate. The kinetics of nanoparticle formation as a function of laser power were monitored in situ by photoluminescence spectroscopy. Raman spectroscopy was also performed to characterize the structural changes of the zirconia matrix under irradiation and to verify the formation of CdS nanoparticles. Results show that CdS nanoparticles were formed by two-photon absorption (TPA) with or without the help of an additional carbazole photoinitiator.     

Charge density: A probe for the nuclear interaction in microscopic transport models

The transport properties of the ³⁶Ar +⁵⁸Ni system at measured with the INDRA array, are studied within the BNV kinetic equation. A general protocol of comparison between the N-body experimental fragment information and the one-body distribution function is developed using global variables, with a special focus on charge density. This procedure avoids any definition of sources and any use of an afterburner in the simulation. We shall discuss the feasibility of such an approach and the distortions induced by the finite detection efficiency and the completeness requirements of the data selection. The sensitivity of the different global observables to the macroscopic parameters of the effective nuclear interaction will be studied in detail.Received: 21 January 2003, Published online: 5 August 2003PACS: 25.70.-z Low and intermediate energy heavy-ion reactions - 24.10.-i Nuclear reaction models and methodsN. Le Neindre: Permanent address: Institut de Physique Nuclaire, IN2P3-CNRS, F-91406 Orsay cedex, France.