Stress-Strain Behavior of Shape Memory Polymers by 1WE Method: Application to Tecoflex®

Thermomechanical cycles including programming, cooling, unloading and heating to trigger the 1WE were examined for a shape memory polymer (SMP), Tecoflex® (TFX EG-72D). Cycles were performed at 60°C with 50% and 225% strains and the recovery time of 10 min. Strains evolving with time were estimated during the thermomechanical treatments for the total 44 cycles using 50% strains and the total 50 cycles using 225% strains. Recovery ratios for 50% strains and 225% were also estimated. It turns out that programming, cooling, unloading and heating to trigger the 1WE causes an increase of irreversible strain and is associated with a corresponding decrease of the intensity of the 1WE in particular during the first thermomechanical cycles. In parallel scanning electron microscopic study using secondary electron imaging shows a very slight wavy surface structure evolved during cycling.     

Acid-Catalyzed RNA-Oligomerization from 3’,5’-cGMP

The assembly of ancient informational polymers from nucleotide precursors is the central challenge of life's origin on our planet. Among the possible solutions, dry polymerization of 3’,5’-cyclic guanosine monophosphate (3’,5’-cGMP) has been proposed as a candidate to create oligonucleotides of 15–20 units in length. However, the reported sensitivity of the reaction to the presence of cations raised questions of whether this chemistry could be relevant in a geological context. The experiments in this study show that the presence of cations is not restrictive as long as the reaction is conducted in an acidic environment, in contrast to previous reports that suggested optimal conditions at pH 9.     

Modelling procedures and properties of rubber in rolling contact

Rubber covered cylinders in rolling contact are studied in two cases; rolling over a flat surface and rolling over a groove. In the first case, two different finite element procedures are compared for the purpose of investigating if computational savings can be made when taking amplitude dependent effects into account by using a modified viscoelastic steady state rolling procedure. This procedure is compared with using a more expensive overlay method with an elastoplastic-viscoelastic material model. The two procedures and material models are shown two give equal results in the flat surface case. For the case of rolling over a groove, it is shown how the non-linear dynamic material characteristics of the rubber layer influence the rolling contact. The groove filling capacity of the rubber is shown to be strongly dependent on the material model. It is shown that amplitude dependent rubber materials have better ability to fill out contact surface irregularities such as a groove.     

Irreversible Structural Changes of Copper Hexacyanoferrate Used as a Cathode in Zn-Ion Batteries

The structural changes of copper hexacyanoferrate (CuHCF), a Prussian blue analogue, which occur when used as a cathode in an aqueous Zn-ion battery, are investigated using electron microscopy techniques. The evolution of Zn_xCu_1−xHCF phases possessing wire and cubic morphologies from initial CuHCF nanoparticles are monitored after hundreds of cycles. Irreversible introduction of Zn ions to CuHCF is revealed locally using scanning transmission electron microscopy. A substitution mechanism is proposed to explain the increasing Zn content within the cathode material while simultaneously the Cu content is lowered during Zn-ion battery cycling. The present study demonstrates that the irreversible introduction of Zn ions is responsible for the decreasing Zn ion capacity of the CuHCF cathode in high electrolyte concentration.