The first example of a liquid crystalline side-chain polymer with bent-core mesogenic units: ferroelectric switching and spontaneous achiral symmetry breaking in an achiral polymer

A dimethylsiloxane diluted polysiloxane side chain co-polymer with non-chiral banana-shaped mesogenic units shows an optically isotropic ferroelectric switching polar smectic C phase (SmCPF) consisting of a conglomerate of homogeneously chiral domains with opposite handedness.     

Metabolic profiling of normal and hypertensive rat kidney tissues by hrMAS-NMR spectroscopy

Intact kidney tissue samples of normal and spontaneously hypertensive rats (SHRs) were analyzed by hrMAS-NMR spectroscopy and principal component analysis (PCA). Radial components (cortex, outer stripe of the outer medulla, inner stripe of the outer medulla, and papilla) were sampled from various regions across the kidney from multiple animals in order to establish inter- and intra-animal variability. The effects of temperature were also measured. Papilla was differentiated from the other tissue types, and this variation by tissue type was greater than the effect of temperature on the samples (spectra were compared from samples at 2 and 30 °C). This study also revealed long term stability issues of tissue storage at -80 °C. The PCA showed that the greatest differentiation between normal rats and SHRs was found in the cortex and the regions in the NMR spectra that were correlated with this variation were identified.Abbreviations hrMAS High-resolution magic angle spinning - NMR Nuclear magnetic resonance - PCA Principal component analysis - CSA Chemical shift anisotropy - DD Dipolar coupling - SHR Spontaneously hypertensive rat     

Analysis of free and esterified sterols in vegetable oil methyl esters by capillary GC

The introduction of quality standards for vegetable oil methyl esters is gaining in importance due to their increased use as diesel fuel substitutes and as technical products. Free and esterified sterols, the main constituents of the unsaponifiable matter in vegetable oils, are recovered in vegetable oil methyl esters and may influence the technical properties of vegetable oil methyl ester products. A rapid gas chromatographic method for the qualitative and quantitative determination of free and esterified sterols in vegetable oil methyl esters has therefore been developed. The concentration of the free sterols as well as their qualitative and quantitative composition and the concentration of the sterol esters have been determined in rape seed oil methyl ester samples by GC–FID. Prior to analysis, the free sterols were silylated with N,O-bis(trimethylsilyl)trifluoroacetamide with 1% of trimethylchlorosilane; betulinol was used as an internal standard. Calibration was performed by analysis of standard solutions containing β-sitosterol, cholesteryl stearate, and betulinol. The reproducibility of the quantitative results has been evaluated by repeated injections of the same test solution and by repeated complete analysis of the same sample.     

Permeation associated with three-phase-partitioning method on release of green fluorescent protein

Transformed cells of Escherichia coli expressing recombinant green fluorescent protein (GFPuv) were subjected to two methods of extraction: (1) freezing/thawing/sonication (FTS) cycles prior to the three-phase partitioning (TPP) method, or (2) directly to TPP extraction. The amount of GFPuv released by the FTS plus TPP method varied: 374μg/mL (first cycle), 93–442 μg/mL (second cycle), 32–359 μg/mL (third cycle), 18–115 μg/mL (fourth cycle). The GFPuv yields by the second method (TPP only) were, 23–54 μg/mL for the first extract and 33–91 μg/mL for the second. The FTS plus TPP method released similar amounts of GFPuv to that extracted by TPP; and provided a better mixture elution through the hydrophobic interaction column: 13–63 μg/mL for FTS plus TPP methods, and 2.5–13 μg/mL for TPP. The results showed that although selective permeation is a more laborious methodology, it was more efficient for obtaining of GFPuv in relation to the direct extraction of the cells for TPP.     

Charge-transfer interactions in face-to-face porphyrin-fullerene systems: solvent-dependent luminescence in the infrared spectral region

The cyclophane-type molecular dyads 1 x 2H and 1 x Zn, in which a doubly bridged porphyrin donor adopts a close, tangential orientation relative to the surface of a fullerene acceptor, were prepared by Bingel macrocylization. The porphyrin derivatives 2 x 2H and 2 x Zn with two appended, singly linked C60 moieties were also formed as side products. NMR investigations revealed that the latter compounds strongly prefer conformations with one of the carbon spheres nesting on the porphyrin surface, thereby taking a similar orientation to that of the fullerene moiety in the doubly bridged systems. Cyclic voltammetric measurements showed that the mutual electronic effects exerted by the fullerene on the porphyrin and vice versa are only small in all four dyads, despite the close proximity of the donor and acceptor components. The steady-state and time-resolved absorption and luminescence properties of 1 x Zn and 2 x Zn were investigated in toluene solution and it was shown that, upon light excitation, both the porphyrin- and the fullerene-centered excited states are deactivated to a lower-lying CT state, emitting in the IR spectral region (lambda max = 890 and 800 nm at 298 and 77 K, respectively). In the more polar solvent benzonitrile, this CT state is still detected but, owing to its very low energy (below 1.4 eV), is not luminescent and shorter-lived than in toluene. The remarkable observation of similar photophysical behavior of 1 x Zn and 2 x Zn suggests that a tight donor-acceptor distance cannot only be established in doubly bridged cyclophane-type structures but also in singly bridged dyads, by taking advantage of favourable fullerene-porphyrin ground-state interactions.     

A remark on a paper by S.R. Bell

It is shown that unbranched proper holomorphic maps between pseudoconvex domains with smooth C boundaries, one of which satisfies subelliptic estimates for the -Neumann problem on (0,1)-forms, extend to unbranched C-coverings between the closures of the domains.     

Comparison of Si-O-C interfacial bonding of alcohols and aldehydes on Si(111) formed from dilute solution with ultraviolet irradiation

Aliphatic alcohols and aldehydes were reacted with the Si(111)-H surface to form Si-O-C interfacial bonds from dilute solution by using ultraviolet light. The resulting monolayers were characterized by using transmission infrared spectroscopy, spectroscopic ellipsometry, and contact angle measurements. The effect of different solvents on monolayer quality is presented. The best monolayers were formed from CH(2)Cl(2). The optimized monolayers were thoroughly characterized to determine the film structure and monolayer stability. The UV-promoted, alcohol-functionalized, and aldehyde-functionalized monolayers are of comparable quality to those previously prepared by other means. Although both molecules are tethered through a Si-O-C bond, the film reactivity is distinctly different with the aldehyde films being more chemically resistant. The differences in chemical reactivity, vibrational spectra, hydrophobicity, and ellipsometric thickness between the alcohol and aldehyde monolayers are attributed to a difference in molecular coverage and monolayer formation.     

The behaviour of micro-bitumen drops in aqueous clay environments

This study summarises the rheological behaviour of emulsion bitumen drops in the presence of aqueous solutions of de-ionised or process water (DIW or PW) containing montmorillonite clays (M) and/or calcium ions (Ca++). The presence of calcium ions and montmorillonite clays resulted in the plastic behaviour of bitumen drops. In a DIW+M+Ca++ system, increasing temperature and calcium ion concentration resulted in an increase in the number and degree of plastic bitumen drops. In the presence of considerable amounts of Ca++ ions and/or at higher experimental temperature, bitumen drops in a PW+M system exhibited no significant overall plasticity of their surfaces. Both calcium and sodium ions contained in process water compete with each other to occupy the montmorillonite clay surface. At the pH value of process water (pH congruent with8), increasing the temperature did not change the value of bitumen droplet zeta potential. Stability of bitumen-in-water emulsions at 22 degrees C showed that bitumen droplets coalesced upon contact in the DIW+M system. The addition of calcium ions (Ca++) led to the inhibition of coagulation and coalescence of bitumen droplets, which may indicate the formation of CaM aggregates at the bitumen-water interface.     

On the stability and decomposition of η6-(2-lithiochlorobenzene)tricarbonylchromium(0)

The decomposition of η⁶-(2-lithiochlorobenzene)tricarbonylchromium(0) (I) was found to follow first order kinetics with k_dec  5.1 x 10^-3 min^-1 at 0°C, the half life of I being 136 min at 0°C. While this dependence strongly suggests intermediacy of η⁶-(benzyne)tricarbonylchromium, trapping experiments were successful in only low yield.