A viscoelastic constitutive model of rubber under small oscillatory load superimposed on large static deformation considering the Payne effect

The viscoelastic behavior of carbon-black-filled rubber under small oscillatory loads superimposed on large static deformation is dealt with. In this class of problems, as the strain amplitudes of the load increase, the dynamic stiffness decreases, and this phenomenon is known as the Payne effect. Besides the effects of the static deformation and the frequencies of the superimposed dynamic load, the Payne effect is considered in this study. Influence factors are introduced in this model in order to consider the influence of static predeformation, the dynamic-strain-dependent properties, and frequency-dependent properties. For simplicity, separation of the three dominant variables, frequency, prestatic deformation, and dynamic amplitude of strain, is assumed. The Kraus model is used for describing the Payne effect. Dynamic tension tests are executed to obtain the model parameters and also for the verification of the proposed model. The suggested constitutive equation shows reasonable agreement with test data.     

Strong visible PL from the nc-Si thin film by Ni silicide mediated crystallization

We studied the growth of nanocrystalline silicon (nc-Si) thin film exhibiting a strong room temperature photoluminescence (PL) at 1.81–2.003 eV. The amorphous silicon was crystallized by Ni silicide mediated crystallization (Ni SMC) and then Secco-etched to exhibit the PL. The PL peak energy and intensity increase with increasing the metal density on the a-Si because of the reduction in the grain size down to 2 nm. The photoluminescence energy and peak intensity depend strongly on the Secco etch time because the grain size is reduced by etching the grain boundaries.     

Positive periodic solution of two-species ratio-dependent predator–prey system with time delay in two-patch environment

In this paper, we are concerned with the existence of positive periodic solution to a class of two-species ratio-dependent predator–prey diffusion model with time delay. By using the continuation theorem of coincidence degree theory, we transform this problem into a problem of calculating the topological degree of a continuous mapping, and then some sufficient conditions of the existence of positive periodic solution is established for the system.     

Correlation between Al2O3 particles and interface of Al-Al2O3 coatings by cold spray

Al-Al₂O₃ composite coatings with different Al₂O₃ particle shapes were prepared on Si and Al substrate by cold spray. The powder compositions of metal (Al) and ceramic (Al₂O₃) having different sizes and agglomerations were varied into ratios of 10:1 wt% and 1:1 wt%. Al₂O₃ particles were successfully incorporated into the soft metal matrix of Al. It was found that crater formation between the coatings and substrate, which is typical characteristic signature of cold spray could be affected by initial starting Al₂O₃ particles. In addition, when the large hard particles of fused Al₂O₃ were employed, the deep and big craters were generated at the interface between coatings and hard substrates. In the case of pure soft metal coating such as Al on hard substrate, it is very hard to get proper adhesion due to lack of crater formation. Therefore, the composite coating would have certain advantages.     

Catalytic allylic transfer reactions of functionalized aldehydes promoted by BINOL-Ti(IV) with synergistic reagent

Practical and efficient catalytic asymmetric allylic transfer reactions of tin reagents promoted by BINOL-Ti[OCH(CF₃)₂]₂ complex by the utilization of t-BuSBEt₂ are successful with a variety of functionalized aldehydes containing ketone, aldehyde, ester, amide, or carbamoyl functionality and affords products in high levels of enantioselectivity.     

Reduction of dislocation density and improvement of optical quality in ZnO layers by MgO-buffer annealing

Optical properties of ZnO thin films with/without MgO-buffer annealing were investigated by low and room temperature photoluminescence measurements. The ZnO films were grown on c-sapphire substrates by plasma-assisted molecular-beam epitaxy employing a thin MgO-buffer layer. Dislocation density of ZnO layer was reduced from 5.3 × 10⁹ to 1.9 × 10⁹ cm⁻² by annealing MgO-buffer prior to the growth of ZnO. The intensity of free exciton emission from the sample with MgO-buffer annealing was almost twice of that from the sample without annealing, while the deep level emission from the sample with MgO-buffer annealing was about 1/3 of that without annealing. The MgO-buffer annealing improves optical quality of overgrown ZnO films.     

Crossover Critical Behavior in the Three-Dimensional Ising Model

The character of critical behavior in physical systems depends on the range of interactions. In the limit of infinite range of the interactions, systems will exhibit mean-field critical behavior, i.e., critical behavior not affected by fluctuations of the order parameter. If the interaction range is finite, the critical behavior asymptotically close to the critical point is determined by fluctuations and the actual critical behavior depends on the particular universality class. A variety of systems, including fluids and anisotropic ferromagnets, belongs to the three-dimensional Ising universality class. Recent numerical studies of Ising models with different interaction ranges have revealed a spectacular crossover between the asymptotic fluctuation-induced critical behavior and mean-field-type critical behavior. In this work, we compare these numerical results with a crossover Landau model based on renormalization-group matching. For this purpose we consider an application of the crossover Landau model to the three-dimensional Ising model without fitting to any adjustable parameters. The crossover behavior of the critical susceptibility and of the order parameter is analyzed over a broad range (ten orders) of the scaled distance to the critical temperature. The dependence of the coupling constant on the interaction range, governing the crossover critical behavior, is discussed.     

Optical characterization of CdTe/ZnSe fractional monolayer structures grown by atomic layer epitaxy

Luminescence properties of CdTe/ZnSe fractional monolayer grown by atomic layer epitaxy have been investigated. To investigate the origin of the highly efficient luminescence, various optical spectroscopic methods such as, photoluminescence (PL), temporal/spatial resolved PL, temperature dependence PL, and excitation power dependence PL have been used. It is found that structural inhomogeneities affect dominant influence on the line width and line shape of luminescence. The luminescence intensity greatly enhanced by the localization of exciton at the disorder induced localized states.     

Investigation of chemometric calibration performance based on different chemical matrix and signal-to-noise ratio.

The chemometric calibration performance was systematically investigated by two parameters (changing the chemical matrix as well as the signal-to-noise ratio) of the NIR (near-infrared) spectrum. Three different analytes (hexane, cyclohexane, toluene) were selected and heptane was used as a solvent. The degree of spectral difference significantly affected the calibration performance. The largest structural difference between the analyte and the solvent provided the best calibration result for a given signal-to-noise ratio. Additionally, the signal-to-noise ratio of the spectra also directly influenced the calibration performance. Overall, the spectral difference and signal-to-noise ratio were the major factors for governing the chemometric calibration performance, especially in the low-concentration range.