Synthesis of Polyacrylaminothiourea Chelating Fiber and Properties of Concentration and Separation of Trace Noble Metal Ions from Samples

A novel polyacrylaminothiourea chelating fiber was synthesized simply and rapidly from nitrilon (an acrylonitrile-based synthetic fiber), which was applied to preconcentrate and separate of trace amount of Au(Ⅲ）,Pt(Ⅳ）,Pd(Ⅳ） and Ir (Ⅳ） ions from solution of samples.The analyzed ions can be quantitatively concentrated by the fiber up to a flow rate of 20.0mL/min at pH2, and can also be desorbed with 15 mL of 4mol/L HCl 3% thiourea from the fiber column with recoveries of 96.5%-100%.The chelating fiber can be reused for ten times,the recoveries of these ions are still over 92%,and hundred to thousand times of excess of Fe(Ⅲ）,Al（Ⅲ）,Ca(Ⅱ），Mg（Ⅱ）,Ni(Ⅱ）,Mn（Ⅱ),Cu(Ⅱ），Zn(Ⅱ），and Cd(Ⅱ） cause no interference on the determination of the analyzed ions by inductively-coupled plasma atomic emission spectrometry (ICP-AES).The static saturation adsorption capacities of the fiber for the analytes are in the range of 1.15-2.80mmol/g.The relative standard deviations for the determination of 20.0ng/mL each of Au(Ⅲ）,Pt(Ⅳ）,Pd(Ⅳ）and Ir(Ⅳ） are in the range of 0.7%-3.0%.The recoveries for test from standard additions to real solution samples are between 96% and 100%.The concentration of each ion in powder sample detected by the method is in good agreement with the certified value.     

新型分子筛Ti-MMM-1的合成及其催化性能的研究

通过控制TEOS的水解，在不同时间添加与MCM-41和MFI相应的有机模板剂合成出了一种新型分子筛，Ti-MMM-1，采用XRD、FT-IR和低温N2吸附对其进行表征，并用H2O2氧化环己烷和环己醇对其催化活性进行评价．结果表明，Ti-MMM-1是一种具有MCM-41和MFI结构的两相混合的微孔／介孔材料，IR分析表明钛原子已进入分子筛骨架，并在环己烷和环己醇的氧化中表现出较好的催化活性和较高的选择性．     

4′-乙酰基苯并-15-冠-5缩氨基硫脲的微波合成及晶体结构

硫脲衍生物主要通过氢键与阴离子相互作用达到识别的目的，冠醚和硫脲两个主体分子亚单元之间的协同作用往往使冠醚和硫脲表现出对某些客体更加优越的络合识别能力，我们在以前工作的基础上，微波辐射下合成了标题化合物并用红外光谱、核磁共振氢谱、元素分析、X射线单晶衍射对其结构进行了表征，欲进一步研究其对阳离子和阴离子识别的双重功效。     

电子探针定量分析的标准样品——几种多元氧化物单晶

在很高的温度和适宜的生长条件下,分别采用熔盐籽晶法和高温引上法生长了高质量的YAP、NAB、KTP、LN、BBO、SBN等多元氧化物单晶,它们具有优良的物理化学性能,严格的化学比,固定的组成与结构以及较好的化学均匀性和电子束轰击下的稳定性。广泛地用于激光和非线性光学领域。我们选用这些晶体为原材料研制电子探针定量分析的标准样品。经过测量和标定,这些单晶标样符合中华人民共和国国家标准GB 4930-85(电子探针显微分析标准样品通用技术条件)的规定。含有稀土元素的标样如NAB和YAP能发出绿色荧光,是电子显微术中理想的阴极发光材料。     

Fe(III)与2,3-二羟基苯磺酸钠配位反应的动力学研究

[H+]在0.01～0.70mol?L-1范围内,离子强度为1.00mol?L-1,[Fe(III)]>>[配体]、[H+]>>[配体]的条件下,研究了Fe(III)与2,3-二羟基苯磺酸钠(Tiron)的配位反应.发现当[H+]≤3.00×10-2mol?L-1时,[Fe(III)]2对反应速率有明显的贡献.求得了相关反应的动力学参数,从而揭示了FeOH2+和FeOH24+与Tiron配位的解离反应途径及FeOH32+的缔合反应机制,并提出了该配位反应的可能机理.     

三磷酸胞苷在Duolite A-30树脂上的交换过程研究

根据CTP在离子交换树脂上的吸附容量和分离因数的大小,确定Duolite A-30树脂适合CTP与CDP,CMP之间的分离.对CTP在Duolite A-30树脂上的吸附动力学和热力学研究表明,在283.15K~303.15K之间,CTP的质量浓度在7.5g/L以上时,Duolite A-30树脂对CTP的吸附主要受颗粒扩散的控制,其有效扩散系数为D=3.47×10-7cm2/s,溶液的质量浓度≤1.0g/L时,CTP与Duolite A-30树脂之间的交换速率主要受液膜控制,其液膜扩散系数为Kf =4.112×10-4/s.同时测定了不同条件下三磷酸胞苷溶液在Duolite A-30树脂固定床离子交换柱中的穿透曲线,研究了进口浓度、进口流速、原料液温度、原料液的pH值及柱高对穿透曲线的影响.用二阶动力学推动力模型描述固定床动态过程,考察了轴向返混对穿透曲线的影响,并从穿透曲线回归得到总传质系数,模型计算值与实验数据符合良好.     

聚甲醛自然老化的SEM研究

对户外曝晒3～36个月的聚甲醛(POM)老化形态进行了研究,讨论了老化层厚度,裂纹宽度、裂纹深度及断口形态与老化时间的关系。结果表明:POM的老化导致了材料内部结构由韧性变成脆性而几乎完全丧失物理机械性能。     

THE SEPARATION,PURIFICATION AND DECOLORIZATION OF NEW ANTIBIOTICS-MILUPEINAN USING ADSORPTION RESIN

1. INTRODUCTION Fig.1 The Chemical Structure of Milupeinan As a new type of antibiotics Milupeinan, not only possesses antibacterial activities against a wide range of Gram-positive and Gram-negative bacteria, but also higgh stability under th…     

Nanostructure Pt Electrode Obtained via Self-assembly of Nanoparticles on Conductive Oxide-coated Glass Substrate

Self-assembly of platinum nanoparticles were applied to fabrication of counter electrode for dye-sensitized solar cells on conductive oxide-coated glass substrate. The present Pt electrode exhibits high exchange current density of 220 mA/cm^2, which is comparable to those prepared by electrodeposition, magnetron sputtering or thermal decomposition of platinum chloride. After analysis by transmission electron microscopy (TEM), atomic force microscopy (AFM) and X-ray photoelectron spectroscopy (XPS), it was found that the catalyst was structurally characterized as nanosized platinum metal clusters and was continuously arranged on electrode surface. The present nanostructure electrode had high electrocatalytic activity for the reduction of iodine in organic solution.     

苯丙水溶胶的合成与性能研究(I) 聚合工艺和反应组分对聚合稳定性和胶体性能的影响

用一次投料法、半连续滴加法和单体预乳化法三种聚合工艺，合成了苯丙乳液聚合物，并加氨微细化，转化成水溶胶，考察了聚合工艺和反应组分（乳化剂，功能单体等）对苯丙乳液及其水溶胶反应稳定性和粒子大小及分布等胶体性能的影响。