Relative intensity noise induced by four-wave mixing in the case of two-wave transmission in an optical fiber

Four-wave mixing (FWM) is a significant nonlinear effect in wavelength division multiplexing (WDM) fiber-optic systems. For two-wave transmission, it is easily found that the FWM noise power decreases with frequency spacing and increases with signal power. However, the variation of relative intensity noise (RIN) with frequency spacing and signal power is only 2 dB at most. The intensity fluctuations induced by the energy exchange between the FWM generated new waves and the original ones are trivial and the influence of FWM on RIN can be neglected. It is also found that the increase of RIN with signal power is mainly attributed to stimulated Brillouin scattering (SBS) rather than FWM.     

Multi-wavelength operation of LD side-pumped Nd:YAG laser

A dual-wavelength laser at 1064 nm and 1319 nm is obtained by a single Nd:YAG crystal rod. On the basis of 1064 nm and 1319 nm dual-wavelength laser installation, the second harmonic waves at 532 nm and 660 nm can be achieved by using non-linear frequency conversion technology. When 1064 nm and 1319 nm lasers oscillate simultaneously, the maximum output power is 30.5 W and 8.78 W, respectively. When the 1319 nm laser is restrained, we obtain a 35.6 W maximum output power at 1064 nm and by contrary 11.2 W at 1319 nm. The maximum output powers of 532 nm and 660 nm lasers are 5.34 W and 1.353 W when oscillating simultaneously. With one of them restrained, the maximum output power is 6.72 W at 532 nm and 1.90 W at 660 nm. The optimum repetition rate of the acousto-optic Q-switch is 10.5 KHz and 20.5 KHz for 532 nm and 660 nm lasers, respectively. The optical-to-optical conversion efficiency from the fundamental waves to the harmonic waves is 17.5% and 15.4%. The instability is less than 2%.     

Oxygen relaxation and phase transition in GdBaCo2O5 + δ oxide

Electrical conductivity, internal friction techniques and dilatometer have been used to investigate the oxygen relaxation, phase transition and thermal expansion behavior of GdBaCo₂O_5 + δ. The main electronic charge carriers in GdBaCo₂O_5 + δ are electronic holes, which could be assigned to the formation of Co⁴⁺. The oxygen exchange kinetics intensely depends on oxygen partial pressure and is also closely related to temperature. Both electrical conductivity and internal friction give rise to an abnormal at about 75 °C, which are related to the insulator-metal transition occurring in GdBaCo₂O_5 + δ. One large relaxation internal friction peak, due to the motion of oxygen within Gd-O plane, is also found in the oxide. The average thermal expansion coefficient (TEC) of GdBaCo₂O_5 + δ is about 21.4 × 10⁻⁶ K⁻¹ between 500 °C and 900 °C.     

Designing N-halamine based antibacterial surface on polymers: Fabrication, characterization, and biocidal functions

We demonstrate a valuable method to generate reactive groups on inert polymer surfaces and bond antibacterial agents for biocidal ability. Polystyrene (PS) surfaces were functionalized by spin coating of sub-monolayer and monolayer films of poly(styrene-b-tert-butyl acrylate) (PS-PtBA) block copolymer from solutions in toluene. PS-PtBA self-assembled to a bilayer structure on PS that contains a surface layer of the PtBA blocks ordering at the air-polymer interface and a bottom layer of the PS blocks entangling with the PS substrate. The thickness of PtBA layer could be linearly controlled by the concentration of the spin coating solution and a 2.5 nm saturated monolayer coverage of PtBA was achieved at 0.35% (w/w). Carboxyl groups were generated by exposing the tert-butyl ester groups of PtBA on saturated surface to trifluoroacetic acid (TFA) to bond tert-butylamine via amide bonds that were further chlorinated to N-halamine with NaOCl solution. The density of N-halamine on the chlorinated surface was calculated to be 1.05 × 10⁻⁵ mol/m² by iodimetric/thiosulfate titration. Presented data showed the N-halamine surface provided powerful antibacterial activities against Staphylococcus aureus and Escherichia coli. Over 50% of the chlorine lost after UVA irradiation could be regained upon rechlorination. This design concept can be virtually applied to any inert polymer by choosing appropriate block copolymers and antibacterial agents to attain desirable biocidal activity.     

Mie-Grüneisen状态方程下多介质守恒型欧拉方程组的数值计算

针对Mie-Grüneisen状态方程下的多介质流场,将Euler方程中的部分复杂参数作为守恒量引入到新的方程中,使原方程结构得到简化.同时引入质量分数以表示流场中不同介质的变化,并对通量作近似处理,再利用MUSCL-TVD格式结合改进过的Euler方程进行求解,模拟Mie-Grüneisen状态方程下多介质相互作用的情况.结果表明,通过本方法既能使方程组满足守恒,又能较好地处理多种介质形成的间断面.     

Maskless laser tailoring of conical pillar arrays for antireflective biomimetic surfaces

Herein, we report a facile approach for rapid and maskless production of subwavelength structured antireflective surfaces with high and broadband transmittance-direct laser interference ablation. The interfered laser beams were introduced into the surface of a bare optical substrate, where structured surfaces consisting of a micropillar array were produced by two-step laser irradiation in the time frame of seconds. A multiple exposure of the two-beam interference approach was proposed instead of multiple-beam interference to simply realize planar patterns of a high aspect ratio. Tall sinusoidal pillars were created and shaped by pulse shot number control. As an example of the application, zinc sulfide substrates were processed with the technology, from which high transmission at an infrared wavelength, over 92%, at normal incidence was experimentally achieved.     

Volume polarization holographic recording in thick phenanthrenequinone-doped poly(methyl methacrylate) photopolymer

Volume polarization holographic recording in phenanthrenequinone-doped poly (methyl methacrylate) photopolymer is obtained. Photoinduced birefringence in a 2 mm thick sample is measured by a phase-modulated ellipsometry. The birefringence induced in this material by linearly polarized beam at 514 nm reaches 1.2×10(-5). In addition, ability for recording volume polarization grating using two different polarization configurations is demonstrated and compared. The experimental results show that the diffraction efficiency of the hologram reaches to ～40% by using two orthogonal circularly polarized beams.     

水平层状介质中电磁场并矢Green函数的一种快速新算法

本文利用提取直射波并结合自适应数字滤波等技术提出一种计算水平层状介质中电磁场并矢Green函数的快速算法. 首先将谱域Green函数中表征均匀介质作用的直射波提取出来并对其积分进行解析计算,这种处理降低了谱域Green函数的奇异性,可在很大程度上缩短其积分收敛区间. 然后在将谱域Green函数剩余部分对应积分转化为三个快速下降积分的基础上,引入一种自适应数字滤波算法对其进行快速求解. 最后通过具体算例验证了本文所述算法的有效性. 关键词： 并矢Green函数 快速算法 水平层状介质     

基于HJ-1-CCD数据的地表反射率反演与验证

环境一号卫星OCD相机(HJ-1-CCD)30m的空间分辨率在地物识别中具有潜在优势,然而由于缺少短波红外通道,利用暗像元法反演地表反射率较为困难.基于北京与珠三角地区的地物光谱试验,获得暗像元的植被指数与红、蓝波段反射率比值,构建基于辐射传输模型的大气校正算法.为了验证算法精度,将北京地区卫星反演值与实测的草坪、水体...     

Controlled release of ketorolac through nanocomposite films of hydrogel and LDH nanoparticles

A novel nanocomposite film for sustained release of anionic ophthalmic drugs through a double-control process has been examined in this study. The film, made as a drug-loaded contact lens, consists principally of a polymer hydrogel of 2-hydroxyethyl methacrylate (HEMA), in whose matrix MgAl-layered double hydroxide (MgAl-LDH) nanoparticles intercalated with the anionic drug are well dispersed. Such nanocomposite films (hydrogel-LDH-drug) contained 0.6–0.8 mg of MgAl-LDH and 0.08–0.09 mg of the ophthalmic drug (ketorolac) in 1.0 g of hydrogel. MgAl-drug-LDH nanoparticles were prepared with the hydrodynamic particle size of 40–200 nm. TEM images show that these nanoparticles are evenly dispersed in the hydrogel matrix. In vitro release tests of hydrogel-LDH-drug in pH 7.4 PBS solution at 32 °C indicate a sustained release profile of the loaded drug for 1 week. The drug release undergoes a rapid initial burst and then a monotonically decreasing rate up to 168 h. The initial burst release is determined by the film thickness and the polymerization conditions, but the following release rate is very similar, with the effective diffusion coefficient being nearly constant (3.0 × 10⁻¹² m²/s). The drug release from the films is mechanistically attributed to anionic exchange and the subsequent diffusion in the hydrogel matrix.