具有纵向辅助耗尽衬底层的新型横向双扩散金属氧化物半导体场效应晶体管

为了优化横向双扩散金属氧化物半导体场效应晶体管(lateral double-diffused MOSFET,LDMOS)的击穿特性及器件性能,在传统LDMOS结构的基础上,提出了一种具有纵向辅助耗尽衬底层(assisted depletesubstrate layer,ADSL)的新型LDMOS.新加入的ADSL层使得漏端下方的纵向耗尽区大幅向衬底扩展,从而利用电场调制效应在ADSL层底部引入新的电场峰,使纵向电场得到优化,同时横向表面电场也因为电场调制效应而得到了优化.通过ISE仿真表明,当传统LDMOS与ADSL LDMOS的漂移区长度都是70μm时,击穿电压由462 V增大到897 V,提高了94%左右,并且优值也从0.55 MW/cm~2提升到1.24 MW/cm~2,提升了125%.因此,新结构ADSL LDMOS的器件性能较传统LDMOS有了极大的提升.进一步对ADSL层进行分区掺杂优化,在新结构的基础上,击穿电压在双分区时上升到938 V,三分区时为947 V.     

机载腔增强吸收光谱系统应用于大气NO_2空间高时间分辨率测量

介绍了一套用于机载平台测量的非相干宽带腔增强吸收光谱(IBBCEAS)系统,并应用于实际大气NO_2空间分布的高时间分辨率观测.为满足机载测量中对时间分辨率的需求,系统采用离轴抛物面镜代替消色差透镜提高光学耦合效率;并运用Allan方差,对系统性能进行了分析.通过腔增强吸收光谱系统与长光程吸收光谱系统对实际大气NO_2的对比测试,两者线性相关系数R~2达到0.86.将IBBCEAS系统应用于机载平台,在时间分辨率为2 s的情况下,探测限达到95 ppt(1σ).通过机载观测,获得了华北地区石家庄等地上空对流层大气NO_2的廓线信息.     

载流子选择性接触:高效硅太阳电池的选择

太阳电池可看成由光子吸收层和接触层两个基本单元组成,接触层是高复合活性金属界面和光子吸收层之间的区域.为了进一步提高硅太阳电池的转换效率,关键是降低光子吸收层和接触之间的复合损失.近年来,载流子选择性接触引起了光伏界的研究兴趣,其被认为是接近硅太阳电池效率理论极限的最后的障碍之一.本文分析了三种类型的载流子选择性接触:在光子吸收层与金属界面之间引入薄的重掺杂层,即所谓的发射极或背面场;利用两种材料之间的导带或价带对齐;利用高功函数的金属氧化物与晶硅接触从而在晶硅中感应能带弯曲.基于一维太阳电池模拟软件wx AMPS,模拟了扩散同质结硅太阳电池[结构为(p~+)c-Si/(n)c-Si/(n~+)c-Si]、非晶硅薄膜硅异质结太阳电池[结构为(p~+)a-Si/(i)a-Si/(n)c-Si/(i)a-Si/(n~+)a-Si]和氧化物薄膜硅异质结太阳电池[结构为(n)MoO_x/(n)c-Si/(n)TiO_x]暗态下的能带结构和载流子浓度的空间分布,其中c-Si为晶硅;a-Si为非晶硅;(i),(n)和(p)分别表示本征、n型掺杂和p型掺杂.模拟结果表明:载流子选择性接触的核心是在接触处晶硅表面附近形成载流子浓度空间分布的不对称进而使得电导率的不对称,形成了对电子的高阻和空穴的低阻或者对空穴的高阻和电子的低阻,从而让空穴轻松通过同时阻挡电子,或者让电子轻松通过同时阻挡空穴,形成空穴选择性接触或者电子选择性接触.     

Structural and electronic properties of potassium-doped 1,2;8,9-dibenzopentacene superconductor: comparing with doped [7]phenacenes

Polycyclic aromatic hydrocarbons doped by metal have exhibited the potential of high temperature superconductivity. Understanding the basic properties of materials is the key to reveal the superconductivity. Here, a systemically theoretical study has been done to explore crystal structures and electronic properties of pristine and potassium-doped 1,2;8,9-dibenzopentacene, compared with [7]phenacenes case. We determined that vdW-DF2 functional is more suitable to describe the non-local interaction in a molecular crystal. Based on this functional, we predicted the crystal structures and investigated in detail the K atomic positions in a system. It was found that the intralayer doping leads to lower total energy. From the calculated formation energy, for each 1,2;8,9-dibenzopentacene molecule, the doping of two electrons is more stable under the relatively K-poor condition while the doping of four electrons is more stable under the K-rich condition. Between these two phases, the three-electron doping phase stabilises in a narrow region of K chemical potential. Combining with the electronic states at Fermi level, we analysed the reasons of superconductivity enhancement in doped 1,2;8,9-dibenzopentacene. This work further deepens the understanding of 1,2;8,9-dibenzopentacene superconductor.     

A comparison of different approaches to integrate flamelet tables with presumed-shape PDF in flamelet models for turbulent flames

Flamelet models for turbulent combustion modelling make use of presumed-shape probability density functions (PDFs) for integrating laminar flamelet solutions to obtain an integrated flamelet table that can readily be used for turbulent flame calculations. The existence of non-unique approaches for such an integration has rarely been investigated before. For the first time, this work studies systematically the non-uniqueness of the flamelet table integration approaches. A flamelet model called the flamelet/progress variable model is used in the study, although the issue exists generally in many other flamelet models. Two classes of table integration approaches are investigated, one preserving the laminar flamelet structures during integration and the other not. Three different table integration approaches are examined and compared in detail to provide a thorough understanding of the different approaches. A partially stirred reactor is used as a test case for examining the different approaches. A method based on the transported PDF method is also employed to provide a reference for the assessment of the different flamelet table integration approaches. It is found in general that the flamelet preserving integration approach yields a more reasonable joint PDF of the mixture fraction and the progress variable, and the prediction results are closer to the referenced transported PDF results.     

Tens of GHz Tantalum pentoxide‐based micro‐ring all‐optical modulator for Si photonics

A tantalum pentoxide‐based (Ta₂O₅‐based) micro‐ring all‐optical modulator was fabricated. The refractive index inside the micro‐ring cavity was modified using the Kerr effect by injecting a pumped pulse. The transmittance of the ring resonator was controlled to achieve all‐optical modulation at the wavelength of the injected probe. When 12 GHz pulses with a peak power of 1.2 W were coupled in the ring cavity, the transmission spectrum of the Ta₂O₅ resonator was red‐shifted by 0.04 nm because of the Kerr effect. The relationship between the modulation depth and gap of the Ta₂O₅ directional coupler is discussed. An optimized gap of 1100 nm was obtained, and a maximum buildup factor of 11.7 with 84% modulation depth was achieved. The nonlinear refractive index of Ta₂O₅ at 1.55 μm was estimated as 3.4 × 10^?14 cm²/W based on the Kerr effect, which is almost an order of magnitude higher than that of Si₃N₄. All results indicate that Ta₂O₅ has potential for use in nonlinear waveguide applications with modulation speeds as high as tens of GHz.

     

Effect of bromine substituent on optical properties of aryl compounds

Substituents significantly affect optical properties of organic compounds. In this study, a series of organic compounds were synthesized. Ultraviolet‐visible and cyclic voltammetry spectra were determined. The relationships between the number of π electron in an aryl ring and the redshift (and molecular orbital energy levels) were studied. To investigate mechanisms of the bromine substituent effects, theoretical calculations were carried out. Ultraviolet‐visible spectra of bromine‐containing compounds exhibit obvious redshifts (0.04‐0.17 eV) of the maximal absorption wavelengths and enhanced absorbance (11%‐57%) compared with corresponding reference compounds. The lowest unoccupied and highest occupied molecular orbital energy levels of compounds containing bromine substituents are 0.05 to 0.60 and 0.02 to 0.40 eV lower than that of corresponding reference compounds. On the whole, the redshifts and the reduced molecular orbital energy levels caused by bromine substituent decrease with the increase in the number of π electron in an aryl ring. The effects would be attributed to strong p‐π conjugation between p electron in the bromine substituent and π electrons in aryl rings. Therefore, this paper suggests a useful way for tuning optical absorption and molecular orbital energy levels of aryl compounds.     

Yolk–Shell‐Structured Cu/Fe@γ‐Fe2O3 Nanoparticles Loaded Graphitic Porous Carbon for the Oxygen Reduction Reaction

Core–shell Cu/γ‐Fe₂O₃@C and yolk–shell‐structured Cu/Fe@γ‐Fe₂O₃@C particles are prepared by a facile synthesis method using copper oxide as template particles, resorcinol‐formaldehyde as the carbon precursor, and iron nitrate solution as the iron source via pyrolysis. With increasing carbonization temperature and time, solid γ‐Fe₂O₃ cores are formed and then transformed into Fe@γ‐Fe₂O₃ yolk–shell‐structured particles via Ostwald ripening under nitrogen gas flow. The composition variations are studied, and the formation mechanism is proposed for the generation of the hollow and yolk–shell‐structured metal and metal oxides. Moreover, highly graphitic carbons can be obtained by etching the metal and metal oxide nanoparticles through an acid treatment. The electrocatalytic activity for oxygen reduction reaction is investigated on Cu/γ‐Fe₂O₃@C, Cu/Fe@γ‐Fe₂O₃@C, and graphitic carbons, indicating comparable or even superior performance to other Fe‐based nanocatalysts.     

A three‐crystal spectrometer for high‐energy resolution fluorescence‐detected X‐ray absorption spectroscopy and X‐ray emission spectroscopy at SSRF

A Johann‐type spectrometer for the study of high‐energy resolution fluorescence‐detected X‐ray absorption spectroscopy, X‐ray emission spectroscopy and resonant inelastic X‐ray scattering has been developed at BL14W1 X‐ray absorption fine structure spectroscopy beamline of Shanghai Synchrotron Radiation Facility. The spectrometer consists of three crystal analyzers mounted on a vertical motion stage. The instrument is scanned vertically and covers the Bragg angle range of 71.5–88°. The energy resolution of the spectrometer ranges from sub‐eV to a few eV. The spectrometer has a solid angle of about 1.87 × 0^?3 of 4π sr, and the overall photons acquired by the detector could be 10⁵ counts per second for the standard sample. The performances of the spectrometer are illustrated by the three experiments that are difficult to perform with the conventional absorption or emission spectroscopy. Copyright © 2016 John Wiley & Sons, Ltd.     

Transport and abatement of fluorescent silica nanoparticle (SiO<Subscript>2</Subscript> NP) in granular filtration: effect of porous media and ionic strength

The extensive production and application of engineered silica nanoparticles (SiO₂ NPs) will inevitably lead to their release into the environment. Granular media filtration, a widely used process in water and wastewater treatment plants, has the potential for NP abatement. In this work, laboratory-scale column experiments were performed to study the transport and retention of SiO₂ NPs on three widely used porous materials, i.e., sand, anthracite, and granular activated carbon (GAC). Synthetic fluorescent core-shell SiO₂ NPs (83 nm) were used to facilitate NP detection. Sand showed very low capacity for SiO₂ filtration as this material had a surface with limited surface area and a high concentration of negative charge. Also, we found that the stability and transport of SiO₂ NP were strongly dependent on the ionic strength of the solution. Increasing ionic strength led to NP agglomeration and facilitated SiO₂ NP retention, while low ionic strength resulted in release of captured NPs from the sand bed. Compared to sand, anthracite and GAC showed higher affinity for SiO₂ NP capture. The superior capacity of GAC was primarily due to its porous structure and high surface area. A process model was developed to simulate NP capture in the packed bed columns and determine fundamental filtration parameters. This model provided an excellent fit to the experimental data. Taken together, the results obtained indicate that GAC is an interesting material for SiO₂ NP filtration.