云计算环境下人脸表情智能识别改进技术研究

随着人脸识别技术的开发,对于如何提高人脸表情智能识别改进技术的研究也越来越多;如何提高人脸识别的准确度和完整度是当前发展的主要需要,而计算机云计算功能在人脸识别中的应用在一定程度上解决了此问题;通过改进细菌觅食算法,再将其应用到主要成分分析算法对图像基本特征进行提取分析;通过以上的算法输入计算机网络云储存当中,实现云计算技术在人脸识别中的应用;文章将通过对于算法部署函数的办法进行图片解析工作,并且利用智能人脸识别软件对图像进行抽丝、分类、匹配等工作进行功能状态进行测试;实验结果表明利用云计算技术通过连接网络云计算系统可以对目前的人脸识别以及分类做到更高的准确性和适应性。     

The colloidal stability and core-shell structure of magnetite nanoparticles coated with alginate

The adsorption of alginate (Alg) onto the surface of in water dispersed Fe₃O₄ nanoparticles and zeta potential of alginate-coated Fe₃O₄ nanoparticles have been investigated to optimize the colloidal stability of Alg-coated Fe₃O₄ nanoparticles. The adsorption amount of Alg increased with the decrease of adsorption pH. The zeta potential of Fe₃O₄ nanoparticles shifted to a lower value after adsorption of Alg. The lower adsorption pH was the lower zeta potential of Fe₃O₄ nanoparticles became. The Alg-coated Fe₃O₄ nanoparticles were found to be stabilized by steric and electrostatic repulsions. Those prepared at pH 6 were not stable around pH 5, and those prepared at pH 4 became unstable at pH below 3.5. Alg of M_w 45 kDa was a little bit more adsorbed onto nanoparticles surface than that of M_w 24 kDa. An average Fe₃O₄ core size of 9.3 ± 1.7 nm was found by transmission electronic microscopy. An average hydrodynamic diameter of 30-150 nm was measured by photon correlation spectroscopy. However, an average core size of 10 nm and an average hydrodynamic diameter of 38 nm were estimated from the magnetization curve of the concentrated magnetic fluids (MFs). The maximum available saturation magnetization of MFs was about 3.5 kA/m.     

CuCrZr合金质子辐照效应的模拟研究

基于Monte Carlo方法,跟踪一大批入射粒子的运动,模拟1~10 Me V质子辐照下质子与CuCrZr合金的相互作用,计算出合金的阻止本领、能量传递、能量损失、射程、空位分布情况以及合金的辐照损伤分别与辐照深度、质子能量的关系,通过模拟CuCrZr合金在聚变反应中的工作环境,分析热沉材料的失效机理.研究结果表明:质子能量在1~10 Me V时,质子与CuCrZr合金发生非弹性碰撞,能量损失以电离能损失为主,表现出很好的抗辐照性能;质子在合金中的峰值深度随质子能量增加而增加,且近似指数关系,峰值深度为2~250μm;入射质子能量达到Me V级别时,溅射产额为零,CuCrZr合金可以很好的避免器壁的侵蚀;合金中空位的个数与入射质子能量呈线性关系,合金中空位和质子在合金中的分布具有同步性;质子损伤效率在合金深度方向呈现高斯分布,损伤最大值位置与辐照深度接近,随着入射质子能量的增加损伤效率最大值不断减小.     

密度泛函理论研究纯的及不同掺杂原子石墨烯和CaH_2分子相互作用

本研究采用密度泛函理论研究了纯的及V,Fe,Ni,Pd,Si,P,S和Cl掺杂原子的石墨烯和CaH_2分子之间相互作用.研究结果发现CaH_2分子与所有石墨烯表面均具有较大的相互作用,而CaH_2分子与掺杂石墨烯相互作用都大于与纯石墨烯的相互作用,在所有掺杂原子中,其中与Pd掺杂石墨烯具有最大的相互作用,S次之,其它掺杂石墨烯与CaH_2分子相互作用能力相差不大.这些结果表明虽然所有石墨烯均有助于CaH_2中H原子的脱附,但掺杂石墨烯脱附能力仍然大于纯的石墨烯.在掺杂原子中,Pd和S掺杂石墨烯对CaH_2中H原子的脱附效果最好,其它的掺杂原子脱附效果相差不明显.此研究结果将有望为CaH_2分子在石墨烯基材料中吸氢-脱氢行为提供有用的理论参考价值.     

基于通用模块化的大型空间飞行器地面供配电系统设计

地面供配电系统一直存在体积过于庞大、系统通用性稳定性差问题。基于通用模块化的设计方案,从基本功能实现模块的角度,将系统划分为功率继电器模块、信号继电器模块、PXI控制模块、地面电缆模块、软件实现模块等,通过对这些模块的通用性设计及部分软硬件功能的整合,实现了减少系统体积规模、加大系统集成化及小型化程度、提高系统间通用性及鲁棒性的目的。     

光学空间滤波过程的计算机仿真

提出了一种利用MATLAB软件并通过计算机仿真光学空间滤波实验过程的新方法.其特点是:既可以随意改变所设计滤波器的参量,又可以对输入图象进行振幅、相位或复合滤波,并且可实现傅里叶变换频谱中相位信息的提取、存储和利用,因而能够完成一般光学实验中往往难以实现的某些操作.并分别给出了网格滤波、低通、高通及相位滤波等仿真实验结果.这种仿真实验给光学滤波器的设计和图象处理带来很大方便,同时也为相关器件的设计提供了一条新的途径.     

类Kerr介质中双模SU(1,1)相干态场与Λ型三能级原子相互作用的量子统计性质

导出了类Kerr介质中双模SU(1,1)相干态场与Λ型三能级原子相互作用系统的态函数,研究了Kerr效应对Λ型三能级原子布居概率、双模SU(1,1)相干态场的互关联函数、Cauchy-Schwartz不等式及二阶相干度的影响.结果表明:Kerr效应使原子与光场的耦合减弱,原子布居的崩塌与复苏的周期缩短;在初始光场较弱和较强两种情况下,类Kerr介质对双模SU(1,1)相干态场两模间的相关性、相关程度以及光子的聚束与反聚束效应产生的作用有明显的区别.     

利用振幅调制器进行光电负反馈抑制激光强度噪声

采用振幅调制器作为抑制激光强度噪声的元件，首先对光电负反馈回路进行了简要的理论分析，然后利用该光电负反馈进行抑制激光二极管抽运全固化单频环形Nd:YVO4红外激光器强度噪声的实验。结果表明，在0－1MHz的低频段，强度噪声大幅度降低，最大降低约15dB。     

Study of nanocrystalline Fe－Al－N soft magnetic thin films

Fe－Al－N films were fabricated by reactive sputtering using a radio-frequency magnetron sputtering system. The effects of Al and N content and annealing temperature on microstructure and magnetic properties were investigated. The Fe－Al－N films, which have good soft magnetic properties, consist of nanocrystalline α-Fe grains and a small amount of other phases in the boundaries of α-Fe grains. The average α-Fe grain size is about 10－15nm. A slight amount of Fe－N and Al－N compounds precipitate in the boundaries of α-Fe grains and suppress their growth. Annealing improves the soft magnetic properties slightly by releasing the residual stress and reducing defects.     

Superconductivity and x—ray photoemission study of MgB2 thin films

Highly c-axis oriented MgB2 thin films with Tc^onset of 39.6K were fabricated by magnesium diffusing into pulsedlaser-deposited boron precursors.The estimation of critical current density Jc,using hysteresis loops and the Bean model,has given the value of 10^7A/cm^2(15K,0T),which is one of the highest values ever reported.The x-ray photoemission study of the MgB2 thin films has revealed that the binding energies of Mg 2p and B 1s are at 49.4eV and 186.9eV,which are close to those of metallic Mg and transition-metal diborides,respectively.