若干锰(Ⅲ)希夫碱配合物的合成和表征

合成了六种锰(Ⅲ)希夫碱配合物:Mn(bzacem)X(X~-=Cl~-,Br~-,I~-,NCS~-,NO_2~-)和Mn(bzacen)ClO_4·2H_2O,其中bzacen~(2-)为N,N′-二(苯甲酰丙酮缩)-乙二胺阴离子.用NMR法测定配合物在DMSO溶液中的有效磁矩值为4.46—4.63,表明为高自旋配合物,将电子光谱中的吸收带分别按配位场带、荷移带和配体带进行了归属,在配合物的红外光谱中,原配体H_2bzacen中的ν_(N-H)带消失,ν_(C-O)带移向低频,并对Mn-O、Mn-N和Mn-X的伸缩带进行了归属。     

Mn_3O(Salea)_2(C_2H_3O_2)_3·HC_2H_3O_2的合成、表征及放氧活性测定

合成了三核锰(Ⅲ)Schiff碱配合物:Mn_3O(Salea)_2(C_2H_3O_2)_3·HC_2H_3O_2(其中Salea~(2-)为水杨醛缩乙醇胺Schiff碱阴离子),经元素分析、磁矩、化合价、电导率、热分析、红外、紫外光谱等进行表征,并利用氧电极进行了放氧活性测试,发现在对苯醌存在下配合物能促使水分解释放氧气,其反应受温度、对苯醌和配合物浓度等因素影响,并提出了可能的放氧反应方程.     

对硝基氯苄与活性亚甲基化合物的反应

对硝基苄基衍生物可以与许多阴离子起单电子转移的亲核取代反应。Kornblum等以对硝基氯苄为底物,2-乙氧羰基香豆满-3-酮的钠盐为阴离子,作了深入的研究,得出对硝基氯苄与2-乙氧羰基香豆满-3-酮钠盐的C-烷化反应机理为自由基链式亲核取代反应。同时,Russell等提出对硝基氯苄与2-     

REDUCING NONSELECTIVE PROTEIN ADSORPTION AND CELL ADHESION ON POLYACRYLONITRILE FILMS BY COPOLYMERIZATION OF ACRYLONITRILE WITH α-ALLYL GLUCOSIDE

In this work, the surface properties of novel sugar-containing polymers, α-allyl glucoside (AG)/acrylonitrile (AN)copolymers, were studied by contact angle, protein adsorption and cell adhesion measurements. It was found that the contactangle of the copolymer films decreased from 68° to 30° with the increase of AG content in the copolymer. The adsorptionamount of bovine serum albumin (BSA) and the adhesive macrophage onto the film surface also decreased significantly withincreasing α-allyl glucoside content from 0 to 42 wt% in the copolymer. These preliminary results reveal that both thehydrophilicity and the biocompatibility of polyacrylonitrile-based membranes could be improved by copolymerizing acrylonitrile with vinyl carbohydrates.     

A New Saponin Transformed from Ginsenoside Rh1 by Bacillus subtilis

A novel saponin was isolated from the transformed products of ginsenoside Rh1 by Bacillus subtilis. It‘s structure was determined to be 3-O-β-D-glucopyranosyl-6-O-β-D-glucopyranosyl-20 (S)-protopanaxatriol on the basis of the spectral data.     

Comparison of quantitative methods for analysis of polyphasic pharmaceuticals

Adequate very sensitive quantification methods are needed for the development and are also now required for the monitoring of undesirable solid form(s) as routine tests. The pre-requisite for quantitation are selectivity, sensitivity and most important the purity of standards and their proper storage, what is a challenge for metastable forms. Several analytical techniques are available such as X-ray diffraction, spectroscopy, thermal analysis and microcalorimetry. The different steps of the validation of the analytical methods and problems to be solved are discussed. Examples illustrate the different techniques and compare their possible advantages and limits. The relative standard deviation of measurements should allow for checking the homogenization procedure of mixtures for calibration. The validation should be carried out following ICH guidelines for validation of analytical methods. Comparison of different techniques in adequate concentration range add confidence in the analytical results.     

Temperature influence on hydrogen sorption in palladium limited-volume electrodes (Pd-LVE)

The effect of temperature on hydrogen and deuterium electrosorption into a palladium LVE (limited-volume electrode) has been investigated. A decrease in hydrogen capacity (H/Pd ratio) with increasing temperature has been observed. Temperature strongly influences the plots of measured H(D)/Pd values vs. potential scan rate. In addition, hydrogen absorption was found to be dependent on the composition of the surrounding electrolyte solution. These results have confirmed the hypothesis that two different mechanisms of hydrogen desorption from the palladium electrode take place, namely electrochemical oxidation and non-electrochemical recombination. Further, the ratio between the rate constants for these two processes has been found to change with temperature. Electronic Publication     

Kinetics of thermal decomposition of alkaline phosphates

Summary The thermal behavior of KH₂PO₄, NaH₂PO₄ and Na₂HPO₄ under non-isothermal conditions using TG method with different heating rates was studied. The values of the reaction rate were processed by means of Friedmans differential-isoconversional method. A dependence of the activation energy vs. conversion was observed. Therefore a procedure based on the compensation effect (suggested by Budrugeac and Segal) was applied. A less speculative data processing protocol was offered by the non-parametric kinetics method suggested by Serra, Nomen and Sempere. Three steps were observed by non-isothermal heating: a dehydration, a dimerization and a polycondensation. The differences in the intimate reaction mechanism are determined by the initial number of water molecules.