用L-脯氨酸衍生物作为手性流动相添加剂拆分对映异构体

用自制的N-十二酰基-L-脯氨酸和N-十二酰基-L-脯氨酸-3，5-二甲基苯胺两种L-脯氨酸衍生物作手性流动相添加剂，在氨丙基硅烷化硅胶柱上，用正己烷／异丙醇作流动相，对多种手性化合物进行了高效液相色谱拆分。实验结果表明：用N-十二酰基-L-脯氨酸作添加剂拆分的12种手性化合物，有8种手性化合物能得到拆分，具有较好的手性选择性。虽然用N-十二酰基-L-脯氨酸-3，5-二甲基苯胺作添加剂，手性选择性也较好，但由于含有苯环，紫外吸收增强，基线波动严重。     

Influence of the exchange‐correlation functional in all‐electron calculations of the vibrational frequencies of corundum (α‐Al2O3)

The equilibrium structural parameters, high‐ and low‐frequency dielectric tensors, Born effective charges, and Γ‐point vibrational frequencies of bulk Al₂O₃ corundum are calculated by using the periodic, ab initio program CRYSTAL, which adopts an all‐electron Gaussian‐type basis set. The effect of basis set and the performance of three different functionals, i.e., LDA, PW91, and B3LYP, are discussed. The mean absolute deviation from the measured frequencies is as small as 7 cm^?1 for both the LDA and B3LYP functionals, indicating that these functionals perform extremely well in this case. The mean absolute deviation increases to 18 cm^?1 when the PW91 functional is used. All three functionals reproduce the equilibrium geometry of corundum to a high level of accuracy, with LDA and B3LYP outperforming PW91 slightly. The comparison of the current all‐electron calculations with previous plane‐wave, pseudo‐potential calculations shows an overall similar performance. The results of isotopic substitution for both Al and O are also presented. © 2006 Wiley Periodicals, Inc. Int J Quantum Chem, 2006     

Superabsorbent hydrogel composites

A new cost‐effective approach to enhance gel strength of superabsorbent hydrogels was invented. Superabsorbent hydrogel composites (SHCs) were prepared through an optimized rapid solution polymerization of concentrated partially neutralized acrylic acid in the presence of a crosslinking agent under normal atmospheric conditions. Kaolin was used as an inorganic component in the polymerization process to strengthen the hydrogel products. FT‐IR spectroscopy was used to confirm grafting of acrylic chains on to the surface of kaolin particles. Morphology of the products was studied by scanning electron microscopy (SEM). Compared with the kaolin‐free hydrogel (control), kaolin caused a reduced equilibrium swelling and swelling rate as low as 17–31% and 19–29%, respectively. Kaolin, however, resulted in enhanced gel strength as high as 21–35% compared to the control. Differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA) were used to study thermal properties of the composites. The SHCs exhibited higher thermal stability than the control. Meanwhile, changes in certain thermal transitions reconfirmed the chemical interaction of the acrylic chain with kaolin. These thermostabilized strengthened superabsorbent hydrogels may be considered as good candidates for agricultural application to retain more water under soil pressure. Copyright © 2003 John Wiley & Sons, Ltd.     

Carbon‐based Nanosensors for Salicylate Determination in Pharmaceutical Preparations

Thiourea derivative‐based carbon paste electrode (TUD1‐CPE) was constructed as a potentiometric sensor for the determination of salicylate anion in pharmaceutical formulations, Aspocid® and Aspirin®. The optimized CPE contained 45.5 % graphite, 0.5 % reduced graphene oxide (rGO), 46.0 % nitrophenyl octyl ether (NPOE) plasticizer, 5.0 % TUD1 ionophore, and 3.0 % tridodecylmethyl ammonium chloride as additive. The incorporation of NPOE of high dielectric constant, and rGO in electrode caused better performance of the sensor; Nernstian response of 59.0 mV decade^?1 in the concentration range of 10^?1–10^?5 mole L^?1, a detection limit of 1×10^?5 mole L^?1 in a very short response time of 6 seconds. The prepared sensor showed high selectivity against similar anions (i. e. , benzoate, I^?, SCN^?). Selectivity was confirmed by calculating the formation constant (K_β) using sandwich membrane method, where K_β for TUD1‐salicylate is 10^0.43. Theoretical calculations at DFT‐B3LY/6‐31G** level of theory were performed to find interaction mechanism, Energies of HOMO and LUMO orbitals, non‐linear optical (NLO) properties (the electronic dipole moment (μ), first‐order hyperpolarizability (β), the hyper‐Rayleigh scattering (β_HRS) and the depolarization ratio (DR)), and other global properties; these calculations showed lower values of β and DR, higher value of β_HRS, and the shortest lengths of the four N?H bonds between TUD1 and salicylate which confirm their strong complexation and salicylate‐selectivity. Also, all the studied anion‐TUD1 exhibited relatively high NLO properties, and these results were considered as a preliminary study for investigating new types of NLO bearing materials. The sensors were applied successfully for the determination of salicylate anion in Aspocid® and Aspirin®.     

Cycloarsanes (AsCF3)n (n = 4, 5) – Precursors for the Highly Reactive Diarsene F3CAs=AsCF3

Tetrakis(trifluoromethyl) cyclotetraarsane (F₃CAs)₄ ( 2 ) was used to repeat the UV initiated [4+2]‐cycloaddition reaction of the diarsene F₃CAs=AsCF₃ ( 1 ) with cyclohexa‐1,3‐diene (CHD) and to isolate single crystals of the cycloadduct 4 for a X‐ray diffraction analysis. 4 crystallizes in the space group and contains the diarsene group in its E‐configuration. 2 was also applied for [2+2]‐cycloaddition reactions of 1 with tBuC≡P and MeC≡CNⁱPr₂, but in contrast to positive results with (F₃CP)₄ the products were too labile for isolation. However, 2 was successfully used at room temperature as precursor for coordinating 1 as π‐donor ligand to the Pd(PPh₃)₂ complex fragment yielding η²‐bis(trifluoromethyl)diarsene‐bis(triphenylphosphane)‐palladium(0) 5 , which was characterized by X‐ray diffraction of single crystals and by spectroscopic investigations (NMR, IR, MS). Attempts to prove the existence of the diarsene 1 , generated by different methods, by spectroscopic studies very probably failed due to its extreme reactivity, not allowing the necessary concentrations for detection. Quantum chemical calculations of the stability of 1 with respect to dimerization, the stability of the [2+2]‐cycloadduct with 1‐di(isopropyl)aminopropyne and the energy difference between 4 and the 2,3‐dimethyl‐1,3‐butadiene cycloadduct of 1 were performed to understand the considerable differences between 1 and the related diphosphene F₃CP=PCF₃.     

On the Proper Normalization Constraint

In the variational optimization of a trial function the proper functional to be varied is the Rayleigh quotient with the normalization constraint explicitly imposed. It will be shown that only under certain very rigorous conditions can one use the energy functional to replace the Rayleigh quotient and that, therefore, the normalization constraint is by no means a matter of no consequence.     

Meso-tetraaryl cofacial bisporphyrins delivered by Suzuki cross-coupling

The Suzuki cross-coupling methodology provides a facile synthetic approach for the modular preparation of meso-tetraaryl cofacial bisporphyrins anchored by xanthene and dibenzofuran. This synthetic method furnishes cofacial bisporphyrin templates with enhanced steric and electronic protection from mu-oxo formation and oxidative degradation. The ability of these platforms to support multielectron oxidation chemistry mediated by proton-coupled electron transfer (PCET) is demonstrated by their reactivity for the catalytic disproportionation of hydrogen peroxide to oxygen and water.     

Preparation of Mullite Fibers by the Sol-Gel Method

Mullite fibers were synthesized from an aqueous solution of aluminum isopropoxide, aluminum nitrate and tetraethylorthosilicate by the Sol-Gel method. The starting solution was prepared by adding aluminum isopropoxide and tetraethylorthosilicate simultaneously to an aluminum nitrate aqueous solution. The spinnability of the starting solution was investigated by varying the molar ratio of aluminum isopropoxide/aluminum nitrate in the solution. Gel fibers were obtained from solutions in a composition range of aluminum isopropoxide/aluminum nitrate of 3 to 5. Gels obtained from spinnable solutions appeared to have high homogeneity in the mixing of the Al/Si components, leading to a sharp 980°C exothermic peak in the DTA curve and a mullitization temperature of 1000°C. However, in the case of gels obtained from unspinnable solutions, a small 980°C exothermic peak was detected, and the mullitization temperature was as high as 1200°C, probably due to greater heterogeneity in the mixing of the Al/Si components.     

Taxumairols X--Z,new taxoids from Taiwanese Taxus mairei

In addition to 19-dydroxybaccatin III, 1beta-hydroxy-5 alpha-deacetylbaccatin I, taxayuntin G and 13-O-deacetyltaxumairol Z (4), three new taxane diterpenoids, taxumairols X (1), Y (2), Z (3) have been isolated from extracts of the Formosan Taxus mairei (LEMEE & LEVL.) S. Y. HU. Compounds 1-2 belong to the 11(15-->1)-abeo-taxane system, having a tetrahydrofuran ring at C-2, C-3, C-4 and C-20. The new compound 3 and 4, which was misidentified previously are derivatives of 11(15-->1)-abeo-taxane with an intact oxirane system. The structures of compounds 1-4 were elucidated on the basis of extensive two dimensional (2D)-NMR analysis.     

New ceramides from the flower of Albizia iulibrissin

A new ceramide and its glycoside were isolated from the flower of Albizia julibrissin. Their structures were established as (25,35,4R,8E)-2-[(2'R)-hydroxyhexadecanoylamino]-8-tetra-cosene-l,3,4-triol(I)and 1-O-β-D-glucopyranosy1-(2S,3S,4R,8E)-2-[(2'R)-hydroxy-hexade-canoylamino]-8-tetracosene-1,3,4-triol (II) on the basis of chemical and spectroscopic studies.