Frequencies of Free Oscillations of a Truncated Spherical Sector Covered with a Thin Elastic Spherical Shell

An analytic solution of the problem concerning the frequencies and shapes of free axially symmetric oscillations of a truncated spherical sector filled with an ideal compressible fluid is constructed. A spherical wall of smaller radius and the radial wall of the sector are absolutely rigid. A thin elastic shell whose edge is clamped in the radial wall is located on a spherical boundary of larger radius. The outer surface of the shell borders vacuum. The phenomenon of an anomalous decrease in the fundamental frequency as the spherical walls approach each other is discovered. An approximate formula for determination of the lowest fundamental frequencies, which are approximately proportional to the square root of the difference of the radii of spherical walls for small values of this difference, is constructed and tested numerically. Bibliography: 13 titles.     

Surface free energies of electroless Ni–P based composite coatings

Surface free energy of a solid surface gives a direct measure of intermolecular interactions at interfaces and has a strong influence on adsorption and adhesion behaviour. However few data are available for the surface free energies of electroless Ni–P based composition coatings. In this paper, the electroless Ni–P, Ni–P-surfactant, Ni–Cu–P, Ni–P–PTFE and Ni–Cu–P–PTFE composite coatings were prepared under various coating conditions. The chemical compositions, surface morphology and thickness of the coatings were measured using an energy dispersive X-ray microanalysis (EDX), a scanning electron microscope (SEM) and a digital micrometer respectively. The contact angles of water, diiodomethane and ethylene glycol on the coatings were measured automatically using dataphysics OCA-20 contact angle analyser. The surface free energy of the coatings and their components (e.g. dispersion, polar or acid/base portions) were calculated using various methods. The experimental results showed that the incorporation of surfactant or PTFE particles into Ni–P matrixes has a significant influence on the surface free energy of the coatings, while the incorporation of copper into Ni–P matrixes has no significant influence on the surface free energy of the coatings.     

The effect of Mn substitution on thermoelectric properties of Ca3MnxCo4−xO9 at low temperatures

The effects of partial substitution of Mn for Co on the thermoelectric properties of Ca₃Mn_xCo_4−xO₉ (x=0, 0.03, 0.9), prepared by sol-gel process, were investigated at the temperatures from 380 K down to 5 K. The results indicate that the substitution of Mn for Co results in increase in thermopower at temperatures >∼80 K, and substantial (23-31% at 300 K) decrease in lattice thermal conductivity in the whole temperature range investigated. The temperature behavior of ZT suggests that Ca₃Mn_xCo_4−xO₉ with light Mn substitution would be a promising candidate for high-temperature thermoelectric applications.     

Fabrication and transport properties of multiwall carbon nanotube crossroads

A multiwall carbon nanotube crossroads has been fabricated by a manipulation technique using a glass microcapillary, and the low temperature transport properties investigated. The two-terminal conductance of an individual tube shows Tomonaga–Luttinger liquid behavior G∝T^α at high temperature and dI/dV ∝V ^α at low temperature. However, no evidence of such a power-law behavior is obtained in the four-terminal conductance at the junction, where the conductance shows an almost metallic behavior ‘corrected’ by weak localization. Weak localization would essentially appear in electron states at the junctions of MWNTs.     

Quadratic Integrals of Motion for the Systems of Identical Particles

The dynamical systems of identical particles admitting quadratic integrals of motion are classified. The relevant integrals are explicitly constructed and their relation to separation of variables in Hamilton-Jacobi equation is clarified.     

Hydrogen indium vacancy complex VInH4 in n-type InP studied by positron-lifetime

Positron-lifetime experiments have been carried out on two undoped n-type liquid encapsulated Czochralski (LEC)-grown InP samples with different stoichiometric compositions in the temperature range 10-300 K. For temperatures below 120 K for P-rich InP and 100 K for In-rich InP, the positron average lifetime began to increase rapidly and then leveled off, which was associated with the charge state change of hydrogen indium vacancy complexes from (V_InH₄)⁺ to (V_InH₄)⁰. This phenomenon was more obvious in P-rich samples that have a higher concentration of V_InH₄. The transformation temperature of approximately 120 K suggests that the complex V_InH₄ is a donor defect and that the ionization energy is about 0.01 eV. The ionization of neutral V_InH₄ accounted for the decrease of the positron average lifetime when the sample was illuminated with a photon energy of 1.32 eV at 70 K. These results provide evidence for hydrogen complex defects in undoped LEC InP.     

InAs/GaAs (1 1 1)A heteroepitaxial systems

We studied the structural, electrical, and mechanical properties of an InAs thin film grown on GaAs (1 1 1)A substrates by molecular beam epitaxy. In contrast to conventionally used (0 0 1) surfaces, where Stranski–Krastanov growth dominates the highly mismatched heteroepitaxy, layer-by-layer growth of InAs can be established. One of the largest advantages of this unique heteroepitaxial system is that it provides a two-dimensional electron gas system in the near-surface region without the problem of electron depletion. We review the fundamental properties and applications of this unique heteroepitaxial system.     

Tunable narrow-band infrared emitters from hexagonal lattices

In this work, we present both the theoretical basis as well as supporting experimental measurements for development of a novel mid-infrared thermally stimulated narrow band emitter with a spectral bandwidth of less than 10%. To achieve this, we utilize a metallized-surface 2D photonic crystal of air voids in a silicon background with hexagonal structure symmetry. Our results are based on the generation of discrete surface plasmon (SP) modes in the thin metallized layer residing on the top surface. This yields a series of adequately spaced discrete peaks in the reflection spectrum, dominated by a single sharp feature corresponding to the lowest plasmon order, in an otherwise uniform highly reflective spectrum (>90%) over most of the IR spectrum. This, in turn, gives rise to a sharp absorption feature with a correspondingly narrow thermal emission peak in the emission spectrum. Transfer matrix calculations simulate well both the position and strengths of the absorption peaks. By altering the period of the surface photonic lattice, the SP peak and emissive band can be tuned to the desired wavelength. These devices promise a new class of tunable infrared emitters with high power in a narrow spectral bandwidth. Such narrow band sources are critical to achieving high efficiency gas sensors.     

Liminf results on the increments of an (N,d)-Gaussian process

We establish some liminf theorems on the increments of a (N,d)-Gaussian process with the usual Euclidean norm, via estimating upper bounds of large deviation probabilities on the suprema of the (N,d)-Gaussian process. This revised version was published online in June 2006 with corrections to the Cover Date.     

Brightness and decay time of Zn2SiO4:Mn phosphor particles with spherical shape and fine size

Green-light-emitting Zn₂SiO₄:Mn phosphor particles were synthesized by modified large-scale spray pyrolysis using a colloidal solution containing fumed silica particles. The particles had a fine size, filled morphology, spherical shape and non-aggregation characteristics even after post-treatment at 1150 °C. The luminescence characteristics of Zn₂SiO₄:Mn phosphor particles having spherical shape, such as brightness and decay time under VUV excitation light, were investigated as a function of Mn content. The luminescence intensity exhibits a maximum at 5 mol% Mn-doped powder. The decay time increases consistently with decreasing Mn content and more saturated color coordinates are obtained with the composition having 12 mol% Mn. As a consequence, the 10 mol% Mn-doped powder proved to provide a good combination of favorable luminance and acceptable decay time. The influence of post-treatment temperature on the decay time and photoluminescence characteristics of Zn₂SiO₄:Mn particles was also investigated. Particles post-treated at 1155 °C had the maximum photoluminescence intensity, which was identical to 113% that of the commercial product, and a comparable decay time of 5.8 ms. PACS 81.20.Rg; 78. 55.Hx; 78.40.Ha; 81.05.Hd; 81.40.Tv