Development and critical comparison of greener flow procedures for nitrite determination in natural waters

Two greener procedures for flow-injection spectrophotometric determination of nitrite in natural waters were developed and critically compared. Replacement of toxic reagents, waste minimization and treatment were exploited to attend the standards of clean chemistry. The flow system was designed with solenoid micro-pumps in order to minimize reagent consumption and waste generation. The first procedure is based on the Griess diazo-coupling reaction with sulfanilamide and N-(1-naphthyl)ethylenediamine (NED) yielding an azo dye, followed by photodegradation of the low amount of waste generated based on the photo-Fenton reaction. The second procedure is based on the formation of iodine from nitrite and iodide in acid medium in order to avoid the use of toxic reagents. For Griess method, linear response was achieved up to 1.0 mg L^− 1, described by the equation A = − 0.007 + 0.460C (mg L^− 1), r = 0.999. The detection limit was estimated as 8 μg L^− 1 at the 99.7% confidence level and the coefficient of variation was 0.8% (n = 20). The sampling rate was estimated as 108 determinations per hour. The consumption of the most toxic reagent (NED) is reduced 55-fold and 20-fold in comparison to batch method and flow injection with continuous reagent addition, respectively. A colorless residue was obtained by in-line photodegradation with reduction of 87% of the total organic carbon content. The results obtained for natural water samples were in agreement with those achieved by the reference method at the 95% confidence level. For the nitrite–iodide method, linear response was observed up to 2.0 mg L^− 1, described by the equation A = − 0.024 + 0.148C (mg L^− 1), r = 0.999. The detection limit was estimated as 25 μg L^− 1 at the 99.7% confidence level and the coefficient of variation was 0.6% (n = 20). The sampling rate was estimated as 44 determinations per hour. Despite avoiding the use of toxic reagents, the nitrite–iodide method presented worst performance in terms of selectivity and sensitivity.     

Tuning the Properties of Copper(II) Complexes with Tetra‐ and Pentadentate Bispidine (=3,7‐Diazabicyclo[3.3.1]nonane) Ligands

The synthesis of a series of tetra‐ and pentadentate bispidine‐type ligands (bispidine=3,7‐diazabicyclo[3.3.1]nonane) – tetradentate ligands are donor‐substituted at C(2) and C(4), pentadentate ligands have an additional donor at N(3) or N(7), with pyridine, 2‐methylpyridine, or quinoline donor moieties – and of their Cu^II complexes are reported, together with single‐crystal structural analyses and solution studies (electrochemistry, electronic and EPR spectroscopy). Depending on the ligand geometry and on the co‐ligands (solvent or counter anion), there are various structural forms (pseudo‐Jahn–Teller elongation along all three molecular axes), and the structural data are correlated with the spectroscopic and electrochemical parameters.     

Vanadyl salen complexes covalently anchored to an imidazolium ion as catalysts for the cyanosilylation of aldehydes in ionic liquids

Two vanadyl salen complexes having peripheral styryl substituents have been reacted with 1-methyl-3-(3-mercaptopropyl)-imidazolium chloride using azoisobutyronitrile as radical initiator. The resulting compounds contain at the same time a vanadyl salen complex and one imidazolium cation. In agreement with the expectations in view of their structure, these compounds were insoluble in conventional organic solvents, but completely miscible in imidazolium ionic liquids. These vanadyl salen complexes bonded to an imidazolium cation are highly active and reusable catalysts for the cyanosilylation of aldehydes. Moderate enantiomeric excesses were obtained using the chiral version of this complex.     

A comparative study of several HPLC methods for determining free amino acid profiles in honey

A study of the viability of three derivatizing reagents for obtaining amino acid profiles in honey through high performance liquid chromatography (HPLC) is presented. A method using diode array detection based on a reaction with diethyl ethoxymethylene malonate (DEMM) and two other methods using fluorescence detection based on derivatization with fluorenylmethyl chloroformate (FMOC-Cl) and 6-aminoquinolyl-N-hydroxysuccinimidyl carbamate (AQC) have been developed. The three methods yield detection limits close to the ppb level, but vary in relation to other analytical characteristics. The use of methyl chloroformate derivatives allows the profile to be obtained with the greatest sensitivity within a short time frame. On applying such methods to honey samples of diverse botanical origin, we observe that the proline values obtained are always lower than those found using the official spectrophotometric method, thereby underlining the advisability of using HPLC methods to reduce uncertainty in these results.     

Analysis of citrates and benzoates used in poly(vinyl chloride) by supercritical fluid extraction and gas chromatography

Supercritical fluid extraction (SFE) has been demonstrated to be a useful tool in the determination of additives in polymeric materials. This paper describes the determination of some citrates and benzoates in poly(vinyl chloride) blended with 33–34% of plasticizer using off-line SFE followed by gas chromatography. Experimental factors affecting SFE have been studied by gravimetric analysis, followed by analysis of the extracts using a gas chromatograph equipped with a flame ionization detector. The extraction process is governed by the solubility of the plasticizers in the supercritical fluid or by their diffusion through the polymer matrix, which depend on the pressure and temperature used. Maximum extraction (>99%) is obtained at pressures and temperatures higher than 40 MPa and 80 °C, respectively. Due to purge losses, the collection efficiency of plasticizers into a liquid solvent ranges from 85 to 90%. The applicability of the SFE method is demonstrated using real samples and comparing the results with those obtained by conventional Soxhlet extraction.     

Asymmetric hetero Diels-Alder as an access to carbacephams.

A short and efficient asymmetric synthesis of the (6R,7S)-7-tert-butoxycarbonylamino-2-ketocarbacepham is described. The key step involves the hetero Diels-Alder reaction of the benzylimine derived from the enantiomer of Garner's aldehyde with Danishefsky's diene.     

The Effect of Preparation Method and Calcination Temperature on the Crystallite Size and Surface Area of Perovskite-Type SrFeO x

We have investigated the synthesis of perovskite-type SrFeO_x (2.5 x 3.0) using three preparative methods: sol-gel, mechanochemical processing and solid state reactions at high temperature of the corresponding oxides. The sample obtained after calcination of the gel from sol-gel method, contained the least amount of strontium carbonate impurity. The amount of strontium carbonate impurity decreased with the increase in calcination temperature. Perovskites obtained have been characterized by X-ray diffraction (XRD) and nitrogen adsorption isotherms. Samples obtained from three methods have been compared with respect to calcination temperature, crystallite size and specific surface area.Issued as NRCC No. 46479.     

Bis(μ‐acetato‐κ3O,O′:O′)bis[bis(acetato‐κ2O,O′)diaquadysprosium(III)] tetrahydrate

The title compound, [Dy₂(C₂H₃O₂)₆(H₂O)₄]·4H₂O, crystallizes in the form of dimeric units related by an inversion centre. Each cation is nine‐coordinate, binding to two water mol­ecules and three acetate groups, two of which are bidentate and the third tridentate. This last acetate group acts as a bridge between neighbouring metal atoms, leading to an intradimer Dy?Dy separation of 4.170 (1) Å.     

Characterization and complementation of a Pichia stipitis mutant unable to grow on d-xylose or l-arabinose

Pichia stipitis CBS 6054 will grow on d-xylose, d-arabinose, and l-arabinose. d-Xylose and l-arabinose are abundant in seed hulls of maize, and their utilization is important in processing grain residues. To elucidate the degradation pathway for l-arabinose, we obtained a mutant, FPL-MY30, that was unable to grow on d-xylose and l-arabinose but that could grow on d-arabinitol. Activity assays of oxidoreductase and pentulokinase enzymes involved in d-xylose, d-arabinose, and l-arabinose pathways indicated that FPL-MY30 is deficient in d-xylitol dehydrogenase (D-XDH), d- and l-arabinitol dehydrogenases, and d-ribitol dehydrogenase. Transforming FPL-MY30 with a gene for xylitol dehydrogenase (PsXYL2), which was cloned from CBS 6054 (Gen Bank AF127801), restored the D-XDH activity and the capacity for FPL-MY30 to grow on l-arabinose. This suggested that FPL-MY30 is critically deficient in XYL2 and that the d-xylose and l-arabinose metabolic pathways have xylitolas a common intermediate. The capacity for FPL-MY30 to grow on d-arabinitol could proceed through d-ribulose.     

Mechanistic aspects of the Wolff-Kishner reaction. V. The cation effect on the reaction of benzophenone hydrazone in butyl carbitol and decyl alcohol

The rate of the Wolff-Kishner reaction of benzophenone hydrazone in butyl carbitol increases as the cation of the alkoxide base is varied in the order K>Na>Li>Mg. The replacement of butyl carbitol by 1-decanol also accelerates the reaction, and an additional increase is caused by the presence of crown ether. On the basis of changes in the activation parameters, it is concluded that the reactivity of the hydrazone anion increases as the contact ion pair becomes more fully solvated and dissociated.