检测DL-苹果酸的高锰酸钾化学发光体系

利用高锰酸钾化学发光体系测定了DL-苹果酸 ,测得该物质的浓度与其对应的化学发光峰值在一定范围内存在较好的线性关系。测定DL-苹果酸的线性范围在1.0×10-6～1.0×10-2mol·L-1;相对标准偏差为1.4%(n=8) ,检出限为1.0×10-9mol·L-1。测定实际苹果汁与饮料 ,结果良好。实验表明 ,该法线性范围宽、重现性好、操作简便。文中还探讨了该体系的自催化属性。     

INFLUENCES OF ACID POST-TREATMENT ON THE MORPHOLOGY OF SOAPFREE P（MMA-EA-MAA） PARTICLES PREPARED BY SEEDED EMULSION POLYMERIZATION

Soap-free poly（methyl methacrylate-ethyl acrylate-methacrylic acid） latex particles with narrow size distribution were synthesized by seeded emulsion polymerization, and the porous particles were created by a stepwise alkali/acid treatment method. Effects of acid treatment conditions on the particle morphology were investigated. Results show that one to three pores were formed inside most of particles after post-treatment. At pH 7.0, when the treatment temperature was lower than 70℃, the size of particles and the volume of pores remained almost unchanged, and these two values increased significantly when the temperature was higher than 70℃. Both the particle size and the pore volume decreased with the increase of initial pH value and treatment time in the acid treatment. As the pH was below 4.0 and the treatment time was longer than 180 min, the particles shrunk in size.     

铈掺杂对超细LaMnO_(3+λ)催化性能的影响

以Ce2(CO3)3,La2O3和Mn(NO3)2为原料,用"溶胶-凝胶"法结合"超临界干燥"技术,将铈掺入超细LaMnO3+λ气凝胶中。用TG-DTA,XRD,TEM,FT-IR等手段对样品进行表征;并用"2CO+2NO=2CO2+N2"反应测试铈掺杂对超细LaMnO3+λ催化活性的影响。结果显示:260℃时,镧铈锰气凝胶为疏松、絮状且具有较好分散性的棕色粉末,由大量直径小于10 nm的球形颗粒组成;850℃热处理后,镧铈锰气凝胶为粒径小于20 nm的类球形颗粒,晶相成分为LaMnO3+λ,La2O3和CeO2;铈掺杂增加LaMnO3+λ晶格的氧空缺数量,改善氧化还原催化的气氛条件,提高超细LaMnO3+λ的催化活性。     

可再生能源系统的不确定性优化模型及求解

结合新提出的满意度方法和混合整数规划方法,给出了多态不确定性环境下可再生能源规划模型.该模型综合描述了多地区、多时期、多品种、多部门之间的可再生能源管理系统的复杂性、系统性、动态性和不确定性.最后的实例求解结果说明该模型能很好地反映能源安全性、系统可靠性与系统成本之间的关系,并能给出不同系统违反水平下的能源配置方式及增容计划,为决策者提供决策参考.     

Dispersion Theory of Polaron in a Parabolic Quantum Dot at Finite Temperatures

By using the dispersion theory instead of the Fröhlich Hamiltonian, the polaron energy in a quantum dot with a parabolic confinement potential is investigated at finite temperatures. It is found that the self-trapping energy of the polaron decreases with the increasing temperature, and the temperature effect is more obvious in quantum dots with weaker confinement.     

基于室温脉冲量子级联激光器的NO气体检测中的光谱处理方法研究

报导了采用基于室温脉冲量子级联激光器的脉内光谱检测技术,利用中心波长为1904 cm^-1的量子级联激光器,在实验室对NO气体样品进行检测的研究结果. 针对单线直接吸收光谱反演算法进行了研究,介绍了基线拟合的最小二乘算法以获取其吸光度,根据HITRAN数据库中相应吸收谱线的吸收线强,采用扫描积分实现了气体浓度的反演,避免了标气标定造成的误差及污染;通过拟合残差分析得到了系统的检测限,达到34×10^-6 m. 关键词： 量子级联激光器 中红外 多项式拟合 扫描积分     

Highly efficient cryogenically-cooled Yb:YAG laser

A MOPA laser system for high pulse energy and high average power has been developed by using a cryogenic Yb:YAG. In the regenerative amplifier with our original TRAM architecture, the high pulse energies of 6.5 and 1.5 mJ were obtained at the repetition rate of 200 Hz and 1 kHz, respectively. An optical efficiency was as high as η_o-o = 9.3% with an excellent beam quality of M ² < 1.1, which ensured that a cryogenic Yb:YAG TRAM had a high thermal strength. The following four pass power amplifier with a cryogenic Yb:YAG rod showed 140 mJ at 100 Hz. Both a high optical efficiency of η_o-o = 30% and a high slope efficiency of η_s = 44% showed that an efficient laser operation could be realized for a power amplification with both a high pulse energy and a high average power by using a cryogenic Yb:YAG.     

Intrinsic self‐initiating thermal ring‐opening polymerization of 1,3‐benzoxazines without the influence of impurities using very high purity crystals

A phenol/aniline type monofunctional benzoxazine monomer, PH‐a , is synthesized and highly purified to study the intrinsic thermal ring‐opening polymerization of benzoxazines without the influence of any impurity. The successful synthesis of the monomer and its corresponding chemical structure are confirmed by Fourier transform infrared spectroscopy (FTIR) and ¹H nuclear magnetic resonance (¹H NMR) spectroscopy. Purity of the compound is evaluated through differential scanning calorimetry (DSC) as well as elemental analysis (EA). Moreover, the thermal behavior of benzoxazine monomer toward polymerization is also studied by DSC, indicating that the highly purified benzoxazine monomer actually polymerize upon heating. The results present evidence of an intrinsic tendency for 1,3‐benzoxazines to undergo thermally induced ring‐opening polymerization upon heating only without any impurity participating during the reaction. This reveals that polybenzoxazines can be obtained by both the traditional thermally accelerated (or activated) polymerization, where impurities or purposefully added initiators are involved in the reaction; or, by the classic thermal polymerization, where only heat is enough to initiate the reaction. © 2017 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2017 , 55, 3434–3445