MoS2纳米管包覆单壁碳纳米管束的制备

MoS₂ nanotube coated SWNT (Single wall carbon nanotube) bundles have been successfully prepared by adsorbing (NH₄)₂MoS₄ onto SWNT bundles and subsequent heat treatment under H₂ at 900 ℃ in a tube furnace. The morphologies, structure and composition of the as-prepared sample were investigated by XRD, SEM, HRTEM coupled with EDS. The formation mechanism has also been preliminarily discussed.     

L-鼠李糖基(氨基)硫脲类化合物的合成

以L-鼠李糖为起始原料, 制备1-溴-2,3,4-三-O-乙酰基-β-L-吡喃型鼠李糖, 然后在甲苯中与Pb(SCN)₂作用, 得到中间体2,3,4-三-O-乙酰基-α-L-吡喃型鼠李糖基异硫氰酸酯(1). 利用2,3,4-三-O-乙酰基-α-L-吡喃型鼠李糖基异硫氰酸酯易发生亲核加成的性质, 在不同溶剂中, 与取代的苯并噻唑胺(2a～2f)、取代的苯并噻唑肼(2g～2l)、氧化和非氧化的哒嗪酮甲酰肼(2m, 2n)以及取代的嘧啶胺(2o, 2p)反应, 合成了16种新的(氨基)硫脲类化合物3a～3p. 所有化合物的结构均经IR, ¹H NMR, LC-MS和元素分析确证, 并对它们的生物活性做了初步测试.     

聚(4-偶氮磺酸苯乙烯-co-4-乙烯基吡啶)与本征态聚苯胺的氢键自组装及其光电转换性能

合成了一种新的共聚体——聚(4-偶氮磺酸苯乙烯-co-4-乙烯基吡啶), 它含有吡啶环, 能作为氢受体与本征态聚苯胺进行氢键自组装. 在紫外光照下, 组装膜通过偶氮磺酸基的光解, 形成稳定的共价交联结构, 在电解质水溶液中也不被破坏, 可用作光电转换膜, 并能在盐水溶液中直接测定它的光电流. 结果表明含有本征态聚苯胺的自组装膜是一种良好的光电转换材料.     

离子色谱法测定皂粒中葡萄糖酸钠含量

建立了离子色谱检测皂粒中葡萄糖酸钠含量的分析方法。样品经METROSEP CARB 1糖分析色谱柱(150 mm×4.0 mm,5μm)分离,以150 mmol·L~(-1) NaOH+20 mmol·L~(-1)NaAc水溶液为流动相进行等度洗脱,流速1.0 mL·min~(-1),采用瑞士万通850型离子色谱仪,选择脉冲安培检测器进行测定,外标法定量。结果显示:葡萄糖酸钠在0.5～200 mg·L~(-1)质量浓度范围内呈良好的线性,相关系数(r~2)为0.999 6,检出限为0.25 mg·L~(-1),定量下限为0.63 mg·L~(-1)。葡萄糖酸钠在1～20 mg/g加标范围内的回收率为80.7%～104%。该方法无需衍生化处理,操作简单方便,灵敏度高,可用于皂粒产线葡萄糖酸钠含量的监控与测定。     

微波法研制碱土金属氧化物负载型MCM-48碱性介孔材料

以立方相介孔分子筛MCM-48为载体,用微波辐射分散MgO或CaO和醋酸镁溶液浸渍等方法研制碱性介孔材料。MCM-48能经受微波辐射,负载碱性客体之后也保持介相结构。异丙醇分解探针反应表明:载体本身没有碱催化活性,而碱性MCM-48介孔材料的活性随温度升高而提高。本文还对介孔材料在微波分散和碱性催化方面的特点进行分析。     

FREE STANDING FILM OF POLYANILINE

A free standing film of polyaniline as large as 18 cm×18cm×0.002 cm can be obtained by evaporation of a solution of the chemically synthesized base in NMP. Its structure was examined by the elemental analysis, IR, U.V.-visible spectra, XPS, DSC, SEM and X-ray scattering and its conducting behavior as well as electrochemical properties were studied. Results show that the composition, structure of main chain, physical properties of the free standing film of polyanilme is similar to that of the powder. However, some differences in its electronic structure, conductivity at room temperature and potential of redox couple between the flee standing film and powder are observed, which may be due to cross-linking of the film of polyaniline.     

Ni添加对0.4Zr0.1V1.1Mn0.5Cr0.1合金的相结构和电化学性能的影响

本文通过XRD、SEM、EDS研究了Ti_0.4Zr_0.1V_1.1Mn_0.5Cr_0.1Ni_x(x=0，0.2，0.4，0.6，0.8)合金的相结构和电化学性能。该合金系由BCC结构的V基固溶体主相和六方结构的C14 Laves第二相组成，Ni能够促进第二相的生成，Ni含量的增加导致了各相中的化学组成和晶格参数的变化，并通过电化学方法研究了Ni含量对_0.4Zr_0.1V_1.1Mn_0.5Cr_0.1合金电极的最大放电容量、自放电性能、高倍率放电性能、循环稳定性能等的影响。     

Nb 掺杂LiFePO4/C 的一步固相合成及电化学性能

用固相法一步合成了Nb掺杂的LiFePO4/C复合材料, 研究了Nb掺杂量对材料电化学性能的影响. 结果表明, Nb掺杂后LiFePO4/C复合材料的电化学性能明显提高. 在0.5C、1C和2C充放电倍率下, 名义成分为Li0.96Nb0.008FePO4/C正极材料的比容量分别为161、148和132 mAh•g−1, 已达到实用化水平. 阻抗谱和循环伏安特性测试显示, Nb掺杂有效地降低了复合材料电极的阻抗和极化, 说明Nb掺杂的主要作用是提高了LiFePO4的电子电导率.     

氧化-还原低温引发甲基丙烯酸甲酯/丙烯酸丁酯超浓乳液聚合研究

以乳化剂十二烷基硫酸钠 (SDS)和共乳化剂十六烷醇 (HD)作为复合乳化体系 ,过氧化二苯甲酰(BPO)和N ,N 二甲基苯胺 (DMA)作为氧化还原引发体系 ,甲基丙烯酸甲酯 丙烯酸丁酯 (MMA BA)作为混合单体 ,制备了分散相占 83 %以上的稳定的超浓乳液 ,然后在低温下引发聚合 .探讨了引发剂浓度、氧化剂与还原剂的摩尔比、乳化剂的浓度、液膜增强剂的种类、聚合温度等因素对聚合稳定性和聚合速率的影响 ,测定并计算得到了聚合速率的公式 ;用激光散射粒度分布仪测定了聚合物乳胶粒子的大小及粒径分布 ,用透射电子显微镜观察了聚合物乳胶粒的形态 ,讨论了乳化剂浓度、聚合温度等对乳胶粒形态、大小的影响     

Rheological Behavior for Mica-filled Polypropylene Composite Melts

The study on rheological properties of a series of mica-filled polypropylene (PP) composites was carried out. The influence of surface-treatment of mica particles on dynamic rheological behavior of the composites were dealt with. The viscosity (η) and dynamic modulus ( G‘ ) of the composite melts were higher than those of PP matrix, especially those for systems treated with silane, which was attributed to the interfacial adhesion enhancement. However, surface-treatment of mica by titanate resulted in lower η and G‘, as compared with the treatment by silane. The reason for this is believed to be the formation of the mono-molecular layer on the mica surface.