Comparison of four quantification methods for the determination of PCB in transformer oils

The analysis of PCB in transformer oils has been achieved with three HRGC/ECD based methods, proposed by the International Electrotechnical Commission (IEC/TC 10), by the Comité Européen de Normalisation (CEN/TC 19/WG 22) and by the Deutsches Institut für Normung (DIN 51 527). The same clean-up, described in the CEN/TC 19/WG 22, has been used for all the samples, allowing a comparison of the quantification procedure only. The total chlorine content has also been determined with X-ray fluorescence. These different methods of quantification are compared and their application for legislative purposes is discussed.Dedicated to Professor Dr Dieter Klockow on the occasion of his 60th birthday     

Stressed states in domain switching of ferroelectric liquid crystal devices

In this paper we show that the director profile of a low pre-tilt surface stabilized ferroelectric liquid crystal passes through quasi-static stressed states during domain switching under direct drive conditions. Using polarized stroboscopic microscopy, we have observed two quasi-static transmission levels during a domain switching transition from dark to light. This is a result of the directors reorienting into stressed profiles both before and after the chevron interface has switched. By modelling the interaction between the elastic forces and the torque from the applied field, we have determined these voltage dependent director profiles and, by calculating their corresponding transmissivities, have shown very good agreement with the experimentally observed values.     

High pressure differential thermal analysis of nematic compounds with different molecular shapes

By means of high pressure differential thermal analysis we measured the pressure/temperature phase diagrams of several nematic compounds with different molecular structures. Using pressures up to about 500 M Pa we found strongly nonlinear clearing curves. This behaviour is interpreted as changes from 'weak' intermolecular potentials to 'hard' potentials, or using thermodynarmic arguments, strong pressure dependence of the volume discontinuity at the clearing transitions.     

Organometallic complexes with biological molecues,part 3. in vivo cytotoxicity of diorganotin (IV) chloro and triorganotin (IV) chloro derivatives of penicillin g on chromosomes of aphanius fasciatus (pisces,cyprinodontiformes)

In order to obtain a continuous source of mitotic metaphases, gill tissue of Aphaius fasciatus (Pisces, Cyprinodontiformes) has been successfully employed. Results gathered after exposure of fish to R₂SnClpenG, R₃SnClpenGNa, to the parents R₂SnCl₂, R₃SnCl and to penGNa (penGNa = penicillinGNa; R = methyl, butyl and phenyl) suggest that both the parent organotin (IV) chloride and organotin (IV) chloropenG derivatives are toxic while penGNa exerts no significant toxic activity. Essentially, all of the chromosome abnormalities are classifiable as irregularly staining of chromosomes, breakages, side-arm bridges or pseudochiasmata.     

Carbon–epoxy composites based on fibers coated with nylon 6,6: hygrothermal ageing versus interlaminar shear strength

Carbon fibers were coated in situ with a thin film of polyhexamethylene adipamide by an interfacial polycondensation technique. The modified fibers were used for the preparation of epoxy-based unidirectional composites. Specimens of these materials were immersed in water until equilibrium conditions were attained. The weight gain at equilibrium was determined as a function of the immersion temperature, the fiber volume fraction and the polyamide content deposited on the fibers. Water penetration in specimens made with uncoated carbon fibers increases when the volume fraction decreases. Introduction of the polyamide interlayer initially increases the water absorption, but reduces it at higher immersion temperatures and/or higher polyamide contents. The treated specimens were subjected to the short beam test to determine the interlaminar shear strength (ILSS). The data show that the ILSS decreases with water penetration but increases when the immersion temperature increases from 40 to 70°C. The overall performance encountered is discussed in terms of the possible roles of the polyamide interphase while taking into account mechanisms concerned with matrix plasticization, interphase degradation and residual stress relaxation.     

Effects of target gas in collision-induced dissociation using a double quadrupole mass spectrometer and radiofrequency

Collision-induced dissociation (CID) of polyatomic ions sampled from an rf-powered glow discharge is examined by using three target gases including atomic (Ar and Xe) and molecular species (N2). Collisions with these targets in the first quadrupole of the double quadrupole system result in the loss of discharge species by dissociation, symmetric and asymmetric charge exchange, and scattering, each to varying degrees. These processes are seen to be a function of the relative mass, size... and ionization potentials of the target species, as well as the collision center-of-mass energies. In light of the comparisons, xenon appears to be the best collision target for both CID and charge exchange because of its relatively low ionization potential and high dissociation efficiency of polyatornic species. Evidence for both symmetric and asymmetric charge exchange is presented for Ar and Xe target gases.     

The potential of pyrolysis/gas chromatography/mass spectrometry for determining the progress of lignification: An investigation of maturing asparagus sclerenchyma tissue

Sclerenchyma tissues from semi-mature and mature asparagus spears were analysed by pyrolysis/gas chromatography/mass spectrometry and by conventional chemical methods in order to determine the degree of lignification and compare analytical techniques. The pyrolysis data are similar to those obtained by a chemical method involving alkaline extraction at 70°C followed by spectrophotometric determination of phenolic content. The pyrolysis method was more rapid, sensitive and informative than the chemical technique and shows considerable potential for studying the chemical basis of the textural development of plant foods.     

The dehydration of copper(II) acetate monohydrate

The thermal dehydration of copper(II) acetate hydrate has been studied between 353 and 406 K, over a range of humidities. The dehydration is controlled by nucleation-and-growth kinetics at low temperatures, with an activation energy of 154 kJ·mol⁻¹, which changes to contracting-disc kinetics at higher temperatures with a lower activation energy of 76 kJ·mol⁻¹. Frequency factors have also been derived; the value for the high temperature process is low (10⁷s⁻¹) and that for the low temperature step is high (10¹⁷s⁻¹). Optical microscopy has been used to clarify the bulk kinetics; there is evidence for a reactive layer at the surface of the decomposing solid. In celebration of the 60^th birthday of Dr Andrew K. Galwey     

Development of a so-called hour method for analysis of plutonium in soil samples

A short overview of HPLC column packings is presented. The properties of chromatographic carriers and the possibilities to combine the solid matrices with organic polymeric stationary phases are elucidated in detail. The latest achievements and anticipated future developments in the area are outlined.     

Radioactive waste treatment products studied by Mössbauer spectroscopy II. Iron hydroxide precipitation systems

Different iron hydroxide precipitation processes simulating radioactive waste, treatment have been investigated by Mössbauer spectroscopy at room temperature and at 80 K. Magnetic oxides (hematite or magnetite) partially affected by superparamagnetic relaxation have been observed. The crystallization degree and the particle size depend on the concentration and the addition order of chemicals. Much smaller particles were precipitated with Ca(OH)₂ than with NaOH as neutralization reagent.