Air stability of PTCDI‐C13‐based n‐OFETs on polymer interfacial layers

This Letter reports the novel use of poly(9‐vinylcarbazole) (PVK) as a dielectric interfacial layer for n‐type organic field‐effect transistors (n‐OFETs). With PVK, both the air stability and electron mobility of N,N′‐ditridecylperylene‐3,4,9,10‐tetracarboxylic diimide (PTCDI‐C13)‐based OFETs were improved. Among the PVKs with different weight‐average molecular weight (M_w), PVK with high M_w showed good performance. The high glass transition temperature of PVK enabled thermal post annealing of the active layer, which resulted in a high electron mobility of 0.61 cm²/Vs. This mobility was maintained at 90% and 59% after 4 days and 105 days in air, respectively. The PVK interfacial layer reduced the trapped charges in the PTCDI‐C13‐based n‐OFET for air‐exposure and caused a decrease in the threshold voltage shift.

     

Graphene Modified Lipophilically by Stearic Acid and its Composite With Low Density Polyethylene

Graphene, prepared by the thermal reduction of graphite oxide (GO), was modified with stearic acid to enhance its lipophilicity. A novel method, using the intrinsic epoxy groups on the graphene, was utilized for reaction with stearic acid to minimize the negative impact of the normal functionalization method on the π-electronic system of graphene. Gravimetric analysis, thermogravimetric analysis (TGA), Fourier transform infrared (FTIR) spectroscopy, and X-ray photoelectron spectroscopy (XPS) showed that the stearic acid was effectively attached to the graphene. In addition, Raman spectroscopy and electric conductivity of the graphene showed that this novel modification method, utilizing intrinsic defects, did not damage the π-electronic system of the sp² bonded carbons. The dispersion of graphene in a low density polyethylene (LDPE) matrix was enhanced; consequently, the reinforcing effect in tensile testing was improved by the lipophilic modification. The crystallization behavior observed by differential scanning calorimetry (DSC) showed that the crystallization of LDPE was hindered by dispersed graphene, more evidently when dispersed uniformly.     

Polymorphic phase transition and thermal stability in squaric acid (H2C4O4)

Phase transformations in squaric acid (H₂C₄O₄) have been investigated by thermogravimetry and differential scanning calorimetry with different heating rates β. The mass loss in TG apparently begins at onset temperatures T_di=245±5 °C (β=5 °C min^?1), 262±5 °C (β=10 °C min^?1), and 275±5 °C (β=20 °C min^?1). A polymorphic phase transition was recognized as a weak endothermic peak in DSC around 101 °C (T_c⁺). Further heating with β=10 °C min^?1 in DSC revealed deviation of the baseline around 310 °C (T_i), and a large unusual exothermic peak around 355 °C (T_p), which are interpreted as an onset and a peak temperature of thermal decomposition, respectively. The activation energy of the thermal decomposition was obtained by employing relevant models. Thermal decomposition was recognized as a carbonization process, resulting in amorphous carbon.     

Sound modes in holographic hydrodynamics for charged AdS black hole

In the previous paper we studied the transport coefficients of quark–gluon plasma in finite temperature and finite density in vector and tensor modes. In this paper, we extend it to the scalar modes. We work out the decoupling problem and hydrodynamic analysis for the sound mode in charged AdS black hole and calculate the sound velocity, the charge susceptibility and the electrical conductivity. We find that Einstein relation among the conductivity, the diffusion constant and the susceptibility holds exactly.     

On partial sums of a gaussian sequence with stationary increments

We establish large increment properties for a Gaussian sequence with stationary increments under global conditions. Limit theorems for partial sums of the sequence with nonpositive correlation functions or the correlation functions on their speed of convergence to zero are proved via estimating a probability inequality on the supremum of Gaussian processes     

Understanding the junction degradation mechanism in CdS/CdTe solar cells using a Cd-deficient CdTe layer

It is known that CdTe solar cells are often degraded under solar illumination. But the degradation mechanism is not fully proved because it does not appear consistently. The junction degradation in CdS/CdTe solar cells was investigated using a CdTe layer with Cd deficient composition, where Cd vacancy concentration is high. It was found that the Cu atoms easily filled the Cd vacancies in CdTe and transport to junction area from Cu back contact. PL measurement and spectral quantum efficiency measurement showed that the incorporation of Cu atoms in CdS forms a defect energy level at 1.55 eV below the conduction band in CdS. As a result, the junction built-in potential is decreased and light penetration into CdTe absorber is shielded. For reliable and stable CdTe cells, the formation of Cd vacancy in CdTe should be avoided by careful control of CdTe.     

Simultaneous determination of 75 abuse drugs including amphetamines,benzodiazepines, cocaine,opioids, piperazines,zolpidem and metabolites in human hair samples using liquid chromatography–tandem mass spectrometry

A liquid chromatography–tandem mass spectrometric method for the simultaneous determination of 75 abuse drugs and metabolites, including 19 benzodiazepines, 19 amphetamines, two opiates, eight opioids, cocaine, lysergic acid diethylamide, zolpidem, three piperazines and 21 metabolites in human hair samples, was developed and validated. Ten‐milligram hair samples were decontaminated, pulverized using a ball mill, extracted with 1 mL of methanol spiked with 28 deuterated internal standards in an ultrasonic bath for 60 min at 50°C, and purified with Q‐sep dispersive solid‐phase extraction tubes. The purified extracts were evaporated to dryness and the residue was dissolved in 0.1 mL of 10% methanol. The 75 analytes were analyzed on an Acquity HSS T3 column using gradient elution of methanol and 0.1% formic acid and quantified in multiple reaction monitoring mode with positive electrospray ionization. Calibration curves were linear (r ≥ 0.9951) from the lower limit of quantitation (2–200 pg/mg depending on the drug) to 2000 pg/mg. The coefficients of variation and accuracy for intra‐ and inter‐assay analysis at three QC levels were 4.3–12.9% and 89.2–109.1%, respectively. The overall mean recovery ranged from 87.1 to 105.3%. This method was successfully applied to the analysis of 11 forensic hair samples obtained from drug abusers.     

Anti‐Inflammatory Activity of a Novel Acetylene Isolated from the Roots of Angelica tenuissima Nakai

Three polyacetylenes, one novel and two known, were isolated from the root of Angelica tenuissima. Using ¹H‐ and ¹³C‐NMR, COSY, HMBC, and HMQC, their structures were found to be (3R,8S)‐heptadeca‐1‐en‐4,6‐diyne‐3,8‐diol ( 1 ), falcarindiol ( 2 ), and oplopandiol ( 3 ). Absolute configurations of compound 1 were established using Mosher's esterification. In addition, the polyacetylenes ( 1 – 3 ) were evaluated for their anti‐inflammatory activity. Compounds 1 and 3 showed potent inhibitory activity against lipopolysaccharide‐induced nitric oxide (NO) production in RAW267.7 macrophage cells with IC₅₀ values of 4.31 and 5.06 μm, respectively. Compound 1 strongly inhibited inducible nitric oxide synthase (iNOS) and cyclooxygenase (COX)‐2 in a concentration‐dependent manner.     

(E)-1-alkyl-4-

(E)-1-Alkyl-4-[2-(alkylsulfonyl)-1-ethenyl]pyridinium salts were synthesized in two steps. These sulfones were stable at pH 7.3 and underwent a nucleophilic vinylic substitution (S(N)V) with mercaptans, including thiouracile, to give the corresponding 4-(thiovinyl)-pyridinium salts. The X-ray diffraction structure of (E)-1-methyl-4-[2-(ethylsulfanyl)-1-ethenyl]pyridinium iodide indicated conjugation of the sulfur with the pyridinium ring. (Z)-1-Methyl-4-[2-(methylsulfanyl)-1-ethenyl]pyridinium iodide, prepared from the corresponding thioether by reaction with methyl iodide in diethyl ether, underwent isomerization to the E isomer in a first-order reaction in deuterated [D6]DMSO with an activation energy of 14 kcalmol(-1). At pH 7, the (E)-1-methyl-4-[2-(methylsulfonyl)-1-ethenyl]pyridinium iodide (19) reacted specifically with thiols. The reaction of this sulfone with glutathione in a TES buffer at pH 7 was a second-order reaction (k = 4,100 M(-1)s(-1) at 30 degrees C) and gave the corresponding substitution product with an intense long wavelength absorption band (lambdamax=360 nm, epsilon = 27,500 M(-1)cm(-1)). The modification of different enzymes of known structure with 19 showed the high selectivity of this reagent towards thiol groups and its usefulness in the quantitative determination of free thiol groups in proteins.     

Effects of take‐up speed on the structure and properties of melt‐spun poly(L‐lactic acid) fibers

Poly(L ‐lactic acid) (PLLA) filament fibers were prepared by one‐step melt spinning process and the effects of variations in take‐up speed on their thermal properties, mechanical properties, and crystalline structures were investigated. Differential scanning calorimetry (DSC) results revealed that the PLLA fibers showed multiple melting peaks and that the melting peak appearing at a lower temperature moved lower while that at a higher temperature moved higher with increasing take‐up speed. The glass transition temperature (T_g) obtained from dynamic mechanical analysis (DMA) increased with increasing take‐up speed. The tenacity increased and the boiling water shrinkage (BWS) decreased with increasing take‐up speed. However, these mechanical and thermal properties were stabilized at take‐up speeds over 3500 m/min. The melt‐spun PLLA fibers of this study showed an α‐form crystal structure which was not affected by the take‐up speed. The change in the tendency of the thermal and mechanical properties at around 3500 m/min did not appear to result from the change in crystal form but rather from the change in crystallite size and crystallite orientation. Copyright © 2008 John Wiley & Sons, Ltd.