Two-color resonantly enhanced multiphoton ionization and zero-kinetic-energy photoelectron spectroscopy of jet-cooled indan

We report studies of supersonically cooled indan using two-color resonantly enhanced multiphoton ionization and two-color zero-kinetic-energy photoelectron spectroscopy. With the aid of ab initio and density-functional calculations, vibrational modes of the first electronically excited state of the neutral species and those of the cation have been assigned, and the adiabatic ionization energy has been determined to be 68458 +/- 5 cm(-1). Similar to the ground state and the first electronically excited state of the neutral molecule, the ground state of the cation is also proven to be nonplanar, with an estimated barrier of 213 cm(-1) and a puckering angle of 15.0 degrees. These conclusions will be discussed in comparison with a previous study of an indan derivative 1,3-benzodioxole.     

Kinetic Spectrophotometric Determination of Ritodrine Hydrochloride in Dosage Forms

A simple and sensitive kinetic method was developed for the determination of ritodrine hydrochloride in pharmaceutical preparations. The method is based upon a kinetic investigation of the oxidation reaction of the drug with alkaline potassium permenganate at room temperature for a fixed 12.5 min; the absorbance of the colored permenganate ion was measured at 609 nm. The absorbance concentration plots were rectilinear over the range of 1.6–11.2 μg mL^?1 (r = 0.9992) with a minimum detectability of 0.096 μgmL^?1 (2.88 × 10^?7 M). The different experimental parameters affecting the development and stability of color were carefully studied and optimized. The determination of ritodrine hydrochloride by the fixed concentration and rate constant methods is also feasible with the calibration equations obtained, but the fixed time method has been found to be more applicable. The proposed method was applied successfully to the determination of ritodrine hydrochloride in tablets and ampoules with average recoveries of 100.37 ± 0.93% and 100.42 ± 0.87%, respectively. The results obtained were in good agreement with those obtained using a reference method for comparison. A proposal of the reaction pathway is also presented.     

Cell-permeable GPNA with appropriate backbone stereochemistry and spacing binds sequence-specifically to RNA

Guanidine-based peptide nucleic acid (GPNA) with a d-backbone configuration and alternate spacing binds sequence-specifically to RNA and is readily taken up by both human somatic and embryonic stem (ES) cells.     

压力、温度和晶粒尺寸对Fe-N合金的合成及结构的影响

在 1× 1 0 - 3 Pa～ 4 GPa的压力和 5 80～ 930 K温度范围内 ,利用高压技术并结合机械球磨 ,研究了压力、温度和晶粒尺寸对α-Fe与非晶 BN的固态反应的影响 .发现高压和晶粒细化可以极大地促进α-Fe和非晶 BN的固态反应过程 ,α-Fe与非晶 BN发生固态反应的临界晶粒尺寸约 8nm.压力和温度对反应产物及其晶体结构有明显影响 .2 GPa和 80 0 K时 ,反应产物为具有正交结构的 Fe-N新相 ;在 3～ 4 GPa和 690～80 0 K时 ,可形成单一ε-Fex N合金相 ;而在 4 GPa和 930 K以上 ,反应产物由 Fe-N合金相转变为 Fe3B相     

Poly[μ‐aqua‐μ4‐naphthalene‐1,8‐dicarboxylato‐zinc(II)]

In the title complex, [Zn(C₁₂H₆O₄)(H₂O)]_n, a Zn^II polymer based on naphthalene‐1,8‐dicarboxylate (1,8‐nap), the Zn^II atoms adopt an elongated octahedral coordination geometry. A zigzag chain is formed by μ₂‐aqua ligands and μ₂‐carboxylate groups of the 1,8‐nap ligands. Adjacent parallel chains are further linked by 1,8‐nap ligands, forming a twisted two‐dimensional layer structure along the (100) plane.     

电化学方法获得具有表面增强拉曼活性镍电极的研究

利用纯电化学手段获得了具有较强表面增强拉曼活性的镍电极, 改进了原有的镍电极表面预处理方法. 结果表明, 在0.5 mol/L的NaClO4溶液中, 结合电化学阶跃技术和循环伏安技术, 可以得到合适的粗糙镍电极; 同时, 还得到了探针分子吡啶在该粗糙镍电极表面随电极电位变化的表面增强拉曼光谱(SERS), 此时谱峰强度获得了极大的增强; 还研究了粗糙镍电极的扫描电子显微镜(SEM)图像, 并估算出其SERS增强因子约为104, 此结果比以前的镍电极表面粗糙方法所能达到的增强因子高一个数量级.     

A study of substituent effect on 1H and 13C nmr spectra of N‐ and C‐substituted carbazoles

¹H and ¹³C nmr spectra of several N‐ and C‐substituted carbazoles (Series 1, 2, 3 and 4) were measured. Correlations between chemical shifts and substituent constants show that these parameters describe properly the substituent effect on the nmr phenomena. Atomic charge densities for carbazoles of Series 1, 2, 3 and 4 were calculated by using the semi empirical PM3 method. These values also show a linear correlation with the ¹³C chemical shifts. The synthesis of several carbazole derivatives 1a – 1g, 2a – 2g, 3a – 3j and 4a – 4g have been carried out according to literature procedures. The carbazoles 3i, 3j and 4c have been synthesized and fully characterized for the first time.     

Total Synthesis of Crenulatan Diterpenes: Strategy and stereocontrolled construction of a bicyclic keto-lactone building block

The bicyclic keto lactone 26 was synthesized for the purpose of developing a viable route to marine diterpenes of the crenulatan type. Following the efficient conversion of (S)-citronellol ( 5 ) to the allylated alcohol 9a (Scheme 2), the αβ-unsaturated lactone 12 was efficiently accessed in preparation for stereocontrolled conjugate addition. The hydroxymethyl equivalent most suited to this task was (i-PrO)Me₂SiCH₂MgCl, which gave 13 predominantly in the presence of CuI and Me₃SiCl. Once the OH group was deprotected (→ 14 ), it proved an easy matter to implement acid-catalyzed isomerization to lactone 15 , oxidation of which gave the pivotal aldehyde 16 . Condensation of 16 with PhSeCH₂Li led via 21 to 22 (Scheme 3). Once the OH group was protected (→ 22b ), it proved possible to effect aldolization with crotonaldehyde (→ 23 ). Exposure of 23 to acid gave the sub-target compound 25 . Its subsequent oxidation and thermal activation resulted in sequential selenoxide elimination with Claisen rearrangement (→ 26 ). The structural features of 26 require that a chair-like transition state be adopted during the [3.3]sigmatropic event. With the clarification of these issues, a highly serviceable and more advanced assault on the crenulatans should prove capable of being mounted.     

以水、甲苯及其混合溶剂超临界萃取煤的研究

在半连续萃取装置上,以水、甲苯及其混合物为溶剂对黄县褐煤进行了非等温超临界萃取,考察了不同溶剂对萃取过程的影响。结果表明,以甲苯为溶剂的萃取率高于以水为溶剂的。以水为溶剂萃取物中的沥青烯和预沥青烯的H/C原子比高于以甲苯为溶剂的,而O/C原子比则低。在水中加入适量甲苯,能够明显改善萃取效果,大幅度提高萃取率。     

重铬酸钾氧化偶氮胂Ⅲ褪色催化光度法测定痕量钴的研究

在醋酸－醋酸钠缓冲介质中痕量钴（Ⅱ）对重铬酸钾氧化偶氮胂Ⅲ褪色反应有显著的催化作用，催化反应的表现活化能为２５．６２ｋＪ．ｍｏｌ＾－１，据此建立了测定痕量钴的催化动力学分析法，线性范围为０～３５０ｎｇ．ｍＬ＾－１，检出限为２．０ｎｇ．ｍＬ＾－１（Ｃｏ），除Ｆｅ（Ⅱ）外，其余常见共存离子基本不影响钴的测定，本法重现性较好，用于测定人发，茶叶，土壤和废水中钴的含量，结果满意。