Determination of 3-amino-1,2,4-triazole (amitrole) in environmental waters by capillary electrophoresis

3-Amino-1,2,4-triazole (amitrole) is a widely used pesticide, with many difficulties to be analyzed at the regulatory level in drinking water, because its high solubility in water. This paper describes a simple and fast method for the simultaneous determination of amitrole and atrazin-2-hydroxy, principal degradation product of s-triazines, by capillary zone electrophoresis. Separation and determination of these herbicides in water samples was performed in 0.02 mol l⁻¹ phosphate buffer at pH 3.2. The method allows determination of the amitrole and atrazin-2-hydroxy in water samples in concentration lower than 100 μg l⁻¹. The detection limits using a previous preconcentration step of amitrole in Alberche River (Comunidad Autónoma de Madrid, Spain) and drinking water spiked samples was of 4 μg l⁻¹.     

Fluorescent behavior of B-phycoerythrin in microemulsions of aerosol OT/water/isooctane

Taking advantage of its unusual fluorescent properties, the incorporation of B-phycoerythrin (B-PE) in aerosol OT (AOT, sodium bis-(2-ethylhexyl) sulphosuccinate)/water/isooctane microemulsions was investigated by following their steady-state and time-resolved fluorescence as a function of the water-to-surfactant molar ratio, w(0). The fluorescent intensity at 575 nm increased continuously with increasing water content, saturating at a w(0) around 35 and staying practically constant at w(0)> or =40. The steady-state anisotropy showed an initial increase with increasing water content until w(0)=23 and then decreased strongly, staying practically constant when w(0)> or =40. The values of the fluorescent parameters, anisotropy and fluorescent intensity, were unchanged when the water content of the system increased in the range between w(0)=40 to 50. This implies the effective incorporation of B-PE in the microemulsion droplets with w(0)> or =40, as well as the equilibrium of the dispersion at these water/surfactant ratios, since higher water content does not affect the main surrounding microenvironment of the protein. The overall incorporation in the microemulsion droplets caused minor spectroscopic changes with respect to biliprotein in aqueous solution of 20 mM sodium phosphate buffer, pH 7.0, such as a blue absorption shift of 3 nm and an emission shift of 1.5 nm, as well as a slight increase in excitation anisotropy spectrum mainly caused by a decrease in protein mobility. Therefore, there are no important interactions between the chromophores and the AOT sulfonate head groups. Emission intensity decays followed complex kinetics in both aqueous and dispersion media. The stability with time and temperature of the biliprotein in the microemulsion was higher than in the aqueous solution. All the results can be explained in terms of B-PE inclusion in the water droplets of AOT microemulsions where the protein has similar configuration and conformation to that in aqueous solution but with the chromophores more protected.     

Quantitative analysis of bilobalide and ginkgolides from Ginkgo biloba leaves and Ginkgo products using (1)H-NMR

1H-NMR spectrometry was applied to the quantitative analysis of the bilobalide, ginkgolides A, B, and C in Ginkgo biloba leaves and six kinds of commercial Ginkgo products without any chromatographic purification. The experiment was performed by the analysis of each singlet H-12, which were well separated in the range of delta 6.0-7.0 in the (1)H-NMR spectrum. However, the H-12 protons of bilobalide and ginkgolides may have overlapped with H-6 or H-8 protons of the Ginkgo flavonoids. Therefore, the optimum (1)H-NMR solvent for the analysis of the compound was selected through the evaluation of solvent effects on the resolution of these signals from the compounds. Acetone-d(6)-benzene-d(6) (50 : 50) was found to be the best one among the solvents evaluated. The quantity of the compounds was calculated by the relative ratio of the intensity of each compound to the known amount of internal standard (25 microgram), phloroglucinol. This method allows rapid and simple quantitation of underivatized bilobalide and ginkgolides in 5 min without any pre-purification steps.     

Voltammetric studies of a psychotropic drug with nitro groups. Determination of flunitrazepam in urine using HMDE

The adsorption behaviour of flunitrazepam at the hanging mercury drop electrode was studied by staircase voltammetry and by adsorptive stripping differential pulse voltammetry. Flunitrazepam is adsorbed in the whole potential range, from the most positive values up to the reduction potential. Flunitrazepam reduction product is also adsorbed. The time dependence of the voltammetric response proves that a diffusion-controlled adsorption takes place. Flunitrazepam can be determined (down to nanomolar levels) by using adsorptive preconcentration prior to the differential pulse voltammetric scan. An application of such a method to flunitrazepam determination in human urine is described. The detection limit was 30 ng per milliliter of urine with a 20-sec accumulation time; the mean relative standard deviation was lower than 3.2% and the mean recovery 97.8%.     

Direct electrochemical synthesis of N-oxopyridine-2-thionato complexes of nickel(II), cobalt(II) and cobalt(III)

Summary The electrochemical oxidation of anodic metal (nickel or cobalt) in MeCN solutions of 1-hydroxy-2-pyridinethione (HPT) gives [Ni(PT)₂], [Co(PT)₂] or [Co(PT)₃]. When 1,10-phenanthroline (phen) or 2,2-bipyridine (bipy) are added to the electrolytic phase the product is a complex, [Ni(PT)₂L] or [Co(PT)₂L] (L = bipy or phen). The i.r., u.v. and ¹H- and ¹³C-n.m.r. spectra of the complexes are discussed.This paper was presented at the 5th Inorganic Chemistry Meeting of the Royal Spanish Chemical Society, Tossa de Mar, Girona, Spain, September 1991.     

Utilization of flash chromatography for the fractionation of coal derived liquids

Summary The suitability of flash chromatography for the fractionation of coal liquids in compound classes has been studied. TLC data obtained from standards were used for establishing the sequence, composition and volume of eluents in order to collect the main components of coal liquids in six fractions of increasing polarity. The method was tested by the fractionation of a SCG coal extract and separations were evaluated by TLC, SEC, and IR and NMR spectroscopy.     

Direct electrochemical synthesis and characterization of copper(II), iron(II) and iron(III) complexes with 1- and 2-substituted pyridines

Summary The electrochemical oxidation of anodic metals (iron and copper) in MeCN solutions of 2-pyridinone (HOPy), 1-hydroxy-2-pyridinethione (HPT), 2-pyridinemethanethiol-1-oxide (HPMTO) or its dimer 2,2-dithiodimethyldipyridine-1,1-dioxide (PMTO)₂, gave the simple complexes Fe(OPy)₂ · H₂O, Cu(OPy)₂ · 3H₂O, Fe(PT)₂ · 3H₂O, Fe(PT)₃, Cu(PT)₂, Fe(PMTO)₂·3H₂O and Cu(PMTO)₂·H₂O, respectively. When 1,10-phenanthroline (phen) was added to the electrolytic phase, only two mixed complexes were obtained: Cu(OPy)₂phen·3H₂O and Fe(PT)₂phen·2H₂O. The possible molecular structures of the complexes were studied on the basis of their i.r. spectra and magnetic properties.