A new electrochemical method for trace water determination in methanol

A new electrochemical method for the determination of trace water in methanol has been developed. This method is based on the effect, that a minor change in the water content affects the value of conductivity measured for dissolved in the solutions electrolyte. The conductivity measurements were performed for four inorganic salts, i.e. NaCl, KCl, RbCl, and CsCl in solutions with different amounts of water traces in methanol and the calibration curves for three of them were determined. With the exception of cesium chloride the high values of correlation coefficients for the regression lines as well as low limits of detection were achieved in all cases which indicates that this method is a useful tool for the determination of the trace amounts of water in methanol.     

Catalytic, asymmetric cyanohydrin synthesis in propylene carbonate

Propylene carbonate can be used as a green solvent for asymmetric cyanohydrin synthesis catalyzed by VO(salen)NCS. A range of 10 aromatic and aliphatic aldehydes gave high enantioselectivities (up to 93%) and conversions (up to 100%) in reactions carried out at or near room temperature with reaction times of 24 h or less.     

Development and validation of a pressurized liquid extraction liquid chromatography–tandem mass spectrometry method for perfluorinated compounds determination in fish

This paper describes the development and validation of an analytical methodology to determine eight perfluorinated compounds (PFCs) in edible fish using pressurized liquid extraction (PLE) with water and solid-phase extraction (SPE) with an ion-exchanger as extraction and pre-concentration procedures, followed by liquid chromatography–quadrupole-linear ion trap mass spectrometry (LC–QqLIT–MS). The rapidity and effectiveness of the proposed extraction procedure were compared with those most commonly used to isolate PFCs from fish (ion-pairing and alkaline digestion). The average recoveries of the different fish samples, spiked with the eight PFCs at three levels (the LOQ, 10 and 100 μg kg⁻¹ of each PFC), were always higher than 85% with relative standard deviation (RSD) lower than 17%. A good linearity was established for the eight PFCs in the range from 0.003–0.05 to 100 μg kg⁻¹, with r > 0.9994. The limits of quantification (LOQs) were between 0.003 and 0.05 μg kg⁻¹, which are well below those previously reported for this type of samples. Compared with previous methods, sample preparation time and/or LOQs are reduced. The method demonstrated its successful application for the analysis of different parts of several fish species. Most of the samples tested positive, mainly for perfluoropentanoic acid (PFPA), perfluorobutane sulfonate (PFBS) and perfluorooctanoic acid (PFOA) but other of the eight studied PFCs were also present.     

Metal Nitride Cluster Fullerene M3N@C80 (M=Y,Sc) Based Dyads: Synthesis,and Electrochemical,Theoretical and Photophysical Studies

The first pyrrolidine and cyclopropane derivatives of the trimetallic nitride templated (TNT) endohedral metallofullerenes I_h‐Sc₃N@C₈₀ and I_h‐Y₃N@C₈₀ connected to an electron‐donor unit (i.e., tetrathiafulvalene, phthalocyanine or ferrocene) were successfully prepared by 1,3‐dipolar cycloaddition reactions of azomethine ylides and Bingel–Hirsch‐type reactions. Electrochemical studies confirmed the formation of the [6,6] regioisomers for the Y₃N@C₈₀‐based dyads and the [5,6] regioisomers in the case of Sc₃N@C₈₀‐based dyads. Similar to other TNT endohedral metallofullerene systems previously synthesized, irreversible reductive behavior was observed for the [6,6]‐Y₃N@C₈₀‐based dyads, whereas the [5,6]‐Sc₃N@C₈₀‐based dyads exhibited reversible reductive electrochemistry. Density functional calculations were also carried out on these dyads confirming the importance of these structures as electron transfer model systems. Furthermore, photophysical investigations on a ferrocenyl–Sc₃N@C₈₀‐fulleropyrrolidine dyad demonstrated the existence of a photoinduced electron‐transfer process that yields a radical ion pair with a lifetime three times longer than that obtained for the analogous C₆₀ dyad.     

Highly anisotropic distribution of iron nanoparticles within MCM-41 Mesoporous Silica

Electron microscopy techniques are used to visualize the spatial distribution of iron nanoparticles inside a mesoporous MCM-41 molecular sieve. Direct observation of the iron oxide nanoparticles by STEM-HAADF imaging reveals a highly non-uniform spatial distribution inside the mesopores. These particles are retained in the pores after a reduction treatment unlike the behavior found in other similar systems. It is found that thermal treatments induce changes in its morphology, creating nanowires from particle strings.     

Major terpenoids from Telekia speciosa flowers and their cytotoxic activity in vitro

In addition to known constituents of Telekia speciosa, an acetone extract from ray florets of the plant yielded: 5,5?-dibutoxy-2,2?-bifuran (1), 5,5?-diisobutoxy-2,2?-bifuran (2), α-tocopherol (3), β-tocopherol (4), loliolide palmitate (5), a mixture of calenduladiol esters - 16β-hydroxylupeol-3-O-palmitate (7) and 16β-hydroxylupeol-3-O-myristate (8), 1-epiinuviscolide (12), inuviscolide (13), 3-epiisotelekin (16), 4α-hydroxy-9β,10β-epoxy-1β(H)-11(13)-guaien-8α,12-olide (17), 4α-hydroxy-1β(H)-9(10),11(13)-guaiadien-8α,12-olide (18), loliolide (19) and 4β,10β-dihydroxy-1α(H),5α(H)-11(13)-guaien-8α,12-olide (20). Calenduladiol esters and asperilin (14) were the major constituents of the extract. Their cytotoxic effect on human normal prostate epithelial cells (PNT-2), human prostate carcinoma cell lines, human skin fibroblasts (HSF) and human melanoma cell lines was examined in vitro. Triterpene esters showed no cytotoxicity against nearly all cell lines tested, except for Du145 prostate carcinoma cells (IC₅₀ – 62.0 μΜ). Asperilin displayed activity against the cell lines under study, especially against three tested lines of melanomas (A375, IC₅₀ – 17.6 μΜ, WM793, IC₅₀ – 28.2 μΜ and Hs 294T, IC₅₀ – 29.5 μΜ).     

Porous Microstructured Surfaces with pH‐Triggered Antibacterial Properties

New antibacterial films are designed with the capability to reversibly regulate their killing and repelling functions in response to variations in environmental pH. These systems consist of porous polystyrene surfaces as the main components and a copolymer bearing pH‐sensitive thiazole and triazole groups as the minor components. These pH‐sensitive groups, located on the surfaces, can be partially protonated at acidic pH levels, increasing the positive charge density of the surfaces and their antibacterial activity. Similarly, their bacterial adhesion and killing efficiencies in response to changes in pH are evaluated by analyzing the bacterial viability of Staphylococcus aureus bacteria on the surfaces under acidic and neutral pH values. It is demonstrated that after only 1 h of incubation with the bacterial suspension in acidic conditions, the surfaces killed the bacteria, while at pH = 7.4, some of the adhered bacteria are removed. Furthermore, the surface topography exerts an important role by intensifying this response.     

Implementation of at‐line capillary zone electrophoresis for fast and reliable determination of adenovirus concentrations in vaccine manufacturing

A CZE method was validated and implemented for fast and accurate in‐process determination of adenovirus concentrations of downstream process samples obtained during manufacturing of adenovirus vector‐based vaccines. An analytical‐quality‐by‐design approach was embraced for method development, method implementation, and method maintenance. CZE provided separation of adenovirus particles from sample matrix components, such as cell debris, residual DNA and proteins. The intermediate precision of the virus particle concentration was 6.9% RSD and the relative bias was 2.3%. In comparison, the CZE method is intended to replace a quantitative polymerase chain reaction method which requires three replicates in three analytical runs to achieve an intermediate precision of 8.1% RSD. Given that, in addition, the time from sampling till reporting results of the CZE method was less than 2 h, whereas quantitative polymerase chain reaction requires 3 days, it follows that the CZE method enables faster processing times in downstream processing.     

Solid-phase synthesis of biaryl cyclic peptides containing a histidine-tyrosine linkage

A solid-phase strategy for the synthesis of biaryl cyclic peptides containing a side-chain to side-chain His-Tyr linkage was developed. The key step was the macrocyclization of a linear peptidyl resin incorporating a 5-bromohistidine and a 3-boronotyrosine via the formation of the biaryl bond by means of a microwave-assisted Suzuki-Miyaura reaction. This method allowed direct access to biaryl cyclic peptides containing a 3- or 5-amino acid ring and bearing the histidine residue at the N- or the C-terminus, being especially conducive for analogues in which this amino acid is located at the C-terminus. This study also served to establish a strategy for the synthesis of biaryl cyclic peptides derived from the two hemispheres of the natural biaryl bicyclic peptides aciculitins.     

Low-Temperature Dynamical Transition in Lipid Bilayers Detected by Spin-Label ESE Spectroscopy

Data on neutron scattering in biological systems show low-temperature dynamical transition between 170 and 230 K manifesting itself as a drastic increase of the atomic mean-squared displacement, 〈x²〉, detected for hydrogen atoms in the nano- to picosecond time scale. For spin-labeled systems, electron spin echo (ESE) spectroscopy—a pulsed version of electron paramagnetic resonance—is also capable of detection of dynamical transition. A two-pulse ESE decay in frozen matrixes is induced by spin relaxation arising from stochastic molecular librations, and allows to obtain the 〈α²〉τ_c parameter, where 〈α²〉 is a mean-squared angular amplitude of the motion and τ_c is the correlation time lying in the sub- and nanosecond time ranges. In this work, the ESE technique was applied to spin-labeled amphiphilic molecules of three different kinds embedded in bilayers of fully saturated 1,2-dipalmitoyl-sn-glycero-3-phosphocholine (DPPC) and mono-unsaturated 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphocholine (POPC) lipids. Two-pulse ESE data revealed the appearance of stochastic librations above 130 K, with the parameter 〈α²〉τ_c obeying the Arrhenius type of temperature dependence and increasing remarkably above 170–180 K. A comparison with a dry sample suggests that onset of motions is not related with lipid internal motions. Three-pulse ESE experiments (resulting in stimulated echos) in DPPC bilayers showed the appearance of slow molecular rotations above 170–180 K. For D₂O-hydrated bilayers, ESE envelope modulation experiments indicate that isotropic water molecular motions in the nearest hydration shell of the bilayer appear with a rate of ~?10⁵ s^?1 in the narrow temperature range between 175 and 179 K. The similarity of the experimental data found for three different spin-labeled compounds suggests a cooperative character for the ESE-detected molecular motions. The data were interpreted within a model suggesting that dynamical transition is related with overcoming barriers, of 10–20 kJ/mol height, existing in the system for the molecular reorientations.