The rate of the reactions of C2O radicals with H and H2

The rate constants for the reactions C₂O + H → products (1) and C₂O + H₂ → products (2) have been determined at room temperature by means of laser-induced fluorescence detection of C₂O radicals, generated either by the KrF excimer laser photolysis Of C₃O₂, or by the reaction of C₃O₂ with O atoms. Values of k₁ = (3.7 ± 1.0) × 10^?11 cm³ s^?1 and k₂ = (7 ± 3) × 10^?13 cm³ s^?1 were obtained.     

Association of hydrofluoric acid in NaCl aqueous media under hydrothermal conditions

The apparent association constant of hydrofluoric acid Q _HF ^' in 1m NaCl aqueous media has been determined potentiometrically at pressures up to 1 kbar and temperatures up to 250°C. A concentration cell employing hydrogen electrodes was used. The association of HF increases with increasing temperature but decreases with increasing pressure.     

THE PHOTOSENSITIZERS BENZOPHENOXAZINE and THIAZINES: COMPREHENSIVE INVESTIGATION OF PHOTOPHYSICAL and PHOTOCHEMICAL PROPERTIES

Eight differently substituted title dye compounds have been investigated regarding intersystem crossing, triplet state, fluorescence and singlet excited state pKa properties. In general, non-halogenated oxazines and thiazines as well as a mono bromooxazine show very low triplet quantum yields, phi tau (less than 0.03) and relatively long triplet lifetimes (approximately 40 microseconds) in acidic methanol. The phi tau data correlate well with known singlet oxygen yields. In basic methanol no triplet transient is observed but a significant yield of a ground state transient protonated (base dye) form is produced with a short lifetime, approximately 400 ns. Fluorescence can be seen simultaneously from both the excited base and the protonated base dye forms in basic methanol. For iodinated oxazine or thiazines, the triplet yield increases and can be as high as 0.5 (diiodo case) in acidic methanol. The triplet lifetimes are further shortened to approximately 10 microseconds compared to the non-iodinated derivatives above. The triplet yields of the iodo compounds are higher or equal to known singlet oxygen yields. In basic methanol triplet yields up to 0.2 can be seen, the triplet lifetime are shortened still further to 1 microsecond but no observable protonated form is produced (in distinction to the non-iodinated cases). Consideration is given to the correlation of triplet and singlet oxygen yields, ground and excited pKa properties, spin-orbit coupling and internal conversion properties, solvent effects, and phototherapeutic activity of these dyes.     

Trimethylsilylverbindungen der Vb-Elemente. VII. Die Kristallstrukturen von Lithium-bis(trimethylsilyl)bismutid · DME und Tetrakis(trimethylsilyl)dibismutan sowie Bemerkungen zur Kristallstruktur des Bis(4-methoxyphenyl)ditellans

Trimethylsilyl Derivatives of Vb Elements. VII. Crystal Structures of Lithium Bis(trimethylsilyl)bismuthide · DME and of Tetrakis(trimethylsilyl)dibismuthane as well as Some Comments on the Crystal Structure of Bis(4-methoxyphenyl)ditellane Colourless lithium bis(trimethylsilyl)bismuthide · DME

1 1,2-Dimethoxyethan (DME); Tetrahydrofuran (THF)

1 and green, metallic lustrous tetrakis(trimethylsilyl)dibismuthane 2 crystallize isotopic to their antimony homologues [1, 2]. As it is shown by crystal structure determinations { 1 : ?90°C; I 4 2d; a = 1017,3(4); c = 3738,0(26) pm; Z = 8; R _w = 0,065; 2 : + 20°C; P2 ₁ /c; a = 680,9(4); b = 1704,8(13); c = 1197,9 (10) pm; β = 119,46(6)°; Z = 2; R _w = 0,084} both compounds form chains which in the case of bismuthide 1 are built up as screws of alternating bismuth and lithium atoms; bonding further to two trimethylsilyl groups or to the chelating DME ligand both atoms gain coordination number 4 {Li? Bi 292(3); Bi? Si 263.3(14) pm; Bi? Li? Bi 132(1); Li? Bi? Li 148(1); φ(Li? Bi? Li? Bi) 83°}. In the case of dibismuthane 2 the centrosymmetric molecules are strung, their Bi-Bi groups forming nearly linear zigzag chains with shortened intermolecular contact distances {Bi-Bi 303.5(3); Bi …? Bi 380.4(3); Bi? Si 268 pm; Bi? Bi …? Bi 169; Bi? Bi? Si 97.4(5) and 92.0(5)°}. Structure and properties of 2 are compared with those of similar compounds; the crystal structure of brown, green metallic lustrous bis(4-methoxyphenyl)ditellane 5 already published by Ludlow and McCarthy[3] is reinvestigated with respect to very short intermolecular Te…?Te contacts.     

Dielectronic recombination of lithium-like Ar15+

Dielectronic recombination (DR) of Ar¹⁵⁺(1s ²2s) ions was studied in a single-pass merged-beams experiment at the UNILAC (universal linear accelerator) of GSI. Absolute recombination rates and cross sections were measured for electron-ion center-of-mass energies from 0 to 580 eV. A number of Rydberg states formed by DR with 2s → 2p (Δn=0) and 2s → 3? (Δn=1) core excitations and even individual terms in the 1s ²3?3?′ configuration could be resolved. Theoretical calculations of DR cross sections are in good overall agreement with the data. In the calculations for Δn=0 transitions, effects of electric fields have to be included to reproduce the magnitude of the measured DR rates at the limit of the 2 _{p 1/2}? and 2 _{p 3/2}? Rydberg series. Discrepancies between theory and experiment are observed at the series limits of the (1s ²3?n?′) Rydberg series.     

Thermal decompositions of kaolinite intercalation compounds

Through a combination of X-ray diffraction and thermal analysis (simultaneous TG-DTG-DTA and quasi-isothermal TG), it was shown that the molar ratio intercalation agent/kaolinite in all intercalation compounds is approximately 1. In a saturated atmosphere of the corresponding intercalation agent, the intercalation compounds are stable up to more than 150 °C.Decomposition of the potassium acetate intercalation compound proceeds simultaneously with the dehydroxylation of kaolinite at an extrapolated onset temperature of 360 °C. The high-temperature reactions (dehydroxylation and transformation) of kaolinite obtained through the decomposition of intercalation compounds with volatile intercalation agents depend on the conditions applied during decomposition.

---

Zusammenfassung Mittels Röntgenbeugung und thermischer Analyse (simultane TG-DTG-DTA und quasi-isotherme-quasi-isobare TG) konnte gezeigt werden, daß das molare Verhältnis Einlagerungsmedium/Kaolinit in allen Einlagerungsverbindungen etwa 1 ist. In gesättigter Atmosphäre des jeweiligen Einlagerungsmediums ist die Einlagerungsverbindung stabil bis über 150 °C. Die Zersetzung der Kaliumacetat-Einlagerungsverbindung läuft zusammen mit der Dehydroxylation des Kaolinits bei einer extrapolierten onset-Temperatur von 360 °C ab. Die Hochtemperaturreaktionen (Dehydroxylation, Phasenneubildung) von Kaolinit, der aus der Zersetzung von Einlagerungsverbindungen mit flüchtigen Einlagerungsmedien erhalten würde, werden von den Zersetzungsbedingungen beeinflußt.

---

- ( , , ) , - 1. , , 150°. — ** 360°, ** . , , .

     

Energetic and kinetic investigation of thermally induced molecular rearrangements of esters of (hydroxymethyl) hydridosilanes by DSC

Silanes of the type R¹R²Si(H)CH₂OEl(O)_xR _y ³ [R=organyl; El=C (x=y=1), S (x=2,y=1), P (x=1y=2)] undergo a thermally induced rearrangement to give silanes of the type R¹R²Si (CH₃)OEl(O)_xR _y ³ . The energetic (reaction enthalpy) and kinetic data (reaction order, enthalpy and entropy of activation) of this reaction were determined by means of differential scanning calorimetry. The results obtained are discussed in terms of mechanistic aspects.

---

Zusammenfassung Silane des Typs R¹R²Si(H)CH₂OE10_xR _y ³ mit R=organyl; E1=C (x=y=1), S(x=2, y=1) oder P (x=1,y=2) zeigen eine thermisch induzierte Umlagerung zu Silanen des Typs R¹R²Si(CH₃)OE10_xR _y ³ . Energetische (Reaktionsenthalpie) und kinetische Daten (Reaktionsordnung, Aktivierungsenthalpie und -entropie) dieser Umlagerungsreaktion wurden mittels DSC ermittelt. Die mechanistischen Aspekte der Ergebnisse werden diskutiert.

---

R¹R²Si(H)OE1(O)_xR _y ³ , R= , E1=C (x=y=1), S (x=2,y=1), P (x=1,y=2), R¹R²Si(CH₃)OE1(O)_xR _y ³ . ( ) ( , ) . .

---

     

Quantitative determination of element distributions in silicon based thin film solar cells using SNMS

The determination of elemental distributions in thin film solar cells based on amorphous silicon using electron beam SNMS is possible by quantifying the measured ion intensities. The relative sensitivity factors (RSFs) for all elements measured have to be known. The RSFs have been determined experimentally using implantation and bulk standards with known concentrations of the interesting elements. The measured RSFs have been compared with calculated RSFs. The model used for the calculation of the RSFs takes into account the probability for electron impact ionization and the dwell time of the neutrals inside the postionization region. The comparison between measured and calculated RSF shows, that this model is capable to explain the RSFs for most elements. Differences between calculated and measured values can be explained by the formation of hydride and fluoride molecules (in case of H and F) and influences of the angular distribution of the sputtered neutrals in case of Al. The experimentally determined RSFs have been used for a quantification of depth profiles of the i-, buffer-, p- and front contact layers of a-Si solar cells.     

Bead cellulose derivatives as supports for immobilization and chromatographic purification of proteins

Characteristic data are presented for Divicell, a macroporous bead cellulose with excellent flow parameters. The preparation of Divicell derivatives and their properties are described with respect to their application as chromatographic supports. The ion exchangers Divicell DEAE and Divicell CM were manufactured in two types with different exclusion limits and an available capacity for proteins of up to 100 mg/ml gel. Divicell Blue is a bead cellulose with covalently bound Cibacron Blue F3G-A and was found to be a very suitable adsorbent for the selective separation and purification of human serum albumin. Activation of Divicell with sodium periodate, epichlorohydrin and 5-norbornene-2,3-dicarboximido carbonochloridate provided activated supports used for immobilization of ligands in organic solvents and in aqueous solutions. Coupling of amines, diamines, amino acids, carbohydrates and proteins is described. The immobilized ligands retained their biological activity as determined by their specific adsorption of proteins. Divicell alkyl derivatives were tested in hydrophobic interaction chromatography with bovine serum albumin as a model. Examples are presented of the application of Divicell derivatives to the purification of biomacromolecules such as immunoglobulins and lectins by affinity chromatography. The results were comparable to those obtained using the corresponding Sepharose-derived absorbents.