Validation of a confirmatory method for lipophilic marine toxins in shellfish using UHPLC-HR-Orbitrap MS

Lipophilic marine toxins are produced by harmful microalgae and can accumulate in edible filter feeders such as shellfish, leading to an introduction of toxins into the human food chain, causing different poisoning effects. During the last years, analytical methods, based on liquid chromatography coupled to tandem mass spectrometry (LC-MS/MS), have been consolidated by interlaboratory validations. However, the main drawback of LC-MS/MS methods remains the limited number of compounds that can be analyzed in a single run. Due to the targeted nature of these methods, only known toxins, previously considered during method optimization, will be detected. Therefore in this study, a method based on ultra-high-performance liquid chromatography coupled to high-resolution Orbitrap mass spectrometry (UHPLC-HR-Orbitrap MS) was developed. Its quantitative performance was evaluated for confirmatory analysis of regulated lipophilic marine toxins in shellfish flesh according to Commission Decision 2002/657/EC. Okadaic acid (OA), dinophysistoxin-1 (DTX-1), pectenotoxin-2 (PTX-2), azaspiracid-1 (AZA-1), yessotoxin (YTX), and 13-desmethyl spirolide C (SPX-1) were quantified using matrix-matched calibration curves (MMS). For all compounds, the reproducibility ranged from 2.9 to 4.9 %, repeatability from 2.9 to 4.9 %, and recoveries from 82.9 to 113 % at the three different spiked levels. In addition, confirmatory identification of the compounds was effectively performed by the presence of a second diagnostic ion (¹³C). In conclusion, UHPLC-HR-Orbitrap MS permitted more accurate and faster detection of the target toxins than previously described LC-MS/MS methods. Furthermore, HRMS allows to retrospectively screen for many analogues and metabolites using its full-scan capabilities but also untargeted screening through the use of metabolomics software. Figure

?     

Determination of parabens in wastewater samples via robot-assisted dynamic single-drop microextraction and liquid chromatography–tandem mass spectrometry

Dynamic single-drop microextraction (SDME) was automatized employing an Arduino-based lab-made Cartesian robot and implemented to determine parabens in wastewater samples in combination with liquid chromatography–tandem mass spectrometry. A dedicated Arduino sketch controls the auto-performance of all the stages of the SDME process, including syringe filling, drop exposition, solvent recycling, and extract collection. Univariate and multivariate experiments investigated the main variables affecting the SDME performance, including robot-dependent and additional operational parameters. Under selected conditions, limit of detections were established at 0.3 µg/L for all the analytes, and the method provided linear responses in the range between 0.6 and 10 µg/L, with adequate reproducibility, measured as intraday relative standard deviations (RSDs) between 5.54% and 17.94%, (n = 6), and inter-days RSDs between 8.97% and 16.49% (n = 9). The robot-assisted technique eased the control of dynamic SDME, making the process more feasible, robust, and reliable so that the developed setup demonstrated to be a competitive strategy for the automated extraction of organic pollutants from water samples.     

Development of ultra-high-performance supercritical fluid chromatography-mass spectrometry assays to analyze potential biomarkers in sweat

Liquid chromatography-mass spectrometry methods were required to afford the rapid separation and detection of purines and small organic acids. These compounds are found in sweat and sebum and are potential biomarkers for the early detection of pressures sores. Two ultra-high-performance supercritical fluid chromatography-mass spectrometry assays have been successfully developed for both classes of compounds. Separation for purines was achieved using a gradient of supercritical carbon dioxide and methanol with a 1-aminoanthracene sub 2 μm particle size column followed by positive ion electrospray ionization. Separation for organic acids was achieved using a gradient of supercritical carbon dioxide and methanol (50 mM ammonium acetate 2% water) with a Diol sub 2 μm particle size column followed by negative ion electrospray ionization. Calibration curves were created in the absence of internal standards and R² values > 0.96 were achieved using single ion monitoring methods for the protonated purines and the deprotonated acids. The two new assays afford rapid analytical methods for the separation and detection of potential biomarkers in human sweat leading to the early detection and prevention of pressure sores.     

Potential Mitigation of Smoke Taint in Wines by Post-Harvest Ozone Treatment of Grapes

When bushfires occur near grape growing regions, vineyards can be exposed to smoke, and depending on the timing and duration of grapevine smoke exposure, fruit can become tainted. Smoke-derived volatile compounds, including volatile phenols, can impart unpleasant smoky, ashy characters to wines made from smoke-affected grapes, leading to substantial revenue losses where wines are perceivably tainted. This study investigated the potential for post-harvest ozone treatment of smoke-affected grapes to mitigate the intensity of smoke taint in wine. Merlot grapevines were exposed to smoke at ~7 days post-veraison and at harvest grapes were treated with 1 or 3 ppm of gaseous ozone (for 24 or 12 h, respectively), prior to winemaking. The concentrations of smoke taint marker compounds (i.e., free and glycosylated volatile phenols) were measured in grapes and wines to determine to what extent ozonation could mitigate the effects of grapevine exposure to smoke. The 24 h 1 ppm ozone treatment not only gave significantly lower volatile phenol and volatile phenol glycoside concentrations but also diminished the sensory perception of smoke taint in wine. Post-harvest smoke and ozone treatment of grapes suggests that ozone works more effectively when smoke-derived volatile phenols are in their free (aglycone) form, rather than glycosylated forms. Nevertheless, the collective results demonstrate the efficacy of post-harvest ozone treatment as a strategy for mitigation of smoke taint in wine.     

Unraveling the Crystal Structure of Lanthanide–Murexide Complexes: Use of an Ancient Complexometry Indicator as a Near‐Infrared‐Emitting Single‐Ion Magnet

Herein, we provide some structural evidence of the complexation color‐change of murexide solutions in presence of lanthanide, which has been used for decades in complexometric studies. For Ln=Sm to Lu and Y, the compounds crystallize as monomeric [Ln(Murex)₃] ? 11 H₂O with an N3O6 tricapped square‐antiprism environment, which are stable up to 250 °C. Single‐ion magnet (SIM) behavior is then observed on the Yb^III derivative in an original nine‐coordinated environment. In‐field slow relaxation (Δ=(15.6±1) K; τ₀=2.73×10^?6 s) is observed with a very narrow distribution of the relaxation time (α_max=0.09). Magnetic and photophysical properties can be correlated. On one hand the analysis of NIR emission spectrum permits to have access to crystal field parameters and to compare them with those extracted from dc measurements. On the other hand, magnetic measurements permit to identify the nature of the M _J states involved in the ²F_5/2→²F_7/2 luminescence spectrum. The gap between the low‐lying states is in agreement with the energy barrier obtained from magnetic slow‐relaxation measurement.     

Tuning Lanthanide Reactivity Towards Small Molecules with Electron‐Rich Siloxide Ligands

The synthesis, structure, and reactivity of stable homoleptic heterometallic LnL₄K₂ complexes of divalent lanthanide ions with electron‐rich tris(tert‐butoxy)siloxide ligands are reported. The [Ln(OSi(OtBu)₃)₄K₂] complexes (Ln=Eu, Yb) are stable at room temperature, but they promote the reduction of azobenzene to yield the KPhNNPh radical anion as well as the reductive cleavage of CS₂ to yield CS₃^2? as the major product. The Eu^III complex of the radical anion PhNNPh is structurally characterized. Moreover, [Yb(OSi(OtBu)₃)₄K₂] can reduce CO₂ at room temperature. Release of the reduction products in D₂O shows the quantitative formation of both oxalate and carbonate in a 1:2.2 ratio. The bulky siloxide ligands enforce the labile binding of the reduction products providing the opportunity to establish a closed synthetic cycle for the Yb^II‐mediated CO₂ reduction. These studies show that the presence of four electron‐rich siloxide ligands renders their Eu^II and Yb^II complexes highly reactive.     

Revealing the Distribution of the Atoms within Individual Bimetallic Catalyst Nanoparticles

To be able to correlate the catalytic properties of nanoparticles with their structure, detailed knowledge about their make‐up on the atomic level is required. Herein, we demonstrate how atom‐probe tomography (APT) can be used to quantitatively determine the three‐dimensional distribution of atoms within a Au@Ag nanoparticle with near‐atomic resolution. We reveal that the elements are not evenly distributed across the surface and that this distribution is related to the surface morphology and residues from the particle synthesis.     

What's Hot,What's Not: The Trends of the Past 20 Years in the Chemistry of Odorants

This review is the sequel to the 2000 report on the recent advances in the chemistry of odorants and it summarizes the developments in fragrance chemistry over the past 20 years. Following the olfactory spectrum set out in that report, trendsetting so‐called captive odorants (patent‐protected ingredients unavailable to the market) are presented according to the main odor families: “fruity”, “marine”, “green”, “floral”, “spicy”, “woody”, “amber”, and “musky”. The design of odorants, their chemical synthesis, and their use in modern perfumery are illustrated with prominent examples. Featured are new fruity odorants that provide signature in the top note, as well as precursor technology. In the green domain, focus is on leafy notes and green pear. New benzodioxepines and benzodioxoles have modernized the marine family and required a revision of the existing olfactophore models. The replacement of Lilial and Lyral kept the industry busy in the floral domain with a plethora of new “muguets”. There was continued activity in the domain of rose odorants, especially in the area of rose ketones. Biotechnology became significant, for example, with Clearwood and Ambrofix, and the principal odorants of vetiver oil in the woody family have been found. Fourth and fifth families of musk odorants were also discovered and populated. Thus, new avenues for further explorations into fragrance chemistry have been opened.     

Correlation analysis of reactivity in the addition of substituted benzylamines to ethyl α-cyanocinnamate

The kinetics of addition of a number of ortho-, meta-, and para-substituted benzylamines to ethyl α-cyanocinnamate (ECC) in acetonitrile have been studied. The reaction is first-order with respect to the amine and ECC. The rates of reaction of meta- and para-substituted benzylamines showed excellent correlations with Taft's σ₁ and σ_R⁰, and with σ₁ and σ_R^BA values, respectively. The reaction of the ortho-compounds showed a very good correlation with Charton's triparametric equation. The reaction is subject to steric hindrance by the ortho-substituents. A mechanism involving formation of a zwitterionic intermediate in a slow step followed by a fast proton transfer has been proposed. © 1996 John Wiley & Sons, Inc.     

An Inexpensive Laser Raman Spectrometer Based on CCD Detection

We describe an inexpensive modular Raman spectrometer system that can be assembled from commercial components for under $5000. Three typical applications are presented: a demonstration of a vibrational isotope effect, a Raman polarization experiment, and a resonance Raman experiment. This spectrometer system should make it easier to include the important topic of Raman spectroscopy in the undergraduate physical and analytical chemistry laboratory curricula.