Kinetics of Oxidation of L‐Cysteine by trans‐ and cis‐CoIII and FeIII Complexes based on α‐ and γ‐Diimine Schiff Base Ligands

Kinetics of oxidation of L ‐cysteine by Co^III and Fe^III complexes based on α‐ and γ‐diimine Schiff base ligands were studied in aqueous solution. Pairs of trans and cis isomers of the metal complexes were used in the studies. Kinetic measurements were performed at 25 °C and constant pH and ionic strength under pseudo‐first order condition, in which the concentration of cysteine was around two orders of magnitude greater than that of the metal complex. The observed rate constant was obtained by following the change in absorbance of the reaction mixture with time at a predetermined wavelength. The overall rate constant and order of the reaction with respect to cysteine and metal complex were determined. For both metal ions studied, the oxidation rate constant for the trans isomer was higher than that for the cis isomer. This was attributed to the contribution of the steric factor and the trans effect. The effects of substituents and the nature of the metal ion on the reaction rate are discussed.     

Radiation Damage and Racemic Protein Crystallography Reveal the Unique Structure of the GASA/Snakin Protein Superfamily

Proteins from the GASA/snakin superfamily are common in plant proteomes and have diverse functions, including hormonal crosstalk, development, and defense. One 63‐residue member of this family, snakin‐1, an antimicrobial protein from potatoes, has previously been chemically synthesized in a fully active form. Herein the 1.5 Å structure of snakin‐1, determined by a novel combination of racemic protein crystallization and radiation‐damage‐induced phasing (RIP), is reported. Racemic crystals of snakin‐1 and quasi‐racemic crystals incorporating an unnatural 4‐iodophenylalanine residue were prepared from chemically synthesized d ‐ and l ‐proteins. Breakage of the C?I bonds in the quasi‐racemic crystals facilitated structure determination by RIP. The crystal structure reveals a unique protein fold with six disulfide crosslinks, presenting a distinct electrostatic surface that may target the protein to microbial cell surfaces.     

Cold Sintering: A Paradigm Shift for Processing and Integration of Ceramics

This paper describes a sintering technique for ceramics and ceramic‐based composites, using water as a transient solvent to effect densification (i.e. sintering) at temperatures between room temperature and 200 °C. To emphasize the incredible reduction in sintering temperature relative to conventional thermal sintering this new approach is named the “Cold Sintering Process” (CSP). Basically CSP uses a transient aqueous environment to effect densification by a mediated dissolution–precipitation process. CSP of NaCl, alkali molybdates and V₂O₅ with small concentrations of water are described in detail, but the process is extended and demonstrated for a diverse range of chemistries (oxides, carbonates, bromides, fluorides, chlorides and phosphates), multiple crystal structures, and multimaterial applications. Furthermore, the properties of selected CSP samples are demonstrated to be essentially equivalent as samples made by conventional thermal sintering.     

Nickel‐Catalyzed Esterification of Aliphatic Amides

Recent studies have demonstrated that amides can be used in nickel‐catalyzed reactions that lead to cleavage of the amide C?N bond, with formation of a C?C or C?heteroatom bond. However, the general scope of these methodologies has been restricted to amides where the carbonyl is directly attached to an arene or heteroarene. We now report the nickel‐catalyzed esterification of amides derived from aliphatic carboxylic acids. The transformation requires only a slight excess of the alcohol nucleophile and is tolerant of heterocycles, substrates with epimerizable stereocenters, and sterically congested coupling partners. Moreover, a series of amide competition experiments establish selectivity principles that will aid future synthetic design. These studies overcome a critical limitation of current Ni‐catalyzed amide couplings and are expected to further stimulate the use of amides as synthetic building blocks in C?N bond cleavage processes.     

Measurements of the complete solvation response in ionic liquids

Dynamic Stokes shift measurements of the solvatochromic probe trans-4-dimethylamino-4'-cyanostilbene were used to measure the solvation response of five imidazolium and one pyrrolidinium ionic liquid at 25 degrees C. The Kerr-gated emission and time-correlated single-photon-counting techniques were used to measure spectral dynamics occurring over the time ranges of 100 fs-200 ps and 50 ps-5 ns, respectively, and a combination of data sets from these two techniques enabled observation of the complete solvation response. Observed response functions were found to be biphasic, consisting of a sub-picosecond component of modest (10-20%) amplitude and a dominant slower component relaxing over times of a few picoseconds to several nanoseconds. The faster component could be correlated to inertial characteristics of the constituent ions, and the slower component to solvent viscosity. Dielectric continuum calculations of the sort previously used to predict solvation dynamics in dipolar liquids were shown to work poorly for predicting the response in these ionic liquids.     

Investigation,by single photon ionisation (SPI)–time-of-flight mass spectrometry (TOFMS), of the effect of different cigarette-lighting devices on the chemical composition of the first cigarette puff

Soft single-photon ionisation (SPI)–time-of-flight mass spectrometry (TOFMS) has been used to investigate the effect of different cigarette-lighting devices on the chemical composition of the mainstream smoke from the first cigarette puff. Lighting devices examined were a Borgwaldt electric lighter, a propane/butane gas lighter, a match, a candle, and the burning zone of another cigarette. To eliminate the effects of the different masses of tobacco burnt by use of the different lighting methods a normalisation procedure was performed which enabled investigation of changes in the chemical patterns of the resulting smoke. When another cigarette was used as the lighting device, elevated levels of ammonia and other nitrogen-containing substances were observed. These are high in the sidestream smoke of the cigarette used for lighting and would be drawn into the mainstream smoke of the cigarette being lit. In contrast, smoke from the cigarette lit by the electric lighter contained slightly higher normalised amounts of isoprene. Lighting the cigarette by use of a candle resulted in larger amounts of substances, e.g. benzene, which most probably originated from thermal decomposition of wax. The composition of the first puff of smoke obtained by use of the three lighting methods with open flames (gas lighter, match, and candle) was usually similar whereas the composition of the smoke produced by use of the electric lighter and the cigarette as the lighter were more unique. The chemical patterns generated by the different lighting devices could, however, be separated by principal-component analyses. Two additional test series were also studied. In the first the cigarette was lit with an electric lighter, then extinguished, the ash was cut off, and the cigarette was re-lit. In the second the cigarette was heated in an oven to 80 °C for 5 min before being lit. These treatments did not result in changes in the chemical composition compared with cigarettes lit in the ordinary way. Figure Time-of-flight mass spectrometry (TOFMS) has been used to investigate the effect of different cigarette-lighting devices on the chemical composition of the mainstream smoke from the first cigarette puff     

Solvent-extraction and Langmuir-adsorption-based transport in chemically functionalized nanopore membranes

We have investigated the transport properties of nanopore alumina membranes that were rendered hydrophobic by functionalization with octadecyltrimethoxysilane (ODS). The pores in these ODS-modified membranes are so hydrophobic that they are not wetted by water. Nevertheless, nonionic molecules can be transported from an aqueous feed solution on one side of the membrane, through the dry nanopores, and into an aqueous receiver solution on the other side. The transport mechanism involves Langmuir-type adsorption of the permeating molecule onto the ODS layers lining the pore walls, followed by solid-state diffusion along these ODS layers; we have measured the diffusion coefficients associated with this transport process. We have also investigated the transport properties of membranes prepared by filling the ODS-modified pores with the water-immiscible (hydrophobic) liquid mineral oil. In this case the transport mechanism involves solvent extraction of the permeating molecule into the mineral oil subphase confined with the pores, followed by solution-based diffusion through this liquid subphase. Because of this different transport mechanism, the supported-liquid membranes show substantially better transport selectivity than the ODS-modified membranes that contain no liquid subphase.     

Atomic force microscopy study of early morphological changes during apoptosis

Apoptosis is defined by a distinct set of morphological changes observed during cell death including loss of focal adhesions, the formation of cell membrane buds or blebs, and a decrease in total cell volume. Recent studies suggest that these dramatic morphological changes, particularly apoptotic volume decrease (AVD), are an early prerequisite to apoptosis and precede key biochemical time-points. Here we use atomic force microscopy to observe early stage AVD of KB cells undergoing staurosporine-induced apoptosis. After a 3-h exposure to 1 microM staurosporine, a 32% decrease in total cell height and a 50% loss of total cell volume is observed accompanied by only a 15% change in cell diameter. The observed AVD precedes key biochemical hallmarks of apoptosis such as loss of mitochondrial membrane potential, phosphatidyl serine translocation, nuclear fragmentation, and measurable caspase-3 activity. This suggests that morphological volume changes occur very early in the induction of apoptosis.