Chemoselective tetrahydropyranylation of alcohols and phenols using polystyrene supported aluminium chloride as a catalyst

A simple, efficient and highly chemoselective method for tetrahydropyranylation of alcohols and phenols has been developed by their reaction with 3,4-dihydro-2H-pyran at room temperature in the presence of a catalytic amount of polystyrene supported AlCl₃. The method is also highly selective for monoprotection of symmetrical diols.     

Dispersive solid phase extraction of lead(II) using a silica nanoparticle-based ionic liquid ferrofluid

We demonstrate the application of an ionic liquid-based ferrofluid to the dispersive solid phase extraction of lead(II) using PAN as the chelator. The ionic liquid contains silica nanoparticles with a magnetic core as the dispersion medium, and its use results in improved stability of the colloidal dispersion and a complete extraction of lead(II) within a few seconds. In addition, there is no need for centrifugation. Specifically, the effect of different variables on the extraction of lead(II) was studied using an experimental design. Lead(II) was quantified by AAS. Under optimized conditions, the calibration graph for lead(II) is linear in the range from 5 to 372 μg L⁻¹, the relative standard deviation is 1.34 % (for n = 7), the limit of detection is 1.66 μg L⁻¹, and the enrichment factor is 200. The maximum adsorption capacity of sorbent was calculated to be 10.7 mg g⁻¹, and adsorption follows a Langmuir isotherm.

A schematic view of D-SPE experimental set up. We demonstrate the application of an ionic liquid-based ferrofluid to the dispersive solid phase extraction of lead(II) using PAN as the chelator. The ionic liquid contains silica nanoparticles with a magnetic core as the dispersion medium

     

A novel sacrificial interlayer-based method for the preparation of silicon carbide membranes

A novel method is presented based on the use of sacrificial interlayers for the preparation of nanoporous silicon carbide membranes. It involves periodic and alternate coatings of polystyrene sacrificial interlayers and silicon carbide pre-ceramic layers on the top of slip-casted tubular silicon carbide supports. Membranes prepared by this technique exhibit single gas ideal separation factors of helium and hydrogen over argon in the ranges 176–465 and 101–258, respectively, with permeances that are typically two to three times higher than those of silicon carbide membranes prepared previously by the more conventional techniques. Mixed-gas experiments with the same membranes indicate separation factors as high as 117 for an equimolar H₂/CH₄ mixture. We speculate that the improved membrane characteristics are due to the sacrificial interlayers filling the pores in the underlying structure and preventing their blockage by the pre-ceramic polymer. The new method has good promise for application to the preparation of a variety of other inorganic microporous membranes.     

PCR-based Gene Synthesis,Molecular Cloning,High Level Expression,Purification, and Characterization of Novel Antimicrobial Peptide,Brevinin-2R,in <Emphasis Type="Italic">Escherichia Coli</Emphasis>

Brevinin-2R, a member of a new family of antimicrobial peptides isolated from the skin of Rana ridibunda, displays antimicrobial activity against bacteria and fungi. In this study, we have used an assembly PCR method for the fast and extremely accurate synthesis of the brevinin-2R gene. A total of six primers were assembled in a single step PCR, and the assembly was then amplified by PCR to produce the final gene. The synthetic gene was cloned into the pET32a (+) vector to allow the expression of brevinin-2R as a Trx fusion protein in Escherichia coli. The results indicated that the expression level of the fusion protein could reach up to 25% of the total cell proteins. The expression products could be easily purified by Ni-NTA chromatography and released from the fusion protein by factor Xa protease. The peptide displayed antimicrobial activity similar to that of the purified brevinin that was reported earlier. This method allows the fast synthesis of a gene that optimized the overexpression in the E. coli system and production of sufficiently large amounts of peptide for functional and structural characterizations.     

Development of a Henry’s constant correlation and solubility measurements of n-pentane,i-pentane,cyclopentane, n-hexane,and toluene in water

In this communication, we report new experimental data on n-pentane, i-pentane, cyclopentane, n-hexane, and toluene solubility in water at low temperature (below 298.15 K) and atmospheric pressure conditions. The new experimental data together with those reported in the literature have been used in developing a new equation for Henry’s constants of normal alkanes (methane to decane), BETEX compounds, and acid gases in aqueous phase over a wide range of temperature (typically from 273.15 K to 373.15 K). The new equation is based on a thermodynamic model, which uses the Peng–Robinson equation of state combined with the classical quadratic mixing rules for modelling non-aqueous phases, while the NRTL model is used to calculate the water activity.The predictions of the developed thermodynamic model are compared to the experimental data and the results of a thermodynamic approach, which uses the Valderrama modification of the Patel–Teja equation of state and non-density dependent mixing rules for modelling all fluid phases. Good agreement is observed between the experimental data and the model predictions.     

Fully printed flexible audio system on the basis of low‐voltage polymeric organic field effect transistors with three layer dielectric

Fully mass printed, flexible and truly polymeric organic field effect transistors consisting of a three layer dielectric made of CYTOP (low‐k), PVA (intermediate) and P(VDF‐TrFE‐CTFE)(high‐k) are introduced. Gravure‐, flexo‐and screen printing were selected as highly productive manufacturing technologies. These OFETs work at strongly reduced voltages and show high field effect mobility (µ = 0.2 cm²/Vs) and remarkable good bias stress stability at very high current density (50 µA/mm). Fully printed OFETs are used for the realization of ring oscillators working in the kHz regime at reduced supply voltage (10 V). In combination with printed fully polymeric piezoelectric loudspeakers, this work shows for the first time fully printed flexible audio systems. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 1409–1415     

Photoinduced dynamics of a cyanine dye: parallel pathways of non-radiative deactivation involving multiple excited-state twisted transients

Cyanine dyes are broadly used for fluorescence imaging and other photonic applications. 3,3′-Diethylthiacyanine (THIA) is a cyanine dye composed of two identical aromatic heterocyclic moieties linked with a single methine, –CH. The torsional degrees of freedom around the methine bonds provide routes for non-radiative decay, responsible for the inherently low fluorescence quantum yields. Using transient absorption spectroscopy, we determined that upon photoexcitation, the excited state relaxes along two parallel pathways producing three excited-state transients that undergo internal conversion to the ground state. The media viscosity impedes the molecular modes of ring rotation and preferentially affects one of the pathways of non-radiative decay, exerting a dominant effect on the emission properties of THIA. Concurrently, the polarity affects the energy of the transients involved in the decay pathways and further modulates the kinetics of non-radiative deactivation.     

Volumetric and viscosity studies of interactions between sodium phosphate salts and poly(propylene glycol) 400 in aqueous solutions at different temperatures

Density and sound velocity at the 288.15–313.15 K and viscosity at the 298.15–313.15 K temperature range at 5 K intervals for polypropylene glycol (PPG) in aqueous solutions of sodium di-hydrogen phosphate, di-sodium hydrogen phosphate and tri-sodium phosphate with salt mass fractions 0.00, 0.010 and 0.020 are reported at atmospheric pressure. From the experimental density and sound velocity data, the apparent specific volume, excess specific volume, isentropic compressibility and isentropic compressibility deviation values have been determined. The infinite dilution apparent specific volume and isentropic compressibility values of PPG have been obtained and from which the infinite dilution apparent specific volumes of transfer of PPG from water to aqueous sodium phosphate solutions have been obtained for the investigated salt concentrations and temperatures. The excess specific volume, isentropic compressibility and viscosity deviation are negative and decrease in magnitude as temperature, concentration of sodium phosphate and charge on the anion of electrolyte increases.