Boiling heat transfer characteristics of nanofluids in a flat heat pipe evaporator with micro-grooved heating surface

An experimental study was performed to understand the nucleate boiling heat transfer of water–CuO nanoparticles suspension (nanofluids) at different operating pressures and different nanoparticle mass concentrations. The experimental apparatus is a miniature flat heat pipe (MFHP) with micro-grooved heat transfer surface of its evaporator. The experimental results indicate that the operating pressure has great influence on the nucleate boiling characteristics in the MFHP evaporator. The heat transfer coefficient and the critical heat flux (CHF) of nanofluids increase greatly with decreasing pressure as compared with those of water. The heat transfer coefficient and the CHF of nanofluids can increase about 25% and 50%, respectively, at atmospheric pressure whereas about 100% and 150%, respectively, at the pressure of 7.4 kPa. Nanoparticle mass concentration also has significant influence on the boiling heat transfer and the CHF of nanofluids. The heat transfer coefficient and the CHF increase slowly with the increase of the nanoparticle mass concentration at low concentration conditions. However, when the nanoparticle mass concentration is over 1.0 wt%, the CHF enhancement is close to a constant number and the heat transfer coefficient deteriorates. There exists an optimum mass concentration for nanofluids which corresponds to the maximum heat transfer enhancement and this optimum mass concentration is 1.0 wt% at all test pressures. The experiment confirmed that the boiling heat transfer characteristics of the MFHP evaporator can evidently be strengthened by using water/CuO nanofluids.     

非晶Nb-Ni合金晶化过程中紫外光电子能谱研究

本文利用紫外光电子能谱和X射线衍射测量研究了非晶Nb_100-xNi_x(x=65,59.8,56.4)合金晶化过程中价带谱的变化。对NbNi₃价带谱中出现的双峰进行了讨论。 关键词：     

Pointwise Stabilization for a Chain of Coupled Vibrating Strings

For the system representing a chain of coupled vibrating strings,we show that the associated semigroup satisfies the assumptionof spectrum-determined growth, and hence obtain conditions forenergy to decay strongly or exponentially. We examine in detailthe three-string case, and our results include those obtainedby others for the two-string case. Permanent address: Beijing Institute of Information and Control,Beijing, China.     

低场脉冲核磁共振测定二醋酸纤维素丝束中油剂

研究了采用低场脉冲核磁共振(NMR)测定二醋酸纤维素丝束油剂的新方法，给出NMR法测定二醋酸纤维素丝束油荆含量的标准曲线。同时对NMR法测量二醋酸纤维素丝束油荆不确定度进行了评估。结果表明，NMR法具有分析速度快、无污染、无损伤和准确度高的优点，适合于二醋酸纤维素丝束油荆的分析。     

还原温度对超细K－Co－Mo催化剂合成低碳醇性能的影响

 用溶胶－凝胶法合成了K－Co－Mo催化剂．样品经不同温度还原后，用于低碳醇的合成．XRD和HRTEM结果表明，样品是超细粒子，粒子尺寸为2～5nm．考察了催化剂的还原温度和反应条件对催化剂性能的影响．实验结果表明，还原温度对催化剂的活性有较大的影响，最佳还原温度为500℃．最佳反应温度范围为310～330℃．升高压力和空速可以提高醇的收率和选择性．在空速14400h－1，压力6．0MPa和温度310℃的条件下，醇的选择性为55．8％，收率为520．0g／（kg·h），MeOH／C2＋OH为0．27．催化剂稳定性良好，在200h的寿命实验中，活性基本不变．与文献中催化剂相比，超细K－Co－Mo催化剂对合成醇具有较高的活性和选择性，尤其是对C2＋OH的合成明显高于其他合成醇催化剂体系．     

STUDIES ON ION IMPLANTATION AND ELECTRICAL PROPERTIES OF POLYACETYLENE FILMS

The effects of ion implantation on ployacetylene films PA have been studied with Ar~+, Fe~+, C1~+, I~+, Na~+ and K~+ ions in the energy range of 15—30 keV. The changes of PA films in the electrical conductivity, due to chemical doping and ion implantation in relation to their structure and depth profiles of impurities, were measured through infrared (ATR/FTIK), Rutherford backscattering spectrometry (RBS) and the four probe technique. In all cases, ion implantation of active ions exhibits the same effects as chemical doping. The formation of p-n junction is observed at the interface of implanted region and chemical doped PA substrate. The mechanism of interaction process between ion beam and polymer is also discussed.     

聚丁二烯~(13)C-NMR谱图中一个新的共振吸收峰(T_4)

<正> 最近解析锂系和铁系含乙烯基聚丁二烯的~(13)C-NMR谱图,发现并确认了一个新的共振吸收峰。即聚丁二烯反式1,4-序列的第四峰,简称T_4峰。 Furukawa等对钼系和章哲彦等对铁系等二元聚顺-1,4-1,2-丁二烯的研究都指出在聚丁二烯的~(13)C-NMR谱图上,有四个谱峰属于顺1,4-序列。本文给出其化学位     

Preparation of Polyclonal Antibodies Against Testis-specific Protease 50 and Characterization of Antibody Specificity

Introduction TheTSP50genehasbeenidentifiedasoneofthe testis specificoncogenes,whichisexpressedathigh levelsinapproximately92%ofhumanbreastcancer samples,makingitanattractivemolecularmarkerand apotentialtargetfordiagnosisandtherapy[1].Itisho mologoustomany…     

克拉霉素漂浮-生物粘附微囊的制备及性能研究

选用乳化-溶剂挥发法制备乙基纤维素载药微球(EMs), 并通过内部凝胶化法进行包衣制得海藻酸钠-乙基纤维素载药微囊(AEMs), 最后通过离子交联法进一步包衣制得壳聚糖-海藻酸钠-乙基纤维素载药微囊(CAEMs). 研究克拉霉素漂浮\|生物粘附微囊的制备工艺, 并考察微囊的体外漂浮性能、 粘附性能及体内滞留性能. 结果表明, CAEMs球形度较好, 药物包封率为72.3%~78.2%, 载药量为7.1%~12.7%. 在pH=5的醋酸缓冲液中, 6 h时的累积释放率为56.6%~70.6%, 漂浮率大于70%, 4 h时的体内滞留率为60.5%. CAEMs有望通过延长药物胃内滞留时间, 在临床用于根除幽门螺旋杆菌, 从而降低消化道溃疡的复发率.     

助剂Cu对Ni/γ-Al2O3催化剂低温还原性能影响

制备了一系列铜质量分数不同的CuNi/γ-Al2O3催化剂，进行了TPR和XRD表征并测定了该系列催化剂对苯加氢制环己烷的催化活性。结果表明，助剂Cu的负载量对低温（160 ℃）还原后催化剂的催化活性影响很大，在铜镍原子摩尔比为1∶1时，催化剂具有较高的催化活性和稳定性；添加铜组分可促进镍在载体表面分散，使负载NiO的还原温度降低，催化活性提高。