Large-scale computer simulation of fully developed turbulent channel flow with heat transfer

Recently, with the advent of supercomputers, there has been considerable interest in the use of direct numerical simulation to obtain information about turbulent shear flow at low Reynolds number. This paper presents a pseudospectral technique to solve the full three-dimensional time-dependent Navier-Stokes and advection-diffusion equations without the use of subgrid-scale modelling. The technique has not been previously used for fully developed turbulent channel flow simulation and is based on methods applied in other contexts. The emphasis of this paper is to provide a reasonably detailed account of how the simulation is done rather than to present new calculations of turbulence. The details of an algorithm for turbulent channel flow simulation and the grid and time step sizes needed to integrate through transient behaviour to steady state turbulence have not been published before and are presented here. Results from a Cray-2 simulation of fully developed turbulent flow in a channel with heat transfer are presented along with a critical comparison between experiment and computation. The first- and second-order moments agree well with experimental measurements; the agreement is poor for higher-order moments such as the skewness and flatness near the walls of the channel. Detailed information given about the effects of spatial grid resolution on a computed results is important for estimating the size of the computation required to study various aspects of a turbulent flow.     

1.2 Anorganische analyse

Ohne Zusammenfassung     

Improvement of least-squares finite difference method on simulating slider air bearings in head disk systems

Least-squares finite difference (LSFD) method, one of mesh-free methods, is used to solve slider air bearings problem through discritizing the generalized Reynolds equation into nonlinear systems of algebraic equations. Two approximation schemes for the linearization of these equations are presented and compared. And, some new techniques to search supporting points for the reference node in the mesh-free method were proposed and explored. Therefore, these improvements eliminate some potential limitation of the LSFD method previously published and further facilitate its employment in complex slider models. Advanced step slider as an example of negative pressure sliders is simulated and verified using the improved LSFD mesh-free method in head disk systems.     

Ferroelectric polarization switching in nylon-11

Cold-drawn Nylon-11 films, which were prepared by stretching the melt-quenched films to a draw ratio of 2.8: 1 at room temperature, were found to exhibit an electric displacement versus electric field hysteresis loop. The results confirmed that the Nylon-11 film exhibited ferroelectric behavior at or below room temperature. The coercive fields were 65, 98, 125, 160, and 215 MV/m at 20, 0, ?20, ?40, and ?60°C and the remanent polarization at ?20°C (where there was considerably less dc conduction) was 56 mC/m². Switching of the polarization was almost completed within 20 ms.     

X-ray scattering studies of the structure of aqueous hydroxy-propylcellulose solutions

X-ray diffraction studies have been undertaken on aqueous solutions of hydroxy propylcellulose (HPC) over a wide range of the scattering vector Q. The experiments revealed only modest differences in local structure on a distance scale ca. 5–300 Å despite the fact that they covered concentrations generally interpreted as ranging from the isotropic (35.1 wt %) to the anisotropic liquid crystalline (LC) phase (53.5 wt %). Several models were used to interpret the small-angle scattering data, and each gave similar structural parameters and extrapolated intensities ( Q → 0) for both solutions. Peaks were observed with d-spacings ca. 12–17 Å in both materials. Wide-angle x-ray scattering (WAXS) showed slightly increased local order over a size range ca. 5–20 Å for the anisotropic solution, and this is consistent with a greater intensity of the 13 Å peak in this material. It is difficult to reconcile these findings with an interpretation of the LC state involving major differences with the isotropic phase and a high degree of orientational order extending over long length scales.     

Direct electrosynthesis of halo and mixed-halo complexes of palladium(II and IV) by the dissolution of a sacrificial palladium anode in aqueous medium

A rapid single-step method for the electrosynthesis of chloro and bromo complexes of palladium(II and IV), viz. M₂[PdX₄] and M₂[PdX₆], by the dissolution of a palladium anode in chloride or bromide containing media is described. Electrolysis of dilute HX solution in the presence of pyridine, 2,2′-bipyridyl or 1,10-phenanthroline gives rise to non-electrolytes, e.g. trans-[PdX₂(py)₂], [PdX₂(bipy)] and [PdX₂(phen)]. Anodic oxidation of palladium in HX medium in the presence of acetonitrile and benzonitrile also gives the non-electrolytes trans-[PdX₂(CH₃CH₂NH₂)₂] and trans-[PdX₂(C₆H₅CH₂NH₂)₂], respectively.