Gas adsorption in mcm-41 porous silicas dynamic measurements using sans

The European Physical Journal E - The isothermal gas adsorption of two hexane isomers (n-hexane and cyclohexane) in the mesopores of MCM-41 silica have been investigated by small angle neutron...     

Micromachining of circular ring microstructure by femtosecond laser pulses

In this paper, integration of interference phenomenon into femtosecond laser micromachining was reported as the femtosecond laser pulses were reshaped spatially to perform ablation. The generation of circular interference pattern was demonstrated by overlapping infrared femtosecond laser pulses. The interference pattern was subsequently focused on a copper substrate to ablate microstructures of concentric circular rings. The present technique is expected to open up new applications in the areas of rapid fabrication of micro-Fresnel lenses, hybrid microlenses and lens arrays.     

Investigation of hypersonic nozzle flow uniformity using NO fluorescence

Planar laser-induced fluorescence visualisation is used to investigate nonuniformities in the flow of a hypersonic conical nozzle. Possible causes for the nonuniformity are outlined and investigated, and the problem is shown to be due to a small step at the nozzle throat. Entrainment of cold boundary layer gas is postulated as the cause of the signal nonuniformity. PACS 47.80.Jk, 47.40.Ki, 47.60.+i     

Existence of the uniformly minimum risk equivariant estimators of parameters in a class of normal linear models

In this paper, we study the existence of the uniformly minimum risk equivariant (UMRE) estimators of parameters in a class of normal linear models, which include the normal variance components model, the growth curve model, the extended growth curve model, and the seemingly unrelated regression equations model, and so on. The necessary and sufficient conditions are given for the existence of UMRE estimators of the estimable linear functions of regression coefficients, the covariance matrixV and (trV)^α, where α > 0 is known, in the models under an affine group of transformations for quadratic losses and matrix losses, respectively. Under the (extended) growth curve model and the seemingly unrelated regression equations model, the conclusions given in literature for estimating regression coefficients can be derived by applying the general results in this paper, and the sufficient conditions for non-existence of UMRE estimators ofV and tr(V) are expanded to be necessary and sufficient conditions. In addition, the necessary and sufficient conditions that there exist UMRE estimators of parameters in the variance components model are obtained for the first time.     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

Phase separation in blends of two homopolymers and a diblock copolymer during film casting

Demixing during film casting of blends of polystyrene, polymethylmethacrylate, and a symmetric diblock copolymer of styrene and methylmethacrylate is discussed. The concentration fluctuations in the homogeneous solutions were calculated in mean field approximation. The structures in the homogeneous and demixed solutions and in the dry films were measured by small-angle x-ray scattering, and the morphologies of the dry films were characterized by transmission electron microscopy. The structure of the dry blends is evidently already pre-formed in solution.     

Correlation of modified crack tip opening distance with heat input to the heat affected zone of high-strength low-alloy steels

Investigated is the dependency of the crack tip opening displacement (CTOD) on the local microstructure of the heat affected zone in high-strength low-alloy (HSLA) microalloyed steel. Since the initiation of the crack tip location could not be controlled in fatigue, any possible correlation between heat iput in welding and fracture toughness could be smeared. Modified CTOD data are defined; they show that the fracture resistance of the weld joint decreased as the heat input increased.     

Fréchet空间上的一些等距逼近问题

本文主要讨论Ｆｒéｃｈｅｔ空间上ε－等距线性算子的等距逼近问题，证明了任意有限维Ｆｒéｃｈｅｔ空间之间的等距逼近问题都是肯定的；无穷维Ｆｒéｃｈｅｔ空间（ｓ）空间上的等距逼近问题也是肯定的．     

T1Effects in Sequential Dynamic Susceptibility Contrast Experiments

Residual effects of an initial bolus of gadolinium contrast agent have been previously demonstrated in sequential dynamic susceptibility contrast MR experiments. While these residual effects quickly reach a saturation steady state, their etiology is uncertain, and they can lead to spurious estimates of hemodynamic parameters in activation experiments. The possible influence ofT₁effects is now investigated with experiments in whichT₁weighting is varied as well as with serial regionalT₁measurements. Little evidence for significant residualT₁effects is found, suggesting instead that susceptibility effects underlie these observations. An initial saturation dose of contrast agent minimizes this effect.