A comparison of a theoretical model for quasi-statically and dynamically induced environmental vibration from trains with measurements

This paper presents comparisons between a theoretical ground vibration model and measured data at three sites. The model, which is briefly outlined here, encompasses both the quasi-static and dynamic mechanisms of excitation. The vertical dynamics of a number of vehicles travelling at a constant speed on an infinite track are coupled to a semi-analytical model for a three-dimensional layered ground. This model is also used to demonstrate the roles of the two components of vibration at different frequencies and for train speeds below and above the lowest ground wave speed. It is found that, in most practical cases, the dynamic component gives rise to the higher level of vibration.     

Active control and a simple estimation method for the onset of Rayleigh-Bénard convection in temperature-dependent-viscosity liquids

Active feedback control for the onset of Rayleigh-Bénard Convection in temperature-dependent-viscosity liquids is investigated. In this paper, three major problems are addressed: (1) The results of Tang-Bau control are improved by considering the effects of temperature-dependent viscosity; (2) A more efficient two-plate control strategy is presented. A phenomenon of coalescence of the unstable modes is observed as the controller gain is large enough; (3) A simple way to estimate the critical Rayleigh number under the effects of temperature-dependent viscosity is described. Numerical results show that the effects of temperature-dependent viscosity on the critical Rayleigh number should be taken into account in some cases and the onset of Rayleigh-Bénard convection can be effectively delayed or advanced by the active feedback control strategies studied here.     

Imprinting by hot embossing in polymer substrates using a template of silica glass surface-structured by the ablation of LIBWE method

Laser-induced backside wet etching (LIBWE) of silica glass plates was performed to fabricate an imprinting template for hot embossing in polymer substrates such as polystyrene and silicone resin. Well-defined inverse surface-micropatterns of gratings and grid arrays on the substrates were produced by the hot embossing using a surface-structured silica glass as the template. These results indicate that the LIBWE method allows us to generate robust glass molding tools that exhibit the inverse shapes of the intended microstructures. PACS 52.38.Mf; 68.47.Mn; 81.05.Kf; 81.05.Lg; 83.50.Uv     

Miniature InGaAsP/InP phase modulator for integrated opto-electronics

Miniature, etching ridge InGaAsP/InP Phase Modulator with highly efficient phase shifting efficiency of 60°/V.mm and 43°/V.mm for TE and TM modes, respectively, and 3 dB bandwidth of 650 MHz at 1.52 μm are reported. It is well suited for integrated opto-electronics. Some functions depending on bandwidth of the devices are discussed.     

Effect of transverse object position on the reconstructed image of an aperture-limited in-line hologram

It is experimentally demonstrated that the image resolution from an in-line Fraunhofer hologram degrades appreciably when the centre of the diffraction pattern from a 5-bar resolution target is located asymmetrically in the hologram aperture. This effect is confirmed and analysed using calculated and experimentally measured images from holograms of a one-dimensional wire. Increasing asymmetry results in an increasing error in the measured linewidth, and a reduction of image resolution. A simple model based on average fringe contrast is used to predict this decrease in resolution with transverse object position.     

Siderophore Transport in Mycobacteria Analyzed by Mössbauer Spectroscopy: Possible Routes to Novel Antibiotics against These Organisms?

Iron uptake of the ⁵⁷Fe-siderophores ferricrocin, rhizoferrin and citrate in M. smegmatis was analyzed by in situ Mössbauer spectroscopy. Siderophore dependent uptake and metabolic utilization patterns of ⁵⁷Fe were found. Rhizoferrin is accumulated in the organism and, therefore, represents a suitable candidate for the synthesis of novel siderophore-antibiotics conjugates.     

Far IR harmonic oscillators in triglycine sulphate at 7 K

Transmission spectra of very thick TGS single crystals (e.g. thickness 8 mm) observed in the Far IR at 7 K do not need a high spectral resolution and nevertheless give evidence of Lorentz oscillators with damping coefficients as small as those considered for water vapour at a pressure of 0.2 atmospheres.     

Preparation of Papers

We motivate the study of a vector variational inequality by a practical flow equilibrium problem on a network, namely a generalization of the well-known Wardrop equilibrium principle. Both weak and strong forms of the vector variational inequality are discussed and their relationships to a vector optimization problem are established under various convexity assumptions.     

Mössbauer study on LiFePO4 cathode material for lithium ion batteries

Crystalline LiFePO₄ has been synthesized using solid-state, spray pyrolysis, and wet chemical methods. The crystal parameters were obtained from Rietveld’s refinement methods of the X-ray diffraction patterns. A detailed investigation of the Fe valency carried out using Mössbauer spectroscopy at room temperature indicates that Fe is predominantly present in its bivalent state.     

Improvement of least-squares finite difference method on simulating slider air bearings in head disk systems

Least-squares finite difference (LSFD) method, one of mesh-free methods, is used to solve slider air bearings problem through discritizing the generalized Reynolds equation into nonlinear systems of algebraic equations. Two approximation schemes for the linearization of these equations are presented and compared. And, some new techniques to search supporting points for the reference node in the mesh-free method were proposed and explored. Therefore, these improvements eliminate some potential limitation of the LSFD method previously published and further facilitate its employment in complex slider models. Advanced step slider as an example of negative pressure sliders is simulated and verified using the improved LSFD mesh-free method in head disk systems.