Reaction of mercury(II) and xylenol orange-I Effect of the buffering media

The influence of the buffering medium on the reaction of Hg(II) with Xylenol Orange has been studied. Amine-type compounds are complexed by Hg(II)/Xylenol Orange with a sharp hyperchromic effect on the reagent itself, at 590 nm, but complex formation of Hg(II)/Xylenol Orange in non-amine-type buffer, such as citric acid-phosphate, gives a hypochromic effect on Xylenol Orange at 580 nm. Hg(II) is determined at pH 7.5 in two ranges of concentration, 2-9 ppm in citrate buffer, measured at 580 nm ( = 2.50 x 10(4)), and 6-11 ppm in hexamine buffer, at 590 nm ( = 4.18 x 10(4)).     

Anionic polymerization of vinyl chloride

Anionic polymerization of vinyl chloride has been studied. Of the organometallic compounds tested as initiators, only butyllithium was found to initiate polymerization. Polymerization in bulk at 0°C and with tert-butyllithium as initiator gave poly(vinyl chloride) in a yield of 38% with M _n = 55,000. Tacticity of the anionic PVC was similar to that of conventional PVC prepared at similar temperatures. Anionic PVC was found to be less branched and more heat-stable than the conventional polymer.     

Vernetzung und Abbau von Polyäthylenterephthalat durch Elektronenbestrahlung

Zusammenfassung PÄT-Folien wurden in Luft, Stickstoff und Vakuum bei 20 °C mit 1 MeV-Elektronen bestrahlt. Untersucht wurden Löslichkeit und Viskosität von Proben, die unmittelbar nach der Bestrahlung gelöst wurden.In allen untersuchten Fällen trat bei hohen Bestrahlungsdosen ein unlöslicher, d. h. vernetzter Anteil auf, dessen Ausbildung jedoch durch in den Proben enthaltene Feuchtigkeit verzögert werden kann. Bei niedrigen Bestrahlungsdosen bewirkt Feuchtigkeit einen Abbau des Polymeren, wie durch Viskositätsmessungen gezeigt wird.Aus den Gel-Messungen wurde derp ₀/q ₀-Wert für Bestrahlung in Luft, Stickstoff und Vakuum zu 1,05 bestimmt.Die Änderung des Gel-Anteils bei Lagerung der Proben zwischen Bestrahlung und Lösung wird diskutiert.

---

Summary Polyethyleneterephthalate samples were irradiated in air, nitrogen and vacuum at 20 °C with 1 MeV electrons. The solubility of the samples and the viscosity of the solutions were studied immediately after irradiation. At high doses an insoluble crosslinked part was always observed. Crosslinking was delayed by moisture in the samples. At low irradiation doses moisture causes chain scission as shown by viscosity measurements. The ratiop ₀/q ₀ of degradation to crosslinking in the case of irradiation in air, nitrogen and vacuum was found by gel measurements to be 1.05. The insoluble gel-part changes with increasing storage time of the samples between irradiation and solution.

---

---

Herrn Diplom-PhysikerH. Fischer sei an dieser Stelle für wertvolle Anregungen und Diskussionen besonders gedankt.     

Viskoelastische Eigenschaften von Polyisobutylenen in verdünnten Lösungen

Zusammenfassung Die Speicher- und VerlustmodulnG undG verdünnter Lösungen (2–4%) dreier Isobutylenpolymerisate mit den Molekulargewichten 0,63, 1,29 und 11×10⁵ wurden in der Apparatur vonBirnboim undFerry über einen Frequenzbereich von 0,4–400 Hz und einen Temperaturbereich von –17,5 bis 25,0° bestimmt. Für die scharf fraktionierten Polymerisate von niederem Molekulargewicht ergab die Frequenzabhängigkeit der Moduln eine ausgezeichnete Übereinstimmung mit der Theorie vonZimm. Die aus den experimentell erhaltenen Kurven ermittelten Molekulargewichte und größten Relaxationszeiten waren von der erwarteten Größenordnung. Für das Polymerisat mit höherem Molekulargewicht entsprach die Frequenzabhängigkeit vonG undG – _s jedoch der Theorie vonRouse. Der Einfluß der hydrodynamischen Wechselwirkung in der Bewegung der Knäuelsegmente, in welchem der Unterschied zwischen den beiden Theorien besteht, erscheint als von der Größe des Molekulargewichts abhängig.

---

Summary The storage and loss moduliG andG of dilute (2–4%) solutions of three polyisobutylenes of molecular weight 0.63, 1.29, and 11×10⁵ were determined in the apparatus ofBirnboim andFerry over a frequency range of 0.4 to 400 cps, and a temperature range of –17.0 to 25.0°. The sharply fractionated polymers of low molecular weight showed a frequency dependence in excellent agreement with the theory ofZimm. The experimentally determined molecular weights and terminal relaxation times were of the expected order of magnitude. The frequency dependence of the polymer of highest molecular weight, however, conformed more closely to the theory ofRouse. The influence of the hydrodynamic interaction on the motion of the coil segments, which constitutes the difference in the two theories, appears to depend on the magnitude of the molecular weight.

     

Adsorption characteristics of a Hungarian natural mordenite and its acid treated derivatives

A mordenite-containing rock from the Tokaj-mountains was investigated. The effect of the treatment with hydrochloric acid solutions of various molarity was established. From gas adsorption measurements, scanning electron microscopic investigations and measurements with a mercury porosimeter conclusions were drawn on the changes caused by acid treatment. Slight changes in the texture were found, but no damage in the crystal structure could be observed.

---

- . . , - , , . - .

     

Spektrophotometrische Bestimmung von L-Askorbinsäure mit 2,2',5,5'-Tetra-(4-nitrophenyl)-3,3'-(3,3'-dimethoxy-4, 4'-biphenyl)-ditetrazoliumchlorid (TNBT)

Zusammenfassung Die Optimalbedingungen für die spektrophotometrische Bestimmung der L-Askorbinsäure mit TNBT wurden ermittelt. Die L-As-korbinsäure wurde in Anwesenheit eines 100fachen Überschusses folgender Stoffe bestimmt: Glukose, Fruktose, Saccharose, Wein-, Zitronen-, Oxal-, Äpfel- und Bernsteinsäure. 0,5g/ml ist die minimale Askorbinsäurekonzentration, die sich bestimmen läßt. Die rel. Standardabweichung beträgt 2,1%, der rel. Fehler 0,875%.

---

Spectrophotometric assay of L. ascorbic acid with 2,2,5,5-tetra-(4-nitro-phenyl)-3, 3-(3,3-dimethoxy-4,4-biphenyl)-ditetrazolium chloride (TNBT)

Summary The optimal conditions for spectrophotometric assay of L-ascorbic acid with TNBT were determined. L-ascorbic acid was assayed in the presence of a 100 fold excess of the following substances: glucose, fructose, sucrose, tartaric acid, citric acid, oxalic acid, malic acid and succinic acid. 0.5g/ml is the minimum concentration of ascorbic acid which can be assayed. The relative standard deviation is 2.1%, the relative error 0.875%.

     

Determination of the pH of binary mobile phases for reversed-phase liquid chromatography

The measurement of pH in chromatographic mobile phases has been a constant subject of discussion during many years. The pH of the mobile phase is an important parameter that determines the chromatographic retention of many analytes with acid-base properties. In many instances a proper pH measurement is needed to assure the accuracy of retention-pH relationships or the reproducibility of chromatographic procedures. Three different methods are common in pH measurement of mobile phases: measurement of pH in the aqueous buffer before addition of the organic modifier, measurement of pH in the mobile phase prepared by mixing aqueous buffer and organic modifier after pH calibration with standard solutions prepared in the same mobile phase solvent, and measurement of pH in the mobile phase prepared by mixing aqueous buffer and organic modifier after pH calibration with aqueous standard solutions. This review discusses the different pH measurement and calibration procedures in terms of the theoretical and operational definitions of the different pH scales that can be applied to water-organic solvent mixtures. The advantages and disadvantages of each procedure are also presented through chromatographic examples. Finally, practical recommendations to select the most appropriate pH measurement procedure for particular chromatographic problems are given.     

Synthesis and characterization of new di- and tri-nuclear cyano-bridged bis(dioximato)cobalt(III) complexes

Summary Several new neutral and cationic di- and tri-nuclear cyano-bridged bis(dioximato)cobalt(III) complexes have been synthesized and characterized (dioximato = dimethylglyoximato or diphenylglyoximato). These compounds are obtained through substitution of labile axial ligands by the nitrogen of the cyano-group in [Co(dioximato)₂(CN)₂]^– or [LCo(dioximato)₂(CN)] (L = H₂O, NH₃, or py). In the first case, the existence of only one band in the CN-stretching region of the i.r. spectrum at 2190–2200 cm^–1 is indicative of a trinuclear compound, while the presence of a second band at 2140 cm^–1 attributable to a terminal cyano-group indicates a dinuclear structure. In the presence of water, aquation of axial positions may take place at the same time as bridge formation, whereas the use of a non-aqueous solvent allows the preparation of complexes with pyridine or NH₃.     

Anwendung mikroanalytischer Methoden zur Lösung kunst- und kulturgeschichtlicher Probleme

Zusammenfassung Mit bekannten mikroanalytischen Arbeitsmethoden — Oberflächenreaktionen, Abstrichuntersuchungen mit dem Korundstäbchen, Schutzschichtreaktionen sowie dem Abdruckverfahren — lassen sich archaeometrische Probleme einer Lösung näherbringen. Die Art der Korrosion kupferhaltiger Oberflächen wurde diskutiert.

---

Application of microanalytical methods to the solution of artistic- and cultural historical problems

Summary Archeometrical problems are brought closer to a solution by means of known microanalytical procedures-surface reactions, surface scraping studies with the corundum rod, protective layer reactions as well as the imprint method. A discussion of the corrosion of copper-bearing surfaces is included.

---

---

Vortrag anläßlich der Tagung Chemische Analysen — Kunst- und Kulturwissenschaften im Reiß-Museum in Mannheim, 19.–21. September 1974.     

The surface activity of the lower homologues of n-alkylammonium chlorides in aqueous solutions. Effect of hydrophobic hydration

Summary The surface tensions of aqueous solutions ofn-alkylammonium chlorides (methyl to hexyl) have been measured at 25 °C. With methylammonium chloride the surface tension increased with concentration, whereas with ethylammonium chloride and higher homologues, the surface tension decreased with concentration. The results suggest that this transition is attributed to the effect of hydrophobic hydration. For propylammonium chloride and higher homologues, the relation between the surface tension lowering da and the concentrationC in the range of 0–10 dyne/cm, can be expressed by the equation; = AC + BC, whereA andB are constants. The surface tension coefficientB has been found to increase approximately twofold for each additional CH₂ group of alkyl chain.

---

Zusammenfassung Es wurden die Oberflächenspannungen wäßriger Lösungen vonn-Alkylammoniumchloriden (Methyl- bis Hexylammoniumchloride) bei 25 °C gemessen. Für Methylammoniumchlorid nimmt die Oberflächenspannung mit der Konzentration zu, aber bei allen höheren Homologen mit der Konzentration ab. Die Ergebnisse deuten darauf hin, daß dieser Übergang durch die hydrophobe Hydration bedingt wird. Für Propylammonium-chlorid und die höheren Homologen wird die Beziehung zwischen der Erniedrigung der Oberflächenspannung und der KonzentrationC in dem Bereich von 1 bis 10 dyn/cm durch die folgende Gleichung ausgedrückt: = AC + BC (A undB sind Konstanten). Es wurde gefunden, daß B für jede zusätzliche CH₂-Gruppe etwa um den Faktor 2 größer wird.