High mobility of dithiophene-tetrathiafulvalene single-crystal organic field effect transistors

Single-crystal field effect transistors of the organic semiconductor dithiophene-tetrathiafulvalene (DT-TTF) were prepared by drop casting. Long, thin crystals connected two microfabricated gold electrodes, and a silicon substrate was used as a back gate. The highest hole mobility observed was 1.4 cm2/Vs, which is the highest reported for an organic semiconductor not based on pentacene. A high ON/OFF ratio of at least 7 x 105 was obtained for this device.     

Determination of lithium in human serum by electrothermal atomic absorption spectrometry

An efficient method was developed for the determination of nanogram levels of lithium in biological samples. Serum samples from human subjects from southeastern Spain, treated or not treated with lithium carbonate, were analyzed by electrothermal atomic absorption spectrometry. The samples were previously treated with a matrix modifier consisting of 0.1% Triton X-100 and injected through a graphite tube with L'vov platform. The Li concentrations measured by the procedure described for the 3 certified reference samples used were not significantly different (p > 0.05) than certified levels. Sample recoveries and variability during several days, with coefficients of variation from 4.00 to 14.8%, demonstrated the reliability and accuracy of this technique. Mean Li concentration determined in the serum of individuals with psychiatric disorders treated with Li (n = 117, 5.077 +/- 1.795 microg Li/mL) was significantly higher (p < 0.001) than that in individuals not treated with Li (n = 24, 1.902 +/- 2.054 ng Li/mL).     

Molecular modeling (MM2 and PM3) and experimental (NMR and thermal analysis) studies on the inclusion complex of salbutamol and beta-cyclodextrin

The inclusion complex of salbutamol and beta-cyclodextrin (beta-CD) is studied by computational (MM2 and PM3) and experimental techniques. Molecular modeling calculations predict two different orientations of salbutamol in the beta-CD cavity in vacuo and in aqueous solution. In vacuo calculations show that the introduction of the aromatic ring of salbutamol is preferred to the introduction of the tert-butyl group into the beta-CD cavity. However, in aqueous solution both computational methods predict the introduction of the alkyl chain instead of the aromatic ring in the beta-CD cavity contrary to experimental results published previously. These quantitative predictions were experimentally confirmed here by studying the inclusion complex in solution by NMR. A 1:1 stoichiometry was found by (1)H NMR studies for this complex. A 2D ROESY (rotating-frame Overhauser enhancement spectroscopy) experiment shows that there are no cross-peaks between the aromatic protons of salbutamol and any of the protons of beta-CD. Cross-peaks for the protons of the tert-butyl group and protons inside the cavity of beta-CD demonstrate the full involvement of this group in the complexation process and confirm the orientation of the complex predicted by molecular modeling. The solid-state complex was prepared and its stoichiometry (beta-CD.C(13)H(21)NO(3).8H(2)O) and dissociation process studied by thermogravimetric analysis.     

Benzo[d]-1,2-oxaphospholes as precursors of stabilized C-centered radicals

[reaction: see text] Several benzo[d]-1,2-oxaphosphole 2-oxides were examined as potential precursors of stabilized C-centered radicals. The transient absorption spectra obtained after laser flash photolysis in the presence of di-tert-butyl peroxide showed the features of benzylic radicals with formation and decay kinetics not significantly influenced by the presence of oxygen. In the case of compounds with two possible diastereomeric forms, the C-H bond of the trans-isomers [corrected] is more reactive toward hydrogen abstraction.     

Density and Speed of Sound for Binary Mixtures of a Cyclic Ether with a Butanol Isomer

Densities and speeds of sound of the binary mixtures 1,3-dioxolane + 1-butanol, 1,3-dioxolane + 2-butanol, 1,4-dioxane + 1-butanol, and 1,4-dioxane + 2-butanol have been measured at 25 and 40°C. The excess molar volumes and excess isentropic compressibility coefficients were calculated from experimental data and fitted to a Redlich–Kister polynomial function. Results were analyzed in terms of molecular interactions and compared with literature data.     

Structure of hydroxycinnamic acid derivatives established by high-perfomance liquid chromatography with photodiode-array detection

Summary The present paper describes the development of a method for the differentiation of hydroxycinnamic acid derivatives by HPLC with photodiode-array detection. Furthermore spectral data of the compounds under investigation are given. Whereas p-coumaric acid derivatives are distinguishable from caffeic and ferulic acid derivatives by the positions of their spectrum maxima and their convexity interval value, it is not possible to distinguish between caffeic and ferulic acid derivatives because of overlapping spectrum maxima and convexity interval values.     

Thermochemistry of interactions of Na+ with benzo-15-crown-5 ether in acetonitrile-water mixtures at 298.15 K

Enthalpies of dissolution of benzo-15-crown-5 ether (B15C5) in mixtures of acetonitrile with water and in solutions of NaI and NaBPh₄ (I=0.05 mol dm^–3) in these mixtures were measured at 298.15 K. From the obtained results and appropriate literature data, the thermodynamic functions of B15C5/Na⁺ complex formation in acetonitrile-water mixtures were determined. The enthalpies of transfer of the complex B15C5/Na⁺ from pure acetonitrile to the examined mixtures were calculated and are discussed.     

Preparation and Characterization of Compositions Based on PbO-MgO-Nb2O5 Using the Sol-Gel Method

Lead Magnesium Niobate, Pb(Mg_1/3Nb_2/3)O₃ (PMN), is an important relaxor ferroelectric material. A significant problem exists, however, in the preparation of this material: it is very difficult to prepare pure phase, without the presence of a pyrochlore impurity phase which degrades the dielectric properties. Depending on the processing conditions, the amount of pyrochlore phase varies.Considering the ternary diagram PbO-MgO-Nb₂O₅, different compositions have been prepared by a simple sol-gel method at room temperature using Pb(CH₃COO)₂, Mg(CH₃COO)₂, Nb(OC₂H₅)₅ as precursors. After the heat treatment, the samples obtained were analyzed by XRD and EPMA with the purpose of studying the compositions formed.From the analysis of these results, it seems to be that the appearance of pyrochlore can be related to the reactivity of the MgO and/or the presence of other phases of the binary system PbO-Nb₂O₅. An excess of Pb and Mg is necessary for compositions to be formed near the PMN. The control of the amount of these two elements is very important because an excess of MgO would lead to rich compositions in Mg as a secondary phase.     

Interaction of 2-hydroxy-substituted Nile red fluorescent probe with organic nitrogen compounds

The fluorescent properties of 2-hydroxy Nile red dye (HONR) proved to be highly sensitive to the basicity of hydrogen bond acceptors. Fluorescence quantum yields and fluorescence decay profiles were measured as the function of the concentration of organic nitrogen compounds in solvents of various polarities. The detailed mechanism and the kinetics of the fluorescence quenching were revealed with the combined analysis of the steady-state and time-resolved spectroscopic data. The relative contribution of the competing reaction steps was found to be very sensitive to the basicity of the additive and to solvent polarity. The most profound change appeared in the unimolecular deactivation pathways of the excited hydrogen-bonded HONR, whereas the formation rate of this species varied to a lesser extent. The dissociation into excited HONR and ground-state base was able to compete with the energy dissipation only when 2,4,6-trimethylpyridine was used as hydrogen bond acceptor in toluene. The bimolecular quenching of the excited hydrogen-bonded complex played significant role in apolar solvents. Proton displacement along the hydrogen bond in the excited complex led to excited ion pairs in polar media.     

A Method for Clustering and Screening of Long-dimensional Chemical Data Based on Fingerprints and Similarity Measurements

A method for the treatment of long-dimensional chemical data arrays is presented in this work with the aim of maximising classification models. The method is based on the construction of fingerprints and the subsequent generation of a similarity matrix. The similarity calculation has been modified through a scaling process to take into account different significance shown by the variables. The method was applied to spectral measurements of wines and several aspects were studied, namely: threshold considered in the construction of fingerprints and patterns, weighting factor used for scaling, normalisation method, etc. The application of both Principal Components Analysis and Soft-Independent Modelling of Class Analogies to the similarity matrices gave better classifications of the information than those obtained using original data.