ESR studies on calcite encrustation on Fili neotectonic fault, Greece

Electron spin resonance (ESR) study was done on calcite encrustation on Fili neotectonic fault surface, Greece. Normally such calcite encrustations on fault surfaces are not observed. Significantly, the ESR study has detected the presence of nitrate NO₃²⁻ radical in this calcite encrustation, havingg _⊥=2.0063±0.0001 and hyperfine coupling constantA _⊥=3.44 mT, the second such detection of nitrate NO₃²⁻ radical following a sample from Scott Glacier, Antarctica. From isochronal thermal annealing measurement the NO₃²⁻ radical was found to be quite stable, only fully annealed at 475°C. This study also shows that the ESR, as a tool, can be suitably applied to date the age of formation of the calcite encrustation with SO₃⁻ as an ESR dating signal by additive γ-ray irradiation. A preliminary estimation indicates the age of formation of calcite precipitation at Fili fault, Greece to be about 5600 years.     

Effect of polarization on two-dimensional carrier distribution in nitride quantum wells

Wide band-gap group-III nitrides are important for the design of optical devices in the blue and blue–green region. Owing to their wurtzite structure, these materials have a strong inherent polarization field that affects carrier distribution, exciton stability and hence influences the optical properties of the devices. So far, carriers have been assumed to have a sheet-like character. In this paper a non sheet-like distribution function for these quasi two-dimensional carriers is proposed that incorporates the effect of the polarization field. Here GaN/InGaN/GaN and AlGaN/GaN/AlGaN quantum wells have been studied. The polarization field causes the electron and hole wave functions to separate out, thus causing decrease of emission strength and strong reduction of exciton binding energy. This treatment explains well the qualitative nature of carrier distribution in the well. The polarization field changes with GaN mole fraction present in the tertiary nitride layer. The effect of mole fraction on carrier distribution has also been studied. It is found that, inside the well, the hole distribution changes a little more with change in mole fraction than the electron distribution, but for all practical purposes the net change in the distribution pattern is negligible.     

An improved algorithm for detecting point of impact in anisotropic inhomogeneous plates

Conventional triangulation techniques fail to correctly predict the acoustic source location in anisotropic plates due to the direction dependent nature of the elastic wave speeds. To overcome this problem, Kundu et al. [1] proposed an alternative method for acoustic source prediction based on optimizing an objective function. They defined an objective function that uses the time of flight information of the acoustic waves to the passive transducers attached to the plate and the wave propagation direction (θ) from the source point to the receiving sensors. Some weaknesses of the original algorithm proposed in Ref. [1] were later overcome by developing a modified objective function [2]. A new objective function is introduced here to further simplify the optimization procedure and improve the computational efficiency. A new algorithm for source location is also introduced here to increase the source location accuracy. The performance of the objective function and source location algorithm were experimentally verified on a homogeneous anisotropic plate and a non-homogeneous anisotropic plate with a doubler patch. Results from these experiments indicate that the new objective function and source location algorithm have improved performance when compared with those discussed in Refs. [1] and [2].     

Acoustic source localization

In this article different techniques for localizing acoustic sources are described and the advantages/disadvantages of these techniques are discussed. Some source localization techniques are restricted to isotropic structures while other methods can be applied to anisotropic structures as well. Some techniques require precise knowledge of the direction dependent velocity profiles in the anisotropic body while other techniques do not require that knowledge. Some methods require accurate values of the time of arrival of the acoustic waves at the receivers while other techniques can function without that information. Published papers introducing various techniques emphasize the advantages of the introduced techniques while ignoring and often not mentioning the limitations and weaknesses of the new techniques. What is lacking in the literature is a comprehensive review and comparison of the available techniques; this article attempts to do that. After reviewing various techniques the paper concludes which source localization technique should be most effective for what type of structure and what the current research needs are.     

Influence of Tb doping on the luminescence characteristics of ZnO nanoparticles

Structural and optical properties of the Tb-doped ZnO nanoparticles with average diameter ≈4 nm have been systematically investigated. Our X-ray diffraction studies show a contraction of the ZnO lattice with the increase of the Tb mole-fraction x for x ≤ 0.02 and an expansion beyond x ≈ 0.02. The photoluminescence spectra are found to be comprised of a near band edge ultra violet luminescence (UVL) and a broad green luminescence (GL) band. Under the atmospheric condition, the intensity of the GL band is found to increase with the Tb mole-fraction over the entire doping range. On the other hand, under the vacuum condition, it has been observed that the GL intensity decreases with the increase of x up to x ≈ 0.02 but further increase of x leads to a gradual revival of the GL emission. Our study suggests that for x ≤ 0.02, GL results due to the physisorption of certain groups on the surface of the nanoparticles (GL-groups). It is also found that in this Tb mole-fraction regime, Tb incorporates mostly on the surface of the nanoparticles and affects the UVL to GL intensity ratio by influencing the attachment of the GL-groups. However, for x > 0.02, GL originates not only from the GL-groups but also from certain point defects, which are likely to be generated due to the incorporation of Tb in the core of the nanoparticles. A simple rate equation model is introduced to get a quantitative understanding about the variation of the density of the centers responsible for the GL emission as a function of x under the atmospheric and the vacuum conditions.     

Amphoteric trap modeling of multidielectric scaled SONOS nonvolatile memory structures

We have characterized multidielectric scaled SONOS nonvolatile memory structures with the quasi-static linear voltage ramp (LVR) technique and dynamic pulse measurements. We have formulated physically-based ERASE/WRITE and retention methods with deep level amphoteric traps which capture and emit carriers to the bands in the silicon nitride film. Amphoteric trap parameters are extracted by the LVR technique. ERASE/WRITE and retention amphoteric trap model simulations agree well with the experimental dynamic pulse measurements. Experimental scaled SONOS structures have been fabricated with tunnel oxide X_OT=20 Å, nitride X_N=30 Å and blocking oxide X_OB=55 Å and demonstrated a static flatband shift of 3.6 V with ±5 V programming voltages. These structures may be used as the nonvolatile memory element in high density VLSI circuits.     

Aeroelastic flutter of a disk rotating in an unbounded acoustic medium

The linear aeroelastic stability of an unbaffled flexible disk rotating in an unbounded fluid is investigated by modeling the disk-fluid system as a rotating Kirchhoff plate coupled to the irrotational motions of a compressible inviscid fluid. A perturbed eigenvalue formulation is used to compute systematically the coupled system eigenvalues. Both a semi-analytical and a numerical method are employed to solve the fluid boundary value problem. The semi-analytical approach involves a perturbation series solution of the dual integral equations arising from the fluid boundary value problem. The numerical approach is a boundary element method based on the Hadamard finite part. Unlike previous works, it is found that a disk with zero material damping destabilizes immediately beyond its lowest critical speed. Upon the inclusion of small disk material damping, the flutter speeds become supercritical and increase with decreasing fluid density. The competing effects of radiation damping into the surrounding fluid and disk material damping control the onset of flutter at supercritical speed. The results are expected to be relevant for the design of rotating disk systems in data storage, turbomachinery and manufacturing applications.